and When the Number of branches is absorbed power by R2 is 8mW and the O 3 current passing through R5 is 2mA, 4 O 5 determine E 6. and R4 O None of the above

Q: Explain why (This is voltage divider) Terminal D = 20 Vdc Terminal C = 10 Vdc Terminal A = -15…

A: In this question,  Find the voltage at the point A, C, D  We know V= IR

Q: Calculate the current across RL1 if RL = 10 ohms. * R1 R2 3 0.8 R3 RL1 2V 0.00067 A 0.0067 A 0.67 A…

A:

Q: What will be the value of V1 in the following circuit? 3R 6R 6R (+ 1

A: The value of the voltage v1 has been determined in the following section.

Q: 18 of 20 K What are the expected voltages at points C and D of this circuit? O 12 V and 12 V O 0.01…

A:

Q: Determine by Ohm's law and Joule's law the total power in Rx for the following circuit. + 20 v= N M…

A: We need to find out power for given resistor in the given circuit.

Q: Determine Yx using super position. Vx SA 23 VN2 AV V 5 (1 Vx/21 4 + 1

A: Given circuit is,Asked to find the voltage Vx by using superposition theorem.

Q: If I = 36 mA when E = 12 V, what is I if the 12-V source isreplaced by an 18-V source? O 1. 72mA O…

A: In this question we will find current in circuit. ..

Q: What is power through the 3 ohm resistor What is votage through the 1 ohm resisitor What is the…

A:

Q: su 1. 3 kN, R4 = 4.7 k, C₁ = C₂ = 0.1 µF. 2. Set E 6 V dc. 3. R₁ Figure 1-2. Schematic measurements…

A:

Q: From Circuit below the value of 1, 12 and 13 are ww ww 1 ohm 3 ohm 5 ohm 5V 2 ohm 4 ohm 15V 13 1.29…

A:

Q: 5. 8 V 2 2 6 V 6. + 2 V 6 2 /12 4 S2 1 V + 2 S2

A: 5) To find the current flowing through the circuit apply KVl to the circuit. Applying KVL to loop 1…

Q: Is 5A R1 2 Ohm D₁ x 412 R2 4 Ohm iz Dz 2t

A: The given problem is from circuits.  The detailed solution is given in the next step

Q: to generate high power, the solar cell must be connected in None of the above 1 series and Parallel…

A: We need to answer to generate high power what will be the arrangement of the solar cells.

Q: 14 N 10 N 5 V V i2

A: Here i have solved it using mesh analysis.

Q: 38. By source conversion, Find the various branch currents. Check e No dal Analysis· 22 a I ab 5 A 3…

A: Given circuit- We will be using concept of superposition to simplify the problem

Q: +5 V 1.0 kl Vin 0V 1.0 kN -5 V Figure 4

A:

Q: A 100-0 resistor and a 50-0 resistor are connected in parallel and a total current of 3 A flows.…

A: The solution is given below

Q: What happens to total current flow when an additional load is added in parallel? Current stays the…

A: Current in parallel circuit- The sum of the branch currents makes up the total current in a…

Q: 5 Determine the value of R that will dreapie the mazimum power from therest of the cirewit in the…

A: Given circuit: It consists of dependent and independent sources. The maximum power across load…

Q: 4. Determine the number of branches and nodes. Using Kirchhoff's law find ₁ and 1₂ OGA 1₁ R1 40 5A…

A:

Q: How many star and Delta Conversion for this circuit to find It It 12 45 12 45 lo0 Uele 12 12 7 mun…

A:

Q: what is the voltage shown by the multimeter

A:

Q: Find the voltages at each of the nodes in the figure

A:

Q: R 0.5A 10V Ela ?

A:

Q: What is the voltage drop across R1? (image 1) What is the total current? (image 2)

A:

Q: find the complex Power for each brakeh and the total comPlex Power for the circuit shown figure In…

A: Complex power in each branch  S= VI* V voltage across branch I current flow in branch.  I* conjugate…

Q: If R=500 ohm, what is the equivalent resistance seen by the source? R R R 12 V R R R R

A: Given

Q: 22 (2 150 12.0 V 12.0 V 110 w 6.0 V ly 12.02 1802 1 of 1 Determine the currents Is. Is, and I in the…

A:

Q: R1=150 R3=120 Eg=25V rg=0.50 EA=50V rA=10 Ec=75V rc=0.50 R5 50 R2=100 R4=60

A: Nodal analysis is an important method to solve big and complex circuits. It is based on Kirchoff's…

Q: Find current thru 52 resistor near the constant current source. -j5 N 5Ω HE 3Ω 100/0° V( 5Ω 10/30°A…

A:

Q: V1 V2 3/0° A -j3 N j6 Q 12 ll

A: Applying KCL at V1,…

Q: Homework Pind the currents , through la and the voltage vo in the circuit in the following figure.

A: The current in the below circuit canbe calculated using nodal analysis

Q: How many star and Delta Conversion for this circuit to find It It 4 12 ww. 12 45 lo lo0 Uelk 12 of…

A:

Q: etermine the approximate value of VGs of Figure 55. VDD 21V 910k 2.2kQ $110kQ Q1 V₂ 1kQ loss 10mA…

A: The answer is calculated below

Q: What is the expected voltage drop across each load in this circuit? O 12 V and 12 V O 10 V and 2 V…

A:

Q: 5.5 KJa 24 kr ww Ri ww R4 Rz

A: To find the total resistance of the circuit

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).