٥ Assertion (A): One watt meter method of three-phasepower measurement is used for both balanced loadsand unbalanced loads.Reason (R): In one-watt meter method of three phasepower measurement, the total three phase power3*wattmeter reading.%3DChoose the correct answer from the following.a. Both A and R are true but R is not correctexplanation of AO b. A is true R is falseO C. A is false R is trued. Both A and R are true and R is correctexplanation of A

Assertion (A): One watt meter method of three-phase power measurement is used for both balanced loads and unbalanced loads. Reason (R): In one-watt meter method of three phase power measurement, the total three phase power = 3*wattmeter reading. Choose the correct answer from the following. O a. Both A and R are true but R is not correct explanation of A O b. A is true R is false O c. A is false R is true O d. Both A and R are true and R is correct explanation of A

Assertion (A): One watt meter method of three-phase power measurement is used for both balanced loads and unbalanced loads. Reason (R): In one-watt meter method of three phase power measurement, the total three phase power = 3*wattmeter reading. Choose the correct answer from the following. O a. Both A and R are true but R is not correct explanation of A O b. A is true R is false O c. A is false R is true O d. Both A and R are true and R is correct explanation of A

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Explain this and elaborate
6.2. Consider an LTI system described by the difference equation y[n] = 0.25y|n – 1] + æ[n] + v2æ[n – 1] + æ[n – 2). a) Plot the pole-zero diagram for this system. h) Plot the system's magnitude response |H(e)| c) What type of system is this: lowpass, highpass, bandpass, or bandstop? over -T < 2
What is the meaning of transient
Subject-power electronic Define A.Delay time B.Rise time C.reverse recovery voltage D.spread time.
· Explain the meaning of terms (Accuracy and Precision) and give example for an each?
3. Explain any four dynamic characteristics of measurement system.
16) For the CRO display of a pulse waveform, the time/cm is on 18.7 ms/cm and the volt/cm switch is on 5 V/cm. The width of one complete cycle is 16.2 cm and the height of the pulse is 3cm. The time period will be___________________ seconds. 30294.00 0.33 0.00 0.30
QUESTION 3 a) b) Briefly describe the following terms for a generic second order instrument response. i. time constant (T) ii. rise time (Tr) iii. settling time (Ts) iv. peak time (Tp) Indicate the following characteristics on the generic second order response given in Figure Q3(b). i. Rise Time ii. iii. iv. Settling Time Min Settling Time Max Settling Time V. Overshoot vi. Undershoot vii. Maximum peak viii. Peak Time Amplitude 4 3.5 3 2.5 1.5 1 0.5 0 0 5 Step Response 10 Time (seconds) Figure Q3(b) 15 20 25