(b) A slide wire potentiometer uses a 200 cm kength of wire that equivakent to overall resistance of 100 Q with neglected internal resistance. This instrument is standardized with a reference voltage source of 1.019 V and the sliding contact is set to 101.9 cm during the calibration process. Cakulate the working current and the measurement range of the potentiometer.

(b) A slide wire potentiometer uses a 200 cm kength of wire that equivakent to overall resistance of 100 Q with neglected internal resistance. This instrument is standardized with a reference voltage source of 1.019 V and the sliding contact is set to 101.9 cm during the calibration process. Cakulate the working current and the measurement range of the potentiometer.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

With the given circuit below, if the input voltage is 10 volts peak-to-peak and the diode is germanium, how much is the output voltage in volts on the negative half cycle? (put polarity (+ or -) and values only) Vpcin) V out RL
AP-N-P-N diode is a Select the correct response controlled rectifier. current controllable negative resistance device. negative resistance device. voltage controllable device.
queckly just select
The varactor is a diode used as a voltage controlled.. Please choose one a. capacitor b. resistance C. light sensor D. current source
Choose correct option. To adjust the maximum voltage in a limiter circuit: a capacitor should be added in series to the diode. a voltage source can be added in series to the diode. a current source should be added in series to the diode.
2. A simple half wave rectifier consists of a diode and load. If the internal resistance of the diode is 1 ohm and the load resistance is 5 ohms. What will be the DC load current if the supply voltage is 12 Volts, draw the schematic diagram and also draw the waveform of the rectifier. 3. Determine the output voltage in the figure below Si Ge Vo R₁ 2kQ 20V R2 2kQ
Q3: bridge rectifier circuit shown in Figure (1), with a forward diode resistance Rd=12, and Rd=0 for a reverse bias. The input voltage of the circuit is 240V and 482 load resistance. Determine: The de load current, the power input efficiency and the PIV rating is required for the diodes. D4 D1 Rd=10 RL=480 Vs Vrms D3 D2 Figure 1
Assuming a Buck converter is operating in continuous conduction mode with a duty ratio & and an output current lo, which of the following expressions correctly describes the average diode current? 07₁=1 (1-8) O 01₁=1₁ OÏDE =I I ° ;,-' == D O 06-1/ = D 1-8
For full wave rectifier circuits a-An AC input and at least four diodes are required b-One AC input, two diodes and output load is sufficient. c-ıt can be installed with a DC source and two diodes. d-An AC, a DC source and two diodes are required.
Drow the Vin and the output Voltage of the half wave rectifier () and draw the circuit it?Vin=0.5 vp. pF=1 KHz
Q3: bridge rectifier circuit shown in Figure (1), with a forward diode resistance Rd=12, and Rd=o for a reverse bias. The input voltage of the circuit is 240V and 482 load resistance. Determine: The de load current, the power input efficiency and the PIV rating is required for the diodes. D4 D1 Rd=10 RL=480 Vs Vrms Vo D3 D2 Figure 1
8