angle of twist

Q: If the part was cut by this plane, what would the resulting remaining face look like?

A: Section planes in SketchUp cut a model along a plane so you may look within it without altering…

Q: What is the class of fit of a ½-20 UNF-2B thread?

A: The united thread series is classified into coarse threads, fine threads and extra fine threads. The…

Q: just to clarifay is the shaft stainless steel? or the tool making the threads on the shaft

A: It is the shaft which is made up of stainless steel.

Q: What is the procedure of using the Mohr's circle?

A: The procedure of Mohr's Circle is given as, (1) Draw the vertical and horizontal coordinates. The…

Q: It is only required to move the cutting tool from the circumference to the center of the workpiece…

A: Introduction A milling machine is a machine that removes material from a workpiece by feeding it…

Q: Which set of ordered processes best describes the steps to perform an emergency stop and reset of…

A: A lathe machine is used for the turning, facing, drilling, and surface finishing processes of…

Q: What happens when an external torque is applied to a shaft?

A:

Q: Draw three views of the adjusting bracket. . Orill-2 Holes 3 BOrill

A: The figure below shows the top and front view of the given model.

Q: The largest soft aluminum tubing that may bent by hand is ________________ -inch outside diameter. *

A: Solution:

Q: What is the MMC of the bored holes?

A: Maximum Material Condition(MMC): In GD&T, the MMC is a feature which contains the maximum amount…

Q: What is the axis of symmetry?

A: The Axis of symmetry is the axis that divides an object into two equal halves. symmetry divides the…

Q: What is the Axial Load?

A: The axial load is a force that acts along the centroidal or longitudinal axis of the system. If the…

Q: Facing is an operation to reduce the diameter of work piece. Select one: True False

A: False

Q: the main diference between the prick punch and center punch?

A: Prick punch is a mechanical tool, which is made up of steel and it is used to mark points on the…

Q: How many and what kinds of materials are needed to start a thread?

A: To start a thread, you typically need the following materials: Thread material: This can be made…

Q: Define the term Angle of Twist?

A: Whenever a twisting moment is applied on the shaft, the shaft's cross-section tends to rotate or…

Torsion

In mechanical engineering, torque, torsion, and twisting moment are three of the most important concepts which have different meanings. Torque is the consequence of a moment of a force that produces an angular acceleration in a body or induces rotational kinetic energy in a body. For instance, in an automobile, the power transmission shaft is a body that is always under rotation due to the external torque acting on it, this torque is created by the engine.