Assume r1=0x02 in 8 bit representation, what ARM assembly instruction will you use to perform the multiplication? Show the ARM assembly instruction to multiply r1 with 4 and show if the result is correct or not.

Q: Write an ARM assembly program ieee.s to assign the hexadecimal equivalent for IEEE 32 bit format of…

A: Answer: ADD  Rd, Rn, Rm {,shift} ;Rd =Rn +Rm ADD   Rn, Rm {,shift} ;Rn =Rn +Rm ASR  #n Arithmetic…

Q: Consider a RISC-V assembly function func1. func1 has three passing arguments stored in registers a0,…

A: In RISC-V assembly programming, understanding the structure and size of stack frames is crucial for…

Q: Write the following sequence of code into RISC-V assembler. Assume that x, y, and z are stored in…

A: RISV-V assembler:  Integer, logic, and a few memory commands are all included in RISC-V. Integer…

Q: What is the hex representation of the given RISC-V instruction? jal x5, loop assume loop is at…

A: Solution

Q: The CLC ISA ( a pretend ISA) is under development and in a state of flux. The CLC ISA uses a 40 bit…

A: Maximum number of instructions possible with n bits is given by 2n Hence maximum number of…

Q: A 12-bit field of a RISC-V instruction contains the value 0x8FF. Provide the correspondent 32-bit…

A: We need to provide the correspondent 32-bit value, expressed in hexadecimal, when the 12-bit value…

Q: Write a program to find the 2'S complement

A: Program to find the 2's complement   LHLD 1A00H;  MOV A, L CMA MOV L, A MOV A, H CMA MOV H, A INX H…

Q: Suppose you want to multiply two numbers using the long-multiplication approach in a 10-bit…

A: 31 * -30 Step 1 : 1*0 = 0 Step 2 : 3*0 = 0  =0+0=0 Step 3 : 1*3 = 3 Step 4 :  3*3 = 9 =93   000+…

Q: In MASM use the XCHG instruction no more than three times, reorder the values in four 8-bit…

A: XCHG:  Exchanges the contents of the destination  and source operands.  This is an instruction to…

Q: What would be the MIPS32 encoding of this instruction: or $t8, $s3, $t5? Write your answer as an…

A: Introduction: MIPS: MIPS is an abbreviation for "Million Input/output Per Second."  Computer…

Q: If an instruction is not accepted and it writes to VA page 30, what will happen? A TLB that is…

A: Given: Instructions that write to VA page 30The Translation Lookaside Buffer (TLB) table is searched…

Q: You have the following high level C code: long long int midterm22_pr1(long long int i, long long int…

A: Answers   There is a slight error in the given program. The variable f is declared inside the while…

Q: Using ONLY the add, sub and slli instruction to convert the following C statements to the…

A: This RISC-V assembly code is designed to implement a set of arithmetic operations, mirroring the…

Q: 3. Decode the following program from machine language into ARM LEGV8 assembly instructions. Use the…

A: HEX CODE  910010CACA020025

Q: An 8-bit data is read from an input device and stored in the memory location Ox20000200. This data…

A: Assembly instructions: MOV This instruction copies the source operand value to destination register.…

Q: Given the number 0x12345678 in PIC18 and the starting address is 0x28 a.Write instruction sequence…

A: Solution) Assembly Instructions   MOVLB This instruction moves literal value to BSR register.…

Q: What is the energy consumption of the worst-case MIPS instruction, and how much energy is required…

A: Intro Below the energy consumed by the worst-case MIPS instruction

Q: Consider the following RISC-V assembly language instruction. and rd,rs1,rs2 Which RISC-V data…

A: RISC: RISC-V pronounced as “RISC-five”, is associate degree ASCII text file customary Instruction…

Q: using RISCV(RVS) Write an instruction that multiplies the unsigned integer in x18 by 512 (in…

A: RISC-V is the type of the instruction set, which is pronounced as the risk five. This RISC-V is an…

Q: rgy consumed by the worst-case MIPS instruction, and how m

A: Below the energy consumed by the worst-case MIPS instruction

Q: Write an ARM code segment that will provide the equivalent to a NAND function. Hint: there is no…

A: The output of the logic AND function is reversed when it is sent via the logic NAND function. The…

Q: for (i=0; i<=w; i++) for (j=0; j<y; j+=2) A[3*i + j] = 2*i +3*j;

A: X4=w,  X5=y,  X6=i,  X7=j add X6, X0, X0  // i=0 Loop1:  beg X6, X4,  DONE  // go to DONE if i=w…

Q: MANUALLY decode the following ARM machine language code to ARM assembly instruction. 0XE5532911…

A: The machine language is basically the language understandable by machines. It is not readable by…

Q: ocessing: if operation is wrong, show the reason why it is wrong: a) MOV BL, 62 MOV AH, BL MOV AL,…

A: The solution is an given below :

Q: For the 8086 memory segment (011A) h with an offset (2B35) h, the memory address is

A: Need to calculate the memory address of Memory Segment(011A)h with offset (2B35)h  Memory Segment :…

Q: Write the assembly instruction to create the constant:

A: The instruction to create the constant 7232118090669728530 can be assembled as follows:   - ADD R1,…

Q: Given a bit pattern 0001 0001 0001 0000 0000 0000 0000 1011. what does it represent assuming it is…

A: Given bit pattern is 0001 0001 0001 0000 0000 0000 0000 1011. MIPS instruction formats are 3 kinds:…

Q: Assuming the instruction is 16 bits, what will be the content of location 405 after the execution of…

A: Let's analyze the instructions step by step:LDA 5: This instruction loads the value 5 into the…

Q: Given a machine-code RISC-V instruction is divided as in the figure below, choose the possible…

A: According to the information given:- We have to choose the correct option to satisfy the mentioned…

Q: Does the CMPS instruction provide any areas of ambiguity?

A: The "CMPS" guidance (another way to say "think about strings") is a x86 low level computing…

Q: Registers in RISC-V are 64-bit.  For the sake of simplicity, consider the following instructions…

A: RISC-V which is an open standard instruction set architecture that are based on established RISC…

Q: An ADD instruction stores a value 7308h at offset value 9F71h. If the computed address is 7CB31h,…

A: Given information:- Offset value = 9F71 h Computed address = 7CB31 h So, Initial address = Computed…

Q: This is the bit pattern for a type of SUB instruction in ARM. How many bits are in Rn? 31 30 29 28…

A: Instructions for an ARM processor may be 32 or 64 bit long. ARM is one of the architectures for…

Q: Q2:- (A) Find the phicycal address if (BP) = 0100H , (SI) = 0200H, (SS)= 2000H and a displacement of…

A: Given: Goal: We have to find the physical address using the instruction given in the problem. Also,…

Q: write a mips program that coverts 8-bit HEX input into mips instruction

A: write a mips program that coverts 8-bit HEX input into mips instruction

Q: only in RISC-V (RVS) answer the following both question, thumps up if both Write an instruction that…

A: We need to write instructions in Risc v for mentioned functions.

Q: siven that the program counter register (PC) currently holds the pattern ×2000000C, and that the…

A: a. What is the instruction type? --&gt; I-type  explain :  The defining characteristic of the I-type…

Q: Consider the MIPS I format instruction. This format is divided into 4 fields as shown here. A B C D…

A: 1) All MIPS instructions are encoded in binary.and  are 32 bits long. 2) All instructions have an…

Q: Using a system call to print a string of text, Change this MIPS code to RISC-V Assembly code.

A: RISC-V assembly is similar to MIPS assembly code. It has an integer, floating-point, branching,…

Q: For the following C statement, write the corresponding RISC-V assembly code. Assume that the base…

A: The given C statement is:j = B[A[i*2]] - 16; The expression i * 2 is being evaluated. The resulting…

Q: (i) „DATA Arrl Arr2 DWORD 300h, 400h, 500h, 600h WORD 50h, 60h, 70h, 80h .CODE MOV CX, [Arrl+2] MOV…

A: ANSWER:-

Q: When the CMP instruction sequence is executed, what is the final value for AL register ? MOV AL, 25h…

A: CMP instruction is used to compare contents of the Accumulator with given register R.  CMP…

Q: Using the mov.w instruction we copy the 16-bit word 0xB612 to the address 0x1C20. You do not need to…

A: Microprocessor:- A microprocessor is composed of several components, including an arithmetic logic…

Computer Fundamentals

The computer is termed computation. For calculating or computing something the device that has been used is known as the computer. Or we can say that for performing a fast arithmetic operation the device that has been used is a computer. Storing, processing, and retrieving are the main features of a computer.