Assign the IUPAC name to each of the following ethers. Name the smaller alkyl group as the alkoxy group. (a) CH,CH2–O–CH,CH,CH,CH,CH,CH,CH, (b) CH₂CH₂-O-CHCH (c) (d) (HCH,CHỊCH,CH,CH OCH₂ CH3 CHỊCHO- OCH₂ O

Q: 3) Phosphoric acid is a viscous, triprotic acid. A 7.00 percent by mass phosphoric acid solution has…

A:

Q: Part IlI: Determination of Saturated Solutions

A:

Q: 25.0 cm3 of sodium hydroxide solution are neutralised by 15.0 cm3 of hydrochloric acid of…

A: Balanced chemical equation: NaOH (aq)  +   HCl (aq)  ------>   NaCl (aq)   +   H2O (l) Number of…

Q: Identify mitigating measure/s What should be the appropriate response to minimize harm Karen is…

A:

Q: If this unknown sample comes from a closed system. Based on the Bjerrum plot and the pH value you…

A: Given pH=7 & Bjerrum plot of Carbonate system To determine: The predominant species of the…

Q: Dichloroacetic acid has a dissociation constant of K = 3.32 x 10-2. Calculate the dogree of…

A:

Q: Experument name: Salt effect on solubility and dissociation of benzoic acid (Effect of the ionic…

A:

Q: Calculation of vinegar Sample Volume of diluted vinegar 28.5 mL 2.1 M 47 mL Molar Concentration of…

A:

Q: Part 1 Do not include states of matter, multiplication symbols, or extra spaces. Use brackets [] to…

A:

Q: It says the solution is incorrect

A: Given that, for carbon-11 The half-life is t1/2 = 20.3 min. The initial amount is N0 = 1×107 atoms.…

Q: Course Home + 8…

A:

Q: What is the molar concentration resulting from mixing 25 mL of 2M and 100 mL of 4M?

A:

Q: Suppose that 50.0mL of 0.240M sulfuric acid requires 36.0mL of KOH solution to reach its endpoint.…

A: For finding the molarity of KOH solution we use following equation:          M1V1    =   M2V2

Q: A stock solution of approximately 7.7x10^-5 molar will be provided in lab. Determine the volumes of…

A: Given: Initial concentration of stock solution = 7.7 X 10-5 M And volume of final solution to be…

Q: What volume of a 0.241 M hydroiodic acid solution is required to neutralize 17.2 mL of a 0.170 M…

A: Hydroiodic acid ( HI ) is a strong acid and Barium hydroxide ( Ba(OH)2 ) is a strong base, therefore…

Q: Calculate mEq/L SO_4^2 of 0.0250 M solution of SO_4^2

A: Molarity = 0.0250 M

Q: against icing on pedestrian paths to prevent accidents table salt is used. Why is that?

A: Table salt , NaCl helps to melt the and remove it from the surface.

Q: what if the concentration of the stock solution CH4N2O2 is 11mM

A: Given that, The concentration of the initial solution is C1 = 11 mM, The volume of the dilute…

Q: O 1. 2. O3, -78 °C 3. H₂O2

A: First: Diels Alder reaction. Diene and dienophile react with each other to form the product.Second:…

Q: The approximate molarity of HCl solution was 0.1 M, What is the precise molarity of Hydrochloride…

A: The Molarity  is defined as Moles of HCl dissolved per litre of solution.

Q: In the standardization of HCl solution, a pale pink end-point using phenolphthalein indicator was…

A:

Q: The name of the apparatus used in salting out is Your answer

A: Salting-out is the effect when adding a salt to a solvent containing an organic solute reduces the…

Q: ......Can be used to differentiate between ethanol and phenol (a) Iron IIl chloride solution (b)…

A: Introduction: Ethanol is an aliphatic compound and phenol is an aromatic compound. Ethanol and…

Q: What is the approximate boiling-point elevation for the solution?

A: The property of a solution varies with the amount of the solute molecules present in the solution…

Q: Calculate the wt of oxalic acid required to prepare 1,000mL of 0.2 N of the solution.

A:

Q: Kr ions 12.3mL(1.36mol) In. KBr solution

A: Given: The volume of the solution of KBr=12.3mL=0.0123 L. The number of moles of K+ ions=1.36 moles.…

Q: the analytical concentration of a 1:1 dilution of concentrated ammonium hydroxide? Mixture of 1 part…

A: Let the volume of the concentrated ammonium hydroxide solution be 'V'.   This 'V' volume is diluted…

Q: Why do true solutions not show Tyndall effect?

A: Tyndall effect is the dispersion of particles by light and its often used to differentiate the true…

Q: Determine the initial concentrations of the species below, after the solutions are mixed. Volume…

A: Formula used M1 V1 = M2 V2 V2 = total volume = 20ml

Q: 29) The molecular interaction called “hydrophobic effect" is best described as: A) The attractive…

A: Hydrophobic effect is best described as:

Q: ons, relative to pure water. Assume complete dissociation for the Highest boiling point 0.39 m…

A: According to Raoults law,

Q: An aqueous solution is made of the diprotic acid H2A to a concentration of 0.15 M H2A. Ka1 = 3.0 x…

A:

Q: 7 2.00 8.00 8 1.00 9.00

A:

Q: Kindly show all solutions.  Applying the correct solution preparation procedure, calculations, and…

A: Given : strengths of solution       M1=14.8M, M2=0.296M, V2=500mL M1=molarity of concentrated…

Q: What is the ratio strength (w/v) of an isotonic solution for pilocarpine hydrochloride SCE 0.24? A.…

A: Answer -The correct option is (a) 1 in 26.7 Solution - According to the question - Given - Ratio…

Q: Provide instructions to prepare 50 mL of a K2SO4 saturated solution at 25 ◦C

A: A saturated solution is the one in which the maximum amount of solute that is soluble in the solvent…

Q: Which would you expect to have the higher vapor pressure? O cis-1,2-dichloroethene O…

A: The Structure of both the compound is -In cis-1,2-dichloroethene, the two chlorine atoms are on the…

Q: . According to Nernst', the molarity of the solution is the only factor that affect the value of…

A: NERNST EQUATION: In electrochemistry, he Nernst equation is used to find out the cell potential in…

Q: Use the References to access important values if needed for this question. The hydroxide ion…

A:

Q: T or F: The normality of the solution obtained by dissolving the acid sample be approximately the…

A: The normality of a solution is calculated by the ratio between the gram equivalent to the solution…

Diol

In chemistry there are so many chemical compounds that have a hydroxyl group but a chemical compound having two hydroxyl groups (-OH) is termed as a diol. It also implies the presence of two alcohols whereas polyols contain two or more than two hydroxyl groups (-OH). Glycol or 1,2-diol is an aliphatic diol that has two alcohol groups on adjacent carbon atoms. In industries, the most commonly used diol is ethylene glycol.