At an average temperature of 100°C, hot air flows through a 2.5 m long tube with an inside diameter of 50 mm. The temperature of the tube is 20°C along its entire length. Convective film coefficient is 20.1 W⁄m2 − K. Determine the convective heat transfer from the air to the tube.

Q: Air at 1 atm and 40°C is flowing over the top surface of a 0.2 m x 0.5 m-thin metal foil. The air…

A: Given data: Air at 1 atm pressure and temperature,, is flowing over a thin metal foil of surface…

Q: The operations management of the industrial plant where you work asks you to determine the length of…

A:

Q: A long aluminum wire of diameter 3 mm is extruded at a temperature of 280°C. The wire is subjected…

A: To find:The rate of heat transfer from the wire to the air per meter length when it is first exposed…

Q: a) What is the required tube length for these conditions? b) To design a water heating system,…

A: first we calculate reynolds numebr  then evaluate nusselt number  then figure out h and the use…

Q: Water flows in a 3.5-cm-diameter pipe so that the Reynolds number based on diameter is 2000 (laminar…

A:

Q: Saturated liquid ammonia is entering a 50 cm diameter 10-m long pipe at a steady 0.1 kg/s mass flow…

A:

Q: Water (5.0 L/min) is flowing in a tube "D = 3 cm, L= 5 m" and is to be heated from 15°C to 64.0°C by…

A:

Q: An ASTM B75 copper tube sheathes a heating element that is used to boil water at 1254 kPa. The…

A:

Q: ir at 3*10-4 kg/s and 27°C enters a rectangular duct that is 1 m long and 4 mm x 16 mm on the sides.…

A: Given: m˙ = 3×10-4 kg/s Tm,i=27oC=300K L =1 m W = 16mm=0.016m h = 4mm=0.004m qs˙= 600 W/m2

Q: Air at 10 °C enter an 18 m de long rectangular duct of cross section 0.15 m X 0.20 m at a velocity…

A:

Q: A tube with a square cross-section 2 mm in side and 1.5 m in length imposes a constant heat flux of…

A:

Q: Water flows at 1 kg/s in a 10 mm diameter tube and is to be heated from 25 to 75 °C. The tube…

A: INTRODUCTION : When a flowing fluid travels through a heat exchanger, our focus is on either cooling…

Q: Consider a 50-mm-diameter and 25-m-long smooth tube that is maintained at a constant surface…

A: Write the expression of the average temperature.Here  indicates inlet temperature and  indicates…

Q: Air at 30 oC flowing over a flat plate 0.5 m long and 0.6 m wide, is to be maintained at 70 oC .…

A: This question is solved with the help of the convection heat transfer coefficient equation. As shown…

Q: Refrigerant 134a flows in a 5-m long square duct that is located in a warehouse. One side of the…

A:

Q: Air at 206.8 kPa and at an average temperature of 200 oC is being heated as is flows through a tube…

A: Given data  Pressure = 206.8 kpa Average temperature= 200°C Inside diameter of pipe = 40mm Velocity…

Q: Water as much as 0.002kg/s at a temperature of 18 °C Flows into a tube with a flow that has been…

A:

Q: Calculate the heat losses per unit length in a horizontal tube with an outside diameter of 15 cm, if…

A: Outside diameter of tube, d=15 cm=0.15 mSurface temperature of tube, Ts=400 KSurrounding air…

Q: solve show all solutions and assumptions

A: Part aTo resolve this trouble, we want to use principles of warmth switch and fluid mechanics,…

Q: Calculate the heat flow every 1.7 hours through the outside fluid film from a 16.2 m² flat vertical…

A:

Q: The heat is propagating through a stainless steel wall with thermal diffusivity of 6x10^(-6)m2/s. If…

A:

Q: The rigid bar ABC is supported by pin at A and aluminium wire BD, is horizontal betore the Load P is…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Water at a temperature of 10°C flows at a velocity of 3 m/s across a plate maintained at a uniform…

A: Solution is given below.

Q: In convection heat transfer, what happens to the heat transfer coefficient if the viscosity of the…

A: Heat transfer coefficient is related to Heat transfer rate. Higher the Heat transfer coefficient,…

Q: Air enters a 7-cm-diameter and 5-m-long tube at 65°C and leaves at 15°C. The tube is observed to be…

A: Given:Tube diameter, d=7 cm=0.07 mTube length, L=5 mAir inlet temperature, Ti=65oCAir exit…

Q: 2. For a boiling process such as shown in Figure below, the ambient temperature Tin Newton's law of…

A: Given:Heat flux, q=20*105 W/m2Convective heat transfer coefficient of water, hw=20*103…

Q: Engine oil is cooled from 110°C to 86°C by running at a mass flow rate of 3.2 kg/s inside a tube…

A:

Q: Determine the convection heat transfer resistance on the inside of the pipe per unit length, in…

A: R, convection i=1/hi*Ai       =(1/450*π*0.150*1).  L=1(unit length)     =4.716*10^-3    =4.716mK/W

Q: The airflow at 1 atm has a free stream velocity and temperature of 5 cm/s and 25°C, respectively.…

A: Heat transfer coefficient:The quantity of heat energy that is moved from one surface to another as…

Q: Engine oil enters the 5 mm diameter pipe at 120°C. The pipe surface temperature is kept at 40°C and…

A:

Q: The temperature of a hot gas stream flowing in a duct (90cm) length and (30cm) diameter is to be…

A:

Q: Consider a 26-cm x 31-cm printed circuit board (PCB) that has electronic components on one side. The…

A: Given:- Tf=32.5°C Ts=45°C T∞=20°C Q=8W To find:- Average hot surface temperature

Q: A pure copper cube 3 cm on each side is placed in a 15°C stream of water.If the initial temperature…

A:

Q: Hot fluid "C= 2562 J/kg.k , Pr=51.3, µ = 5.22E-3 Pa.s, k = 0.260 W/m.K" flows at 1.3 kg/min inside a…

A: Cp =2562 J/kg.K Pr = 51.3 Dynamic viscosity, u = 5.22*10-3 Pa.s k = 0.260 W/m.K Hot fluid mass flow…

Q: Hot fluid "C= 2562 J/kg.k , Pr=51.3, µ = 5.22E-3 Pa.s, k= 0.260 W/m.K" flows at 1.3 kg/min inside a…

A:

Q: Question 3 Engine oil is cooled from 110°C to 86°C by running at a mass flow rate of 3.2 kg/s inside…

A:

Q: Hot fluid "C= 2562 J/kg.k, Pr=51.3, µu = 5.22E-3 Pa.s, k = 0.260 W/m.K" flows at 1.3 kg/min inside a…

A: Given:Cp=2562 J/KgKPr=51.3μ=5.22E-3 Pa.sk=0.260 W/mKm=1.3 Kg/minTs=23°CTo=35°C∆T=45°CTi=45+35=80°C

Q: Air at 20°C enters a heated circular tube with a diameter of 30 mm and a length of 3 m. The mass…

A: for answers apply heat balance.for solution refer below images.

Q: Water at 20°C flows through smooth tubes of 25 mm dia at a mean velocity of 2.2 m/s. The surface of…

A: Write the properties of water at 20 oC. μ=2.47 kg/hr·mk=0.534 kcal/hr·m°Ccp=1 kcal/kg°CPr=4.6255

Q: The local atmospheric pressure in Denver, Colorado (elevation 1610 m), is 83.4 kPa Air at this…

A: Step 1: Step 2: Step 3: Step 4:

Q: For seaworthiness trial of a new ocean-going vessel design, the total convective heat transfer rate…

A:

Q: How is the Reynolds number related to Darcy-Weisbach?

A: Reynolds number is used to determine the nature of the fluid, Laminar or turbulent fluid.

Q: Air at 15 m/s is cooled from 80 C to 60 C in 2.5cm diameter tube. The tube wall is maintained at a…

A: