Assume steady-state, one-dimensional heat conduction through the symmetric shape shown in Figure 1. Assuming that there is no internal heat generation, derive an expression for the thermal conductivity k(x) for these conditions: A(x) = (1 - x), T(x) = 300(1 - 2x - x3), and q = 6000 W, where A is in square meters, T in kelvins, and x in meters. Consider x= 0 and 1.

Q: Q4) Write the relation between melting point temperature of ice with pressure? At 1 Atm, water melts…

A: Melting point is the temperature required for the solid to change its phase from solid to liquid.…

Q: A graphite heat exchanger is constructed by drilling circular channels in a solid block of graphite.…

A:

Q: A flat plate is cooled with a fluid with a Prandtl number very small (Pr << 1). Plate surface…

A:

Q: For a stream of water (at 32 °C) flowing over a plate at a constant surface temperature of (90 °C)…

A: Given:  T∞ = Twater = 32 oC            Thermal conductivity of water at 32 oC = 0.6 W/m.k…

Q: Calculating the entropy change for a composite ;process Calculate the entropy change when argon at…

A: Given:Initial temperature, T1=250C=298 KPressure, P=1 bar=105 PaInitial volume, V1=0.5 dm3Final…

Q: 1. During the isothermal heat rejection process of a Carnot cycle, the working fluid experiences an…

A: Given: In Isothermal heat rejection Carnot cycle, entropy change of working fluid is -0.7 Btu/R,…

Q: Q.4: A very long cylindrical rod is placed along the positive x-axis with one end at x = The rod is…

A: Given data: Temperature of the rod a cylindrical rod varies with distance and time. Sides of rod are…

Q: Solve the given problem involving Entropy. Show step by step process of your solution. How much is…

A: Given, The mass of ice, m = 50 g The initial temperature of ice, T1 = -10.5 °C = -10.5+273.15 K=…

Q: Steam at 235°C is flowing inside a steel pipe (k = 61 W/m ∙ °C) whose inner and outer diameters are…

A:

Q: A spherical stainless steel storage tank (k = 20 W/m.K) with 1.8 m inner diameter and 3.7 m outer…

A:

Q: Example 4.1 : Calculate the heat loss by radiation from an unlagged horizontal steam pipe, 50 mm…

A: Above problem is based on radiation heat transfer. Radiation is one mode of heat transfer. Radiation…

Q: The expansion of a closed system occurs at a constant pressure, there is no change in their kinetic…

A:

Q: 2 ' rs² In rs r 4k T(r) = Ts2 + (rs? - r) - 2 k

A:

Q: What does this graph show?

A: This question is based on data analysis.

Q: A block of wood and a block of steel are placed flush against each other. If temperature 1 (T1) is…

A: We have to select the correct temperature profile for the given conditions:  block of wood and and…

Q: Carnot efficiency of a heat engine between the temperature limits of TH (Higher temperature) and TL(…

A: Carnot engine is a thermodynamic cycle that gives the maximum possible efficiency of a heat engine…

Q: Which of the following is not an intensive

A: Intensive property is a thermodynamic property which does not depend on the amount of material in…

Q: Imagine gas in a piston – cylinder device. The fluid is compressed resulting to an increase in…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The equivalent to a 270 degrees Fahrenheit interval in Kelvin is: Answer:

A: Given: T = 270 °F

Q: Gases inside a cylinder are ignited causing a reaction with a heat loss of 1000 joules. The…

A: Heat loss to the surrounding, dQ=-1000joules (heat transfer to the system possitive, heat transfer…

Q: Find the two-dimensional temperature distribution T(tz) under steady state condition. Where, To-20…

A: T0 = 20 C = 293 K T(L) = 1000 C = 1273 K Density (p) = 800 kg/m^3 k = 200 W / m K Cp = 2500 J/ kg K…

Q: Calculating the entropy change for a ;composite process Calculate the entropy change when argon at…

A: Entropy is defined as the measure of a system's thermal energy per unit temperature. In other words,…

Q: For heat transfer, We have thermal diffusivity and thermal conductivity. But For mass transfer, We…

A: Thermal conductivity is defined as the ability of a material to conduct heat. It is the heat…

Q: Consider the heat transfer that occurs through the wall of a house. The outdoor and indoor…

A: Given data: Outdoor temperature = 0 0C Indoor temperature= 27 0C Exterior temperature of wall = 5 0C…

Q: The expansion of a hypothetical closed system takes place at a constant pressure with no change in…

A: First law of thermodynamics for closed system: dQ-dW=dEdQ-dW=dU+dEp+dEkas kinetic and potential…

Q: Explain with a sentence in the framework of a strategy why a correction factor is used in…

A: The concept of correction factor (CT) is for the case of multiple pass shell and tube heat exchanger…

Q: 02: How much thermal energy must be supplied by an electric immersion heater if you wish to raise…

A:

Q: A water pipe is buried 0.40 m below ground in wet soil (a=7.85 x10-7 m2/s and k=2.6 W/m.K). The soil…

A:

Q: Quiz2: Determine the value of specific entropy of steam at 2Mpa with temperature 400 °C. A) by…

A:

Q: 7.52. Show that the friction heating in a hydraulic jump is given by = 8(Zz - Z₁)³ 42122 (7.67)

A: Friction heating is taken as the energy loss.

Q: 5. Variable Heat Generation and Equation of Energy Change. A plane wall is insulated so that…

A:

Q: Water is poured into an insulating container. The water has mass m, = 1.2 kg and an initial…

A: Equilibrium temperature for the system is to be calculated.

Q: why does the freezing of ice or the condensation of water increase the entropy of the surroundings?

A: It is to be mentioned why the entropy of the surroundings increases during the freezing of ice or…