ater must flow over a distance of 2 800 m from a large catchment dam to a turbine. I The water level in the catchment dam is 1 620 m above sea level and the turbine is situated 1 275 m above sea level. The efficiency of transmission is 65% and 300 kW must be transmitted from the pipeline to the turbine. If f = 0.007, determine the number of 200 mm diameter pipelines, which must be laid in parallel, needed to transmit the required power.

Q: With reference to the figure below a power station uses a condensor in order to condensate steam for…

A:

Q: Oil is pumped from a very large tank (z1 = 150 m) to another tank (z2 = 200 m), located higher and…

A:

Q: A pump is used to transfer crude oil from a non-pressurized oil tanker to a storage tank at a…

A: As all the units of the parameters in the given problem are irregular, convert all the units into SI…

Q: What power can be delivered by the turbine if its efficiency is 100%? The water flow rate is 0.01…

A: Q=0.01m3/shL=13.0 mρ=1000kg/m3μ=0.001kg/m.s

Q: A fertilizer delivery system is shown in the figure. The hose is made of a material whose…

A: Solution: Given Data: CR=0.12d=25 mmD=30 mmR=1.3 mV=5.4 m/sη=75%SG=1.1h=10 m - 1.2 m = 8.8 m

Q: Reservoir X (Elevation 369m) supplies water to reservoir Y (Elevation 195m) thru a 400 mm pipe. A…

A:

Q: A submersible pump is to be selected for the installation on a newly drilled deep well. The static…

A: The total dynamic head of the water system determines the various head losses that the pump must…

Q: Water with a specific heat of 1 BTU/lbm F is pumped using a 1-hp jet pump from a well that is 20 ft…

A: Given       Specific heat, C = 1 BTU / lbm           Flow rate, m = 5 gal/min…

Q: There exists a sharp entrance (Ken= 0.5) from the tank to the pipeline, shown in the figure. Also, a…

A:

Q: 3. In the following system, the flow rate of Q= 400 lt / s is transmitted from the A chamber to the…

A:

Q: * A hydraulic lift raises a total load of 8 tonnes through a height of 12 m- once in every two…

A: given; total load(m)=8 tonnes                        =8000kgfor every 2 minute.total load rate…

Q: A hydroelectric generation facility has a gross head of 120 m and a consistent yearlong water flow…

A:

Q: he water flows through a pipeline 1.2m diameter at a velocity of 3m/s which bifurcates at a…

A: Given:d1=1.2 mv1=3 m/sd2=0.08 mQ2=13Q1v3=2.4 m/s

Q: Water is retained in a small mountain lake whose surface is 280 ft above the inlet to the turbines…

A: Bernoulli's theorem is used in fluid dynamics and gives the relationship between the pressure,…

Q: Determine the pump work of the oil piping system. The oil has kinematic viscosity of 0.0001 m²/s and…

A: Given:Kinematic viscosity of the oil, ν=0.0001 m2/sSpecific gravity of the oil, SGoil=0.79Pipe…

Q: A  25Hp  suction pump operating at   56.30%  efficiency draws water from a suction line whose…

A: The power of the pump is P=25 Hp The efficiency of the pump is η=56.3%. The diameter of the suction…

Q: 2.attention to the piping system shown in the figure below. Pipes 1, 2, and 3 are installed in…

A:

Q: ater must flow over a distance of 2 800 m from a large catchment dam to a turbine e water level in…

A: Solution:

Q: Calculate the inside diameter of the pipes at the inlet and outlet a hydraulic pump whose volume…

A: Given : flow rate Q = 40 Lit/min = 40 x 10-3 m³ / 60 sec = 6.67 x 10-4 m³/s entry velocity V₁ =…

Q: QUESTION 2 A pipeline of 50 mm diameter and 4.5 km length connects two reservoirs whose constant…

A: by problem,QB=QCQA=QB+QCQB=QC=QA/2f=0.0075DA=DB=50mmDC=?For A & B reservoir,ZA-ZB=fCADA X VA22g…

Q: Find the maximum power that can be transmitted by a power station through a hydraulic pipe of 3…

A: GIVEN DATA- D=200mm f=0.01 P=1500KPa L=3km WE HAVE TO FIND MAXIMUM POWER TRANSMITTED

Q: Water must flow over a distance of 2 800 m from a large catchment dam to a turbine. The water level…

A: In parallel combination of pipes, their frictional head losses are the same but the power…

Q: Water is to be moved from one large reservoir to another at a higher elevation as indicated in the…

A: GivenQ=6.2 ft3/shL=61V22   ft2/s2d=8inz=56ft

Q: In the following figure, a machine is installed in the water drainage system. Knowing that the…

A:

Q: flow rate of water in the pipe which is con ed to tank B is the flow rate in the other two pipes and…

A:

Q: A water tank with a capacity of 1500 L is desired to be completely filled in about 1.5 hours. The…

A: To find: The power input (in kW) to the pump. Given: The capacity of the tank is V=1500 lt. Tine…

Q: 2. For a piping system as shown in the figure, determine the distribution of the water flow Qi and…

A:

Q: The three water-filled tanks shown in the figure below are connected by pipes as indicated. If mi…

A:

Q: 6.5 BELLOWS 8100mm The horizontal elbow is joined by bellows to the rest of the piping system and it…

A: NOTE: According to Bartleyby's policy we shall answer only one question at a time so kindly repost…

Q: 3. Petrol is drained from a tank X to tank Y via pipeline A-B (see figure Q3). A pump is then used…

A:

Q: Calculate the power consumption and the steady discharge of water between the reservoirs in the…

A: Write the given data. hst=15 mD=0.300 mL=500 mλ=0.004η=0.38

Q: Each of the two circular pipes carries water at 65 °C flows at a Reynolds Number of 3.8× 10^4.…

A:

Q: Two pipes in a series have a flow rate of 50 L/s. The pipe upstream is 300 mm and reduced downstream…

A: Given Data Q=50 L/s D1=300 mm D2=150 mm

Q: Determine the pump work of the oil piping system. The oil has kinematic viscosity of 0.0001 m²/s and…

A: Given:Kinematic viscosity of the oil, ν=0.0001 m2/sSpecific gravity of the oil, SGoil=0.79Pipe…

Q: What power must be supplied by the pump to the flow if water is pumped through the 200-mm steel pipe…

A:

Q: Figure 5 shows a pump connected to a large tank of water. Water flows out of the tank through the…

A: Given:

Q: Water flows initially from tank A to B through a single pipeline which is 150 mm in diameter and 150…

A: Length of first pipe, L1=150mDiameter of first pipe, d1=150mm=0.150mFlow rate need to increased by =…

Q: Question 1 Water is circulated from a large tank, through a filter, and back to the tank as shown in…

A:

Q: The reservoir tank shown contains fresh water air pressurized to 200 kPa. There is a loss of 3.3…

A:

Q: Water is pumped from the upper reservoir to the lower reservoir through the piping system shown.…

A: Mass flow rate of water, m˙=60 kg/sh1=10 mh2=3 mL1=50 mL2=300 mL3=2 mD1=0.2 mD2=0.5 mD3=0.03…