Answers for calculated individual voltages Topic: the voltage divider circuit.

Q: There are three 15,000-ohm resistors connected in series across a 120-volt DC source.  What is the…

A: The solution can be achieved as follows.

Q: what are the two main classifications of resistors?

A: Two main classifications of the resistors are:  1-Fixed or constant resistor 2- Variable resistor…

Q: Can you show the circuit for this or the diagram?

A:

Q: ectrician A says that a circuit breaker marked 120/240 V is acceptable for a circuit that doesn't…

A: Answer: B.  Electrician A is correct

Q: Explain in paragraph the relationships of resistance, voltage and current, and the distribution of…

A: Question is asking about relationships of resistance, voltage and current  also distribution of…

Q: What is the correct way to measure current in a completed circuit using a DMM? O Connected in series…

A: MultimeterThis type of meter is used for the measurement of electrical characteristics. It can…

Q: How to turn-off a current source? A) Set it to zero. B) Replace it with a short-circuit. (C) You…

A: What is the process to turn of the current source  : Options are : Set it to Zero. Replace it with…

Q: provide specific values for the resistor, power source, and Red LED

A: Power Source: Typically a battery or a DC power supply.LED (Light Emitting Diode): A semiconductor…

Q: What is the resulting voltage when you connect two 9- Volt batteries in parallel?

A:

Q: Please answer in typing format for like

A: Case 1: 0 < x < 1.50The force due to q1: F1​=ke​x26e⋅q3​​The force due to…

Q: hat is the normal resistance measurement range for most DMMs?

A: Digital multimeter (DMM), is must-have equipment in an electronic or electrical laboratory.  DMMs…

Q: How is concept of voltage in electrical circuits is related to the concept of energy

A: relation between voltage and energy in electrical circuits.

Q: 1. The letter designation SL on an electrical draw- ing indicates a a. limit switch b. low-voltage…

A: As per our policy, i am attempting first question. The letter designation SL on an electrical…

Q: What is the advantage of using the voltage divider technique in determining the voltage across a…

A:

Voltage Division Method

In the electronics branch, a voltage divider is required to produce a section of its input voltage as an output. This basic circuit may be prepared with two resistors or any passive elements along with the voltage source. The circuit resistors are attached in series and a voltage source is braced across these resistors. The input voltage can be transferred between the resistors in the circuit for the voltage division to occur. The SI unit of electrical resistance is ohm (Ω) or kilo-ohms (kΩ).