b) A shaft whose nominal diameter is 30mm has limits of 30.013mm and 29.992mm. It is to make a transition fit with a bore. If the maximum interference between the mating components is to be 0.013mm and maximum clearance is to be 0.039mm. calculate: (i) The low limits of the hole (ii) The high limits of the hole (ii) The tolerance of the hole (iv) The high limits of the shaft (v) The tolerance of the shaft

b) A shaft whose nominal diameter is 30mm has limits of 30.013mm and 29.992mm. It is to make a transition fit with a bore. If the maximum interference between the mating components is to be 0.013mm and maximum clearance is to be 0.039mm. calculate: (i) The low limits of the hole (ii) The high limits of the hole (ii) The tolerance of the hole (iv) The high limits of the shaft (v) The tolerance of the shaft

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The Fit of the two letter tolerances (P7& f7) When the basic size(160mm) * ?is Internal Fit. Transfer Fit Clearance Fit O * The Pitch diameter circle for the gear depends on Shaft diameter. Hub diameter Module and number of teeth the maximum internal fit of the two letter tolerances (G7& p6) When the * ?basic size (180 mm) is -56 -54 -53
Complete the hole specification including a position tolerance of .018" diameter at MMC relative to primary datum feature A, secondary datum feature B, and tertiary datum feature C.
1-Show how the roughness is indicated for a Surface to be coated, obtained by any production method with N6 showing max. and min roughness. 3- gearing is suitable for two shafts at 90°. : Draw five turns of a compression spring of wire diameter 6mm, pitch 12 num and outside diameter of 38mm.
3. If the diameter with tolerance of the hole is 2.6 ±0.1 mm, which of the following is the safe diameter and tolerance of the shaft to ensure a clearance fit (no interference and not tight) when assembled? 2.6-0.05 mm 2.5-0.1 rum 2.6 ± 0.1 mm b. 2.5±0.1 mm a. C. d.
Matching hole and shaft, the size of the hole isp40+0.15 +0.05mm, the size of the shaft isq400. -0.1 Omm , and their gap is (). A. 0.25 B. 0.05 C. 0.15
Machine shaft alignment theory and A. Theory of shaft alignment B. Evaluation of shaft alignment readings C. Equipments needed for shaft alignment D. Procedure of how shaft alignment is done. evaluation
In an interchangeable assembly, shafts of size -0.040 25.000-0.0100 mm mate with holes of size +0.020 25.000-0.000 mm. The maximum possible clearance in the assembly will be (a) 10 microns (b) 20 microns (c) 30 microns (d) 60microns
Fill in the table regarding the hole and shaft below. Assume ANSI tolerancing.
What is the concept of accuracy? Explain. How do you measure accuracy? How do you measure thread pitch diameter? Why is it important? Given the following information and (TPI: thread per inch -13), determine the pitch diameter.
can you please find the solution question no:26
Is this a clearance or interference fit?