QUESTION 79Assign IP addresses to all of the interfaces.For Subnet 1 use addresses of the form 11.192.4.xxx; for Subnet 2 uses addresses of the form 121.192.10.xxx;Subnet 2Subnet 1a(2Switch s1Switch s2Router R1Assume ip address and MAC address are as follow:IPMACla84-29-9F-E8-FF-55bDC-50-DE-DO-AB-7DF6-E9-00-27-BB-4ВR1 port 122-B2-2F-54-AA-OFR1 port 291-BD-D2-D7-56-2AConsider sending an IP datagram from Host B to Host C.Suppose all of the ARP tables are up to date. Enumerate all the stepsStep 1Step 2

Dear Student, The ip addresses needed to be filled by subnetting the given address also, to…

Assign IP addresses to all of the interfaces. For Subnet 1 use addresses of the form 11.192.4.xxx; for Subnet 2 uses addresses of the form 121.192.10.xxx; Subnet 2 Subnet 1 Switch s1 Switch s2 Router R1 Assume ip address and MAC address are as follow: IP MAC a 84-29-9F-E8-FF-55 b DC-50-DE-DO-AB-7D F6-E9-00-27-BB-4в R1 port 1 22-B2-2F-54-AA-OF R1 port 2 91-BD-D2-D7-56-2A Consider sending an IP datagram from Host B to Host C.

Assign IP addresses to all of the interfaces. For Subnet 1 use addresses of the form 11.192.4.xxx; for Subnet 2 uses addresses of the form 121.192.10.xxx; Subnet 2 Subnet 1 Switch s1 Switch s2 Router R1 Assume ip address and MAC address are as follow: IP MAC a 84-29-9F-E8-FF-55 b DC-50-DE-DO-AB-7D F6-E9-00-27-BB-4в R1 port 1 22-B2-2F-54-AA-OF R1 port 2 91-BD-D2-D7-56-2A Consider sending an IP datagram from Host B to Host C.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Q1. For The Figure Below find the successor and FS (EIGRP) for path from R1 to Network 192.168.2.0 if all interfaces are GigabitEthernet and the delays are as follows: R1 int g0/0 = 2000 usec, R1 int g0/1 = 1000 usec, R2 int g0/1 = 10 usec R3 int g0/1 = 10 usec, R4 int g0/2 = 100 usec, R5 int g0/1 = 10 usec 192.168.1.10/24 Gigo/0 Fad Gigo/2 R1 a 192.168.1.0/24 10.0.0.0/30 Gigo/1 Gigo/0 Gigo/1 R2 10.0.0.12/30 10.0.0.4/30 Gigl/R3 Gig0/0 Gig0/1 RS Gig0/1 10.0.0.16/30 10.0.0.8/30 Gig0/0 Gigo/1 Gigo/2 Fao R41 192.168.2.10/24 192.168.2.0/24
An inbound IPv4 packet is received by a router with the routeing table shown in Figure 8-8. 10.55.72.234 is the originating IP address. 10.4.6.7 is the destination host. The TTL is set to one. The Protocol field has the value 6. What is the router's intended use for this packet?
In the following figure, assume computer A is sending a message to computer B. For the message from computer A to router R, what is the source and destination IP and the source and destination MAC? Source IP: Destination IP: Source IP: Destination MAC:
There are two hosts a and B, which are connected through router R1. The IP addresses and MAC addresses of a, B and R1 are shown in the figure. Write out the ARP request packet sent by a to B and the MAC address and IP address of the received ARP response packet. (including source address and destination address). 220.168.11.16 A 00-15-C5-C6-CB-11 220.168.11.1 R1 220.168.10.1 02-21-13-16-42-910-15-C5-C6-08-11 220.168.10.12 MACE 00-15-CS-CB-C4-95
Suppose a router has built up the routing table shown in Table 3.19. The router can deliver packets directly over interfaces 0 and 1, or it can forward packets to routers R2, R3, or R4. Assume the router does the longest prefix match. Describe what the router does with a packet addressed to each of the following destinations: (a) 128.96.171.92 (b) 128.96.167.151 (c) 128.96.163.151 (d) 128.96.169.192 (e) 128.96.165.121 Table 3.19 Routing Table for Exercise 56 SubnetNumber 128.96.170.0 128.96.168.0 128.96.166.0 128.96.164.0 (default) SubnetMask 255.255.254.0 255.255.254.0 255.255.254.0 255.255.252.0 NextHop Interface 0 Interface 1 R2 R3 R4
The following is a partial output from a show command on a router: Neighbor ID Pri State Dead Time Address Interface 192.168.1.1 150 FULL/DROTHER 00:00:16 192.168.1.1 FastEthernet0/o 192.168.1.2 100 FULL/DROTHER 00:00:16 192.168.1.2 FastEthernet0/0 show ip protocols O show ip ospf neighbor show ip eigrp neighbor O show ip neighbor
Briefly explain limitation and possibilities.
You would like to send a 2100-byte chunk of data uslng TCP from Computer A to Computer B. TCP segments are carrled In IP datagrams with a 20-byte header. IP datagrams are carrled In a data link frame with a 10-byte header. The maxlmum segment slze for TCP Is 800 bytes. The physlcal layer protocol can support a data rate of 1 Mbps. Assume a total round-trip time of 10 ms between the sender and the recelver. How many frames will need to be sent from Computer A to Computer B? What Is the size of each TCP segment? Show your work
Assume a new packet arrive with the destination address 11100000 01011111 00000000 00000001. Assume you have a tertiary content addressable memory (TCAM). Draw how you will match the destination address to the link interface using a TCAM.
In the above network diagram, IP and MAC addresses are given for network nodes. Suppose Host1 (Shahid) sends a datagram to Host2 (Khalid). What IP and MAC addresses (source and destination) will be written in IP and Data link layer headers respectively, for the following intermediate points from Host1 to Host2?a) Host1 to Router1 (R1)b) Router1 to Router2 (R2)c) Router2 to Host2
From the below image, assume that computer A is sending a message to computer B. For the message from computer A to router R, what is the source and destination IP and the source and destination MAC?
. The following is configured on a router Router(config)# interface g0/0.10 Router(config-subif)# encapsulation dot 1Q 20 Router(config-subif)# ip address 192.168.30.1 255.255.255.0 A packet is sent from the router out the subinterface to a trunk port on a switch. The switch will treat the packet as if it is on what VLAN? The native VLAN VLAN 30 VLAN 10 VLAN 20