Are the members of the frame and the connecting pins adequate to support the 30-kN load? 30 kN If rod BC is made of steel with oallow 165 MPa, can it support the stress produced by the 30 kN load?

Q: Convert: the density of the blood 1060 Kg/m³ to mg/cm³ Answer:

A:

Q: Light from a medium with index of refraction n₁=1.22 passes into a medium with index of refraction…

A:

Q: Solvè ß

A: Ohm's law states that the current through a conductor between two pointsis directly proprotional to…

Q: I need help with number 3 please and round all numbers to three significant digits please

A: Q 3(a) Given Data : The magnitude of charge 1 is given as Q1 = 1.33 μC. The magnitude of charge 2 is…

Q: 4. The Earth is (approximately) a sphere of radius 6.37 x 106 m. (a) Find the circumference of the…

A: Radius, r = 6.37×106 mCircumference, C = ? Surface area, A = ?

Q: 4. Fret if a 1 is increased three times and qz is reduced to 2 : 5. Fnet if g2 is increased three…

A: Given data: The net force between two charges is given as, Fnet = 500 N Formula used: According to…

Q: I need help with 4 please and round all numbers to three significant digits please

A:

Q: An object of mass M is attached to a string. The length of the string is r and has no mass. The…

A:

Q: 400 MF value capacitor. what value L Showld circuit choose engineer analyzing the an the voltage…

A: Series LCR circuit A series LCR circuit contains an inductor, a capacitor, and a resistor in series.…

Q: Question 4: Consider the following setup: C Determine the equivalent capacitance, and the charge on…

A: 4)4 capcitors are connected in an arrangement as shown in the circuit. The capacitance of each…

Q: Supplement 1. What force is' needed to accelerate a child on a sled -(total mass = A grocery sack…

A:

Q: and velocity as the fil impulse identical to in problem 31. Howe designed to crumple

A: Given as, Average force= 1.23×107 NS, Time interval= 21.0 ms=21×10-3s, Interaction duration= 57.1…

Q: 9. In the circuit shown at the right, what is the value of the current at point Q? Www 202 www 102…

A:

Q: 2. A rod is 1.0 meter long (r₁ = 1.0 m) and connected to a pivot point on its left end so that it…

A:

Q: Problem 8: Penny is adjusting the position of a stand up piano of mass m, = 220 kg in her living…

A: Part (a) Minimum force Fs is, Fs,min=Ffr2=μsmpg2

Q: An angle of a circle with a 2 m radius is A0 = 20°. What is the corresponding arc length As? 11. D.…

A: 11. radius of circle,r=2 m∆θ=20

Q: Q4: A copper ball is heated to a temperature of (212°F) then at time (t-0) it is placed in water…

A:

Q: A point source S emitting light of wavelength 600 nm is placed at a very small height h above a flat…

A: We are aware that a point source S is positioned at a very low height h above a flat reflecting…

Q: 8. From Ampere's law, it can be shown that the magnetic field B inside a long solenoid is B = HonI…

A:

Q: (5) A 15.0A current produces a B field at the center of an arc of angle n/4 radians and radius…

A: (5) Given Current (I) = 15.0 A Radius (r)  = 0.500 m Angle θ  = π4 radians

Q: 5. If an electrically neutral object is induced and acquire 10 positive charge. How many electrons…

A: 5. Given that, An electrically neutral object is induced and acquires 10 positive charges.  We need…

Q: 5. Two long, parallel conductors, separated by 10.0 cm carry currents in the same direction. The…

A:

Q: A 10.-kilogram rubber block is pulled horizontally at constant velocity across a sheet of ice.…

A:

Q: elect the corresponding answer to the ff questions.

A: Solution: option c is correct. Explanation  Velocity : It is define as the rate of change of the…

Q: relative to the origin is d = (2.00 m)i + (4.00 m) - (3.00 m) k, its velocity is = -(4.03 m/s) î+…

A:

Q: 12. What is the ratio of the electrostatic force to the gravitational force between two electrons?

A: 12)the charge on an electron (q) = - 1.6×10-19 C mass of electron (m) = 9.11×10-31 kg Let the…

Q: answer is incorrect, it should be option 3

A:

Q: 6. A simple pendulum passes through the lowest point in its swing at 1.25 m/s. In order to find the…

A: The lowest point during the swing of a pendulum is one where the height of the pendulum is exactly…

Q: Given A = y 4a + a_and vectors B = 2a_ + 3a , find the scalar projection of A on B. %3D 2 Answer:

A: Given  A→=4ay→+az→B→=2ax→+3ay→ Scalar projection of A→ on B→ is given by, s=A→·B→B

Q: 2. What is the maximum length of a wrench needed to apply 90 Nm torque to the bolts on a motorcycle…

A:

Q: 1. Shown in the figure is a homogenous plate of uniform thickness. In which labeled region is the…

A:

Q: 44. (II) An unmarked police car traveling a constant 95 km/h is passed by a speeder traveling 135…

A:

Q: separated by 8.50 cm, is 8.00 × 10

A: Given: Distance is 8.5 cm or 8.5×10-2m Electric field strength is 8×104V/m

Q: 25. If the screen is moved closer to the slits, the distance between the central maximum and the…

A: Given : (Note : Given is a multiple kind of question. Answer for first one is given below. Please…

Q: 20. A point charge of -1.0×10°C and a charge of + 3.0x10°C separated by 5.0x10² m what is the…

A: 20. Given data: Magnitude of charge 1 is, q1=-1.0×10-9 C. Magnitude of charge 2 is, q2=+3.0×10-9 C.…

Q: Problem 6: Consider a ball of mass m attached to a string of length L, which is being spun around in…

A:

Q: Three point charges are aligned along the x-axis as shown in the figure below. Find the electric…

A:

Q: A model rocket is launched straight upward with an initial speed of 50.0 m/s. It accelerates with a…

A: Given: initial speed u = 50.0m/s upward acceleration a=2.00m/s2 engine stops at altitude of 150m

Q: 6. A satellite of mass, m = 200 kg orbits the Earth at a %3D distance of 30 000 km measured from the…

A:

Q: 6. Where are the points of (a) maximum and (b) minimum probability of finding a particle trapped in…

A: The probability function is ψx2.  The wavefunction for a particle trapped in a box of length L is…

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).