As shown in the figure, a 320-ft3 tank contains 25 lb of H2O initially at 30 lbf/in?. The tank is connected to a large steam line car steam at 200 lbf/in?, 450°F. Steam flows into the tank through a valve until the tank pressure reaches p2 = 100 lbf/in? and the temperature is 400°F, at which time the valve is closed.

As shown in the figure, a 320-ft3 tank contains 25 lb of H2O initially at 30 lbf/in?. The tank is connected to a large steam line car steam at 200 lbf/in?, 450°F. Steam flows into the tank through a valve until the tank pressure reaches p2 = 100 lbf/in? and the temperature is 400°F, at which time the valve is closed.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A reheat cycle with two stages of reheating is executed with steam expanding initially from 25 MPa and 600 °C. The two reheater pressures are 4 MPa and 1 MPa, and the steam leaves each reheater at 600 °C. Condensation occurs at 40°C. For 1 kg/s of steam, what is QA in kW? Remember, 1. For values taken from the steam tables: Use them as is, do not round off. 2. For values obtained by interpolation and final answers obtained by solving, use FOUR (4) decimal places. 3. Use the steam tables provided
Given: P3 = 4 kPa, x3 = 0.6 , P4 = 4 kPa, T1 = 25 oC, T2 = 35 oC, mdot_steam = 25 kg/s. Find mdot_water (kg/s).mdot_water = _________ kg/s.
Q2 O of O points Q2:In a steam power plant operating at steady state is supplied to the high pressure turbine at 5 MPa and 400 °C. after expansion to 500 kPa the steam is reheated at constant pressure to the original temperature. The steam expands in in the low pressure turbine to an exhaust pressure of 10 kPa . Find 1- h:
Initial condition: T = 360Ch = 1860.8 KJ/kg Process: IsometricFinal condition: saturatedRequired: Final pressure
Solve the problem and show the solution.Note: The answer is given on the bottom right side of the image, just show the solution on how to get it.Thanks!!!
37. A certain gas with Cp = 2.215 KJ/kg °K and R= 0.518 KJ/kg °K with a volume of 0.425m3 and 300 °K has an initial pressure of 106.869 KPa.Heat is added at constant volume until the final pressure becomes 387.72 KPa. How much heat is added?
Saturated steam at P1=25 bar expands adiabatically through a throttling valve to P2=4 bar. If the quality of the steam at the valve inlet is x1=0.9 what is the quality x2 at the valve outlet Please respond ASAP
As shown in the figure, a 320-ft³ tank contains 25 lb of H₂O initially at 30 lbf/in². The tank is connected to a large steam line carrying steam at 200 lbf/in², 450°F. Steam flows into the tank through a valve until the tank pressure reaches p2 = 100 lbf/in² and the temperature is 400°F, at which time the valve is closed. Step 1 Steam at 200 lbf/in.2, 450°F Am 12 = i (1) Valve AD Determine the amount of mass that enters the tank, in lb. lb (1) Determine the amount of mass that enters the tank, in lb, and the heat transfer to the tank from its surroundings, in Btu. Tank Initially: 30 lbf/in.², m₁ = 25 lb (2) Finally: P₂ lbf/in.², 400°F.
Q) A & B are rigid tanks. Tank A has volume of 1 m3 , contains steam with 4 MPa and 500 °C heated by external heat source with 130 kJ. The valve is open allowed to part of steam exit from the tank A to an evacuated and insulated tank B at constant temperature, then the valve is close when the final pressure in tank A reaches to 2 MPa and the mass reduce by 2/3. Determine the volume of tank B. A в
1. A gas undergoes isobaric process with a constant pressure of 2000 Pa. If the heat of 800 J is added to the process, the volume expands from 0.120 m to 0.200 m. What is the change in its internal energy? 2. An engine absorbs 500 J of heat and reject 100 J of heat to cold reservoir in each cycle. What is its efficiency? 3. From Question 2, how much work does the engine do in three cycles? 4. A refrigerator has a coefficient of performance of 2.0. In each cycle it absorbs 3.4x10 J of heat from the cold reservoir. During each cycle, how much heat is released to the high-temperature reservoir? 5. During running, you lost 4.0x10 J of heat, and your internal energy also decreased by 1.6x10* J. How much work did you do in the match?
I need the answer as soon as possible
I need help with this thermo practove problem that I do not understand- thank you! 2 kg of air in a piston cylinder initially at P1=101 kPa, T1= 300 K undergoes a cyclemade up of three processes: 1-2 Isothermal compression until the volume is (1/15) of its original value.2-3 Constant Pressure heating3-1 Isentropic Expansion back to the initial state Assume air is an ideal gas with constant specific heats with the following values: Cpo=1.027kJ/kgK; Cvo= 0.740 kJ/kgK; R=0.287 kJ/kgK; ɣ=1.388 Fill out the processes table below. Calculate Processes 1-2, 2-3, and 3-1 clearly