At t= 0, charge density pv0 was introduced into the interior of a material with relative permittivity , 3. If at t₁=0.1 us the charge density has dissipated down to 0.001* Pvor what is the conductivity of the material?

Q: What is the voltage drop across RC, VC, in volts?  (Enter the number, not the units.)

A: Given circuit is -

Q: explain insulation coordination and write method of insulation coordination

A: We have to explain insulation coordination and write method of insulation coordination.

Q: With neat sketch explain the types and operation of oil circuit breaker

A: Types of the circuit breaker, 1. Low oil circuit breaker 2. Bulk oil circuit breaker Plain break…

Q: What is the meaning of the acronym, XLPE? A. EXTRA LOW POLYESTER EQUIPMENT B. CROSS-LINED POLYETHYL…

A: In this we will write about XLPE....

Q: In an electronic circuit, a. current remains the same through all the series components. b. voltage…

A: Note that,  In an electronic circuit, current remains same jn all series components and voltage…

Q: define the fake resistance

A: Fake resistance has property of some electrical circuit s and devices in which an increase in…

Q: GFCI's are designed to trip when they sense a current imbalance of __________ amperes or more.…

A: Ground fault circuit interrupter is a type of protection device that is used to protect the people…

Q: b 2000 CRO (14 1.00-1 CR₂) Jov w ML WW 10.0-2 CRE TA 0.00-2 CR4)

A:

Q: Which type of levels are the most commonly employed today. O a. Dumpy levels O b. Automatic levels…

A: To do:We have to select the right option from given four different options for type of levels that…

Q: Grateful a little help with this homework thanks.

A:

Q: Using a DMM (Digital Multi Meter), a fully charged 12 volt battery should indicate how much voltage…

A: voltage of a one standard cell is 2.1 V

Q: What is HT supply?

A: What is HT supply?

Q: what is vehicle servicing

A: A motor vehicle service or tune-up is a series of maintenance procedures carried out at a set time…

Q: With neat diagram explain the construction and working principle of strain gauge

A:

Q: Measures to be taken in protecting the electronic rotection of information centers

A:

Q: Assume that the collector current changes from 2.5mA to a new level of 3mA. Determine the magnitude…

A: Given thatcollector current change from 2.5mA to 3mAfind magnitude of IC change %

Q: a) Draw the block diagram of a measurement system.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Explain the elements of measurement system in detail

A: Measurement system : measurement system is combination of various component which measures the…

Q: Accuracy of an instrument or device is the difference between the indicated value and actual value.…

A:

Q: Rewrite five (5) proper steps in determining the sizing of battery that to be used  either in…

A: We need to write steps in determining the sizing of battery that to be used either in…

Q: Identify and Explain with neat sketch of the 1. Pin Type Insulator 2. Suspension Type 3. Strain…

A: Pin type insulator: This type of the insulators the most early grown overhead insulator, yet are…

Q: 2. Explain over modulation.

A:

Q: 1. Define two (2) types of Power Electronics application with diagram and gives one for each types.…

A:

Q: 3List out common electrical hazards and give risk level for each of them

A: 1. discharge of current through insulating materials: If the appliance is not connected through an…

Q: Define noise in communication systems and mention the different types Note: Please do not…

A: Noise is an unwanted signal which interferes with the original message signal and corrupts the…

Q: HERE IS IT

A: Physical address can be expressed by the following formula:Physical Address = (Segment Address) x 10…

Q: Discuss the following K. CCTV L. Type of CCTV recorder O. Cable used in CCTV system

A: Digital security is one of the major factor nowadays. It can be done by various electronic devices…

Q: Identify and Explain with neat sketch of the 1. Pin Type Insulator

A: As per our policy, i have attempted one question. Pin type insulator - It is a device which is used…

Q: The ___is used to calibrate the multitester when you want to measure the resistance of an object

A: The resistance of an object(conductor or conducting material) is measured in order to maintain…

Q: Please answer in typing format

A: a) EarthingWhat is Earthing?Earthing, also known as grounding, is the process of connecting the…

Q: Discuss the difference between the off-line and online UPS

A:

Q: 4. What is PPE?

A: here we have to find the what is PPE.

Q: if you have (10) 10 OHM resistors and (5) OMR resistors in a series circuit what would the total…

A: Resistances are given as,

Q: At pinch-off voltage, the drain current in a FET is ___. Choose the correct answer: a.zero…

A: At pinch-off voltage, the drain current in a FET is ___.   Choose the correct answer: a.zero…

Q: Notes and labels are usually

A: Notes and labels are usually ____.?

Q: Q1/A/ In your city: one station is work between (15-30) GHz, Design filter that pass up to 300MHZ.…

A: Filter circuits are used to filter out the ripples present in the signal. Any AC or Dc signal has…

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.