AutoCAD........OBLIQUE VIEWSketch the oblique view of the given isometric components using AutoCAD20203020this is related to mechanical dont dare to send to civil if you dont knowauto cad then skip , civil dont have this subject many times i have sent tomechanical, never send to civil , i will downvote

Answered: Image /qna-images/answer/dd6c5dbb-994c-4064-a975-b32908d2744e.jpg

Answered: AutoCAD....... ........OBLIQUE VIEW…

Engineering

Mechanical Engineering

AutoCAD....... ........OBLIQUE VIEW Sketch the oblique view of the given isometric components using AutoCAD

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Draw the isometric and oblique views, as required: Ex. 1: Isometric View Ex. 2: Oblique View
☆Draw figures 1 and 2 using AutoCAD and store the drawings in red at the command of Block الشكل 1 الشكل 2 ☆Draw the following figure with dimensions: 20
make a three-view drawing, complete with dimensions, of the part. Show the dimensions with the view that best shows the shape of the part or feature. Note :use creo PARAMETRIC 3.0
Isometric View
Answer the first three subquestions only. Show clear working with detailed explanations where necessary.
Write two or three Sentences about each of the following: Standard GaugeLimit GaugeIndicating GaugeCombination GaugeWorkshop GaugeInspection GaugeMaster Gauge (Reference Gauge)Dimension Measuring GaugeInside Dimension Measuring GaugePlug GaugePin Gauge Outside Dimension Measuring GaugeSnap GaugeRing GaugeBoth sides Dimension Measuring GaugeCalliper GaugeGeometric Measuring GaugeGauges for concentricityGauge of TaperGauge of ProfileSingle limit and Double limitSingle-ended and Double-endedFixed and Fastened
sketch the orthographic view of the following isometric component Note : in catia v5 software only no hand drawings Ihrough hole. 34 Dia 54 14 54 Through slot 44 20 Through slut Bearing 25
The following figure shows an isometric view of an object.Draw its Front view,Top view,and Side view in FIRST Angle of projection.
7. is used for measuring the wind direction. changes. [True/false]
A theodolite is an instrument that measures horizontal and vertical angular orientations of a line of sight. The line of sight may be established optically, or by laser, and many forms of theodolite are used in surveying, construction, astronomy, and manufacturing. A simple optical theodolite is shown. After the instrument is aligned so that its base is in a horizontal plane and a desired reference direction is selected (such as perhaps north in the case of a surveying instrument), the telescopic sight is used to establish a line of sight, and then horizontal and vertical angles Thetah and Thetav are measured. If Thetah = 30° and and Thetav = 60°, determine the following: 7.1 The coordinate direction angle Alpha of the line of sight is Blank 1°. 7.2 The coordinate direction angle Beta of the line of sight is Blank 2°. 7.3 The coordinate direction angle Gamma of the line of sight is Blank 3°.
Figure 3.14 10 P15 25 45 60 35 /10, Sketch the views necessary views from the front, above and left or right side. Figure 3.14 shows an object .use creo parametric software . mention the dimension and views 15
Q.1 Draw orthographic Front and top view of object given below 50 25 25 40 RIS 60 20 80 20 0.