b) 2 Using the concept of control flooding, with the above network, find the total number of packets that will be transmitted in the network if a LSA packet originates at Node G with a network hop limit (TTL) of three and a SeqNo of 11 (which is a new SeqNo)?

b) 2 Using the concept of control flooding, with the above network, find the total number of packets that will be transmitted in the network if a LSA packet originates at Node G with a network hop limit (TTL) of three and a SeqNo of 11 (which is a new SeqNo)?

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Consider the following network. A. Display router forwarding table A. such that all traffic for H3 is transmittedthrough interface 3. b. May you enter a transmission table on router A, in that all traffic from HI to host H3 is transmitted via interface 3, while all traffic from 112 to host H3 is transmitted via interface 42? (Hint: This issue is a trick.)
Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive 100 Mbps links of 2000 km length each.Assume that the signal propagation speed on both links is 2 x 108 m/s.Furthermore, assume that the maximum length of a packet is 1480 bytes and that Computer A fills each packet to the max, if possible. How long (in seconds) does it take Computer A to send out one packet of maximum length on the first link?
Computer A is sending a 100 kByte long file to Computer B via packet-switching over two consecutive 10 Mbps links of 1000 km length each.Assume that the signal propagation speed on both links is 2.5 x 108 m/s.Furthermore, assume that the maximum length of a packet is 1500 bytes and that Computer A fills each packet to the max, if possible. How "long" (in meters) is one bit on link 1?
1) Consider a packet of length 1200 bytes begins at end system 'A' and travels over three links to reach the destination end system 'B'. These three links are connected by two packet switches. Assuming no queuing delays, the propagation speed on all three links is 2.5*10 m/s, the transmission rates of all three links are 2 Mbps and the packet switch processing delay is 3 msec. Further, the length of the first link is 4,000 km, the length of the second link is 2,000 km, and the length of the last link is 3,000 km respectively. Specify the formula for total delay in this transmission and also calculate the end-to-end delay involved in this packet transmission?
hdet b) Consider sending a packet contains 1100 bits from Host A to Host B in a store and forward nerwork. There are 10 links (and 9 routers) between A and B, and the links are congested (there Is a queuing delays). Assume propagation delay over the links are negligible. As a packet travels along the route, it encounters an average of 5 packets already waiting in the queue to be transmitted when it arrives at each router, How long does it take for the packet to get to the receiver if the nodes transmit on a "first come first served" basis (in ms)?
as a possible congestion control mechanism in a subnet using virtual circuits internally, a router could refrain from acknowledging a received packet until (1) it knows its last transmission along the virtual circuit was received successfully and (2) it has a free buffer. for simplicity, assume that the routers use a stop-and-wait protocol and that each virtual circuit has one buffer dedicated to it for each direction of traffic. if it takes 7 sec to transmit a packet (data or acknowledgement) and there are n routers on the path, what is the rate at which packets are delivered to the destination host? assume that transmission errors are rare and that the host-router connection is infinitely fast.
Assume there are two hosts X and Y that are connected with the help of a router T having: X-T link of infinite bandwidth. The T-Y link can send one packet per second. T's queue is infinite. You have to measure the load as the number of packets per second sent from X to T also sketch a curve for throughput and the delay, each as a function of load.
2. Consider a slotted TDM hierarchical network in which there are 8 computers sharing a 10 Mbps channel to a router R1, sending packets to R1 which must all be forwarded by R1 over an outgoing link (called the MAN link), as shown in Figure 1. Computers A-H always have packets waiting to be sent, so no timeslot on the shared LAN is idle. Ignore the propagation delay on the LAN. The MAN link outgoing from R1 is a 100 Mbps link. The network layer protocol in use has a PDU with exactly 40 bytes of header and exactly 200 bytes of payload (SDU). The DLC layer protocol in use on the LAN has a PDU with exactly 40 bytes of header and 20 bytes of trailer. The DLC layer protocol in use on the outgoing link from R1 has a PDU with 40 bytes of header and no trailer. The physical layer does not impose any bit overhead in either channel. Use 1 Mbps = 1000000 bps. B D E F G H R1 R2 Figure 1 (a) What is the transmission delay of a bit for Computer A? (b) What is the transmission delay of a DLC PDU for…
COMPUTER NETWORKS QUESTION : In TCP, hosts need to set the retransmission timeout (RTO) dynamically to adapt for the routing performance and optimize the bandwidth utilization. Assume that one sending hosts found from previous packet/acknowledgement pairs that the RTT between it and the receiver is 45 mS. What will be the RTO of that sending host after receiving a new packet/Ack pair witha new RTT sample = 100 mS. (assume that ?=0.875)