As shown in figure below, a closed, rigid tank is filled with Refrigerant 22, initially at -10°C, a quality of 75%, and a volume of 0.03 m³. Since the quality of initial mixture is 75%, there is 25% liquid in the tank. You are asked to convert all liquid into vapor using a 12-volt battery and fine-wire electric resistor. You deicide to pass 6-amp of current to the resistor for 15 minutes. After 15 minutes you measure the temperature of the final vapor to be 40°C. a. determine the amount of electric work used in this process, in kJ. b. assume that tank was not insulated from surroundings. How much energy was wasted to surroundings in the form of heat transfer, in kJ. c. find efficiency of your heating process, where efficiency is defined as the ratio of internal energy change of R22 divided by electric work. d. sketch the process on T-v diagram.

As shown in figure below, a closed, rigid tank is filled with Refrigerant 22, initially at -10°C, a quality of 75%, and a volume of 0.03 m³. Since the quality of initial mixture is 75%, there is 25% liquid in the tank. You are asked to convert all liquid into vapor using a 12-volt battery and fine-wire electric resistor. You deicide to pass 6-amp of current to the resistor for 15 minutes. After 15 minutes you measure the temperature of the final vapor to be 40°C. a. determine the amount of electric work used in this process, in kJ. b. assume that tank was not insulated from surroundings. How much energy was wasted to surroundings in the form of heat transfer, in kJ. c. find efficiency of your heating process, where efficiency is defined as the ratio of internal energy change of R22 divided by electric work. d. sketch the process on T-v diagram.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Can you solve this problem (full solution) for my thermodynamics subject. Thank you 4. Five kg of water vapor are contained at 150 kPa and 90 percent quality in a suitable enclosure. Calculate the heat which must be added in order to just produce a saturated vapor. What will the pressure be at the end of the heating process? Ans. 1045.5 kJ, 168 kPa.
A rigid closed tank contains refrigerant 134a wnich is initally a two- phase liquid - vapor mxiure with a temperaflure of D'c and a quality of Ce0%. An electrical resistor nistalled inside the Fank transfers until the tank contains only saturated vapor. if the tank is well - insulated and the mass of the Cefrigerant is 1.5 kg, determıne the time it takes for the process to be completed in seconds using 5 signifigant Agures
Special Home Work A tank of 2m' volume contains saturated ammonia at a temperature of 40°C, the tank contains 50% liquid and 50% vapour by volume. Find the specific volume, enthalpy, and internal energy of the mixture. (3.369x10 m/kg, 232908kJ, 229816KJ).
A substance initially at 290kPa, 8 m³ is expanded to 37 m³ at in a process where PVn=const., n = 1.19. Determine the final pressure (in kPa)
Mr Zul operates a hot plate. He places a closed, rigid container of volume 0.5 m3on the hot plate. Initially, the container holds a saturated mixture with quality ofvapour of 0.5, at a pressure of 100 kPa. After heating, the pressure in the containerincreases to 150 kPa.a) Calculate the mass of vapour at the initial and final states (in kg).b) If heating is allowed to continue, find the pressure (in kPa) when thecontainer holds only saturated vapour.c) Sketch the T – v diagram for this system.
Provide complete solution and detailed diagram. A gas has an enthalpy of 2400 KJ/kg and internal energy of 2200 KJ/kg. Find the specificvolume of the gas at 950 Kpa pressure. A. 0.12 m3/kg B. 0.93 m3/kg C. 0.72 m3/kg D. 0.21 m3/kg
2) Two glass bulbs, one on the left with a volume of 2 liters and the other on the right with avolume of 6 liters, are connected to one another by a thin tube that is initially closed by astopcock. The bulb on the left has 0.1 moles of ideal gas, and the bulb on the right isevacuated. The system is in thermal equilibrium with the surroundings at 300K. When thestopcock is opened, the gas flows out to fill both bulbs. Calculate A for this process. If wewere to insert a propeller to extract work as the gas flows from left to right, what is themaximum amount of work that we could possibly extract?
Assuming air is an ideal gas composed of only O2 and N2 how much heat is necessary to heat the air isobarically from 30 degrees celsius to 500 degrees celsius? We are given the conditions that pressurized air is at 30 degrees Celcius and 5 bar. It is then preheated to 500 degrees celsius and then compressed to 35 bar. The air compressor operated at a 75% efficiency.
Hi, pls help me solve this problem. Thank you so much.
Thermodynamics
With 3% moisture, 2.5 kg of steam has an enthalpy of 6600 kJ. It is heated at constant pressure to a final condition of 80 o Find (a) the pressure of the process, (b) the quantity of heat received by the steam, and (c) draw and use h-s diagram.
i need the answer quickly