As a mechanical designer you are given the task to design a Slider-Crank Mechanism. The mechanism must have a time ratio of 1.20, a maximum linear displacement of 0.375" and a total cycle time of 0.025 seconds. Using either graphical or analytical methods, determine the following: Link lengths of the mechanism. • Crank speed. Explicitly state the value of any variables which you are choosing arbitrarily.

Q: F2 = 40 N %3D 4 m F= 70 N %3D 2 m 3 m B. 3m 2 m 3 m

A:

Q: Determine the x and y components of F, and F, acting on the boom shown in Fig. 2-18a. Express each…

A:

Q: Determine the components of the force of reaction at point A. Assume that the positive x and y axes…

A: Given Data:   To Find: (a) Components of forces at A. (b) Moment of reaction at A.

Q: Required information Determine the magnitude of the forces. In the given figure, y = 300 N, V2 = 1.6…

A: Draw the free body diagram of the system. Apply force equilibrium in a horizontal direction.…

Q: The cable is attached to the boom at A and to point B as shown in (Figure 1) so that x = 60 ft, y =…

A:

Q: F2 F1 40 60 Q1- Use the Parallelogram law, Sine law and Cosine law to add the forces shown above: F1…

A: Parallelogram law is method to find the vector addition of two vector which states that if two…

Q: The x component of the cross product of the vector from C to D times the force F. (Use the format…

A: Solution:-Given dataA≡0,2,0B≡4,4,4C≡0,0,4D≡4,0,0F=105 N

Q: Solve for A and B. P=400 lbs. 0=30° P 45° B www Drawing not to scale. Use given angles. Magnitude of…

A:

Q: Determine the magnitude of the resultant force. Replace the three forces acting on the shaft by a…

A:

Q: Answer the following question: 4. Find the forces at points A and B of the landing gear shown.

A:

Q: F (given 30 N) into AB and AC. 0=23º and F A 35° C

A:

Strain energy

The term strain indicates the variation in an object's length, area, and volume when the object is subjected to an external force. The external force may be of normal, shear, moment, torque, etc. The strain in an object depends on the types of external force and cross-section of the object. Mathematically, the evaluation of strain can be obtained with the help of elastic constants.