AW18 × 40 standard steel shape is used to support the loads shown on the beam. Assume P = 20 kips, w = 5.8 kips/ft, LAB = 4.0 ft, LBc 4.0 ft, and LcD = 13.0 ft. Determine the magnitude of the maximum bending stress in the beam.

Q: Q.No.3: Determine the ACI design moment capacity =60000 psi. Also draw the strain diagram? 4 #9 bars…

A:

Q: A W18 x 40 standard steel shape is used to support the loads shown on the beam. Assume P = 29 kips,…

A: Answer  We know that maximum bending stress occur in a beam at extreme fibres and it can be…

Q: A steel rod (3/4) in. diameter and 25 ft long is subjected to an axial tensile load of 15,000 lb.…

A: d = Diameter of rod = 3/4 in = 0.75 inL = Length of rod = 25 ft = 2512 = 300 inP = Axial load =…

Q: n, solve the absolute maximum shear stress.

A: CALCULATIONS OF ABSOLUTE MAXIMUM SHEAR STRESS###

Q: Calculate the maximum tensile and compressive stresses in the section of BC of the beam. A 0.5 in…

A: Determine the maximum tensile and compressive stress in the section BC.

Q: A W18 × 40 standard steel shape is used to support the loads shown on the beam.  Assume P = 25 kips,…

A:

Q: A WT305 x 41 standard steel shape is used to support the loads shown. Assume w = 52 kN/m, LAB = 1.7…

A:

Q: For the given reinforced T-section shown in Figure 2 with fc’= 30 MPa, fy = 400 MPa, calculate the…

A: According to the specifications, first we will calculate the compression and tension type of force.…

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.