(B) A liquid subcooler as shown in the Figure receives To high-stage liquid ammonia at 30°C and subcools 0.6 kg/s to 5°C. compressor Saturated vapor leaves the subcooler for the high- stage compressor at -1°C. Calculate the flow rate of ammonia that evaporates to cool the liquid. From condenser To expansion valve of low-temperature evaporator

(B) A liquid subcooler as shown in the Figure receives To high-stage liquid ammonia at 30°C and subcools 0.6 kg/s to 5°C. compressor Saturated vapor leaves the subcooler for the high- stage compressor at -1°C. Calculate the flow rate of ammonia that evaporates to cool the liquid. From condenser To expansion valve of low-temperature evaporator

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

16. Consider the figure below. An electric stove having a rating of 3kW is use to boil a 6Li of tap water (Initially at 20°C and whose density at this temperature is 1020kg/m). If useful energy is around 62% of the total energy supplied by the stove. Determine how long would it take to vaporized all the water in the pan. determine the total kW-hr used by the electric stove in the given condition.
In the evaporator of an air conditioning system, air flows over finned tubes through with the refrigerant R134a flows. air out refrigerant in refrigerant out air in The mass flow rate of the air is 0.75 kg/s and the air enters at 40°C and pressure 1.04 bar. The air leaves the evaporator at 25°C and 1.01 bar. The refrigerant enters the evaporator with a quality of 0.2 and a temperature of 12°C. The refrigerant exits as saturated vapor. Obtain the properties of air and R134a using the fluids "Air" and "R134a" in EES. What is the volumetric flow rate of the air entering the heat exchanger (m^3/s)? Determine the rate of heat transfer from the air to the refrigerant (W). Determine the mass flow rate of the refrigerant (kg/s).
Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam is extracted for feed water heating at 0.6 MPa. The turbine exhaust is 60 degree C. the required values of some state point properties are tabulated below. 10. Calculate the net work of the cycle.
A single effect evaporator was used to concentrate 8000 kg / hr of tomato juice from 5% total solids to 30% total solids. The juice enters the Evaporator at 20 ° C. The evaporator is operated on Steam (80% quality) at 143.27 kPa. The vacuum in the evaporator allows the juice to boil at 75 ° C. The specific heat of the dilute material is 4.1 kJ / (kg ° C) and the concentrate product is 3.1 kJ / (kg ° C). Count it (a) Steam demand rate = Answerkg / hour. b. Steam economy when condensate temperature is released at 75 ° C. = Answer(kg of water evaporated / kg of steam)
Need asap show complete solution
A four stage single acting air compressor running in an atmospheric at 87 KPa and 15 degrees Celsius has a free air delivery of 2,83 m³/min. The section pressure and temperature are 80 KPa and 32 degrees Celsius respectively, the delivery pressure is to be 7 MPa. The temperature at the start of compression in each stage is 32 degrees Celsius, take n=1.3 for all stages. Calculate : 1. The intermidiate pressure ratio in 3 decimal place 2.The intermidiate pressure at first, second and third stage in KPa 3. The mass flow rate in kg/min 4.The power input in KW
In the condenser of the power plant, Ammonia is isobarically condensed to saturated liquid state with 615.2kPa and x = 0.9, the mass flow rate is 4 t/h. The heat rejected from the condensing ammonia is added to heat water, which is heated from 277K to 281K. What is the mass flow rate of water in t/h. Also sketch the T-s and P-v diagrams.