Analysis of a chromatogram of a mixture containing 0.0124 M analyte and 0.0448 M standard found that the peak area from the analyte was 324 and that the peak area from the standard was 258. In another experiment, a solution containing an unknown concentration of analyte and 0.0381 M standard was analyzed. The peak area of the analyte was 231, and the peak area of the standard was 197. What is the molar concentration of the unknown?

Q: In running a Beer’s Law lab, you are given 50.00 mL of a 25.00 µM solution of the organic pigment…

A: The initial concentration of crystal violet is 25.00 µM and volume of this solution is 50.00 mL…

Q: A stock solution of potassium permanganate (KMn04) was prepared by dissolving 13.0g KMn04 with DI in…

A: Record the given data, The given weight of KMnO4 = 13.0 gm The molecular weight of KMnO4 = 158 g/mol…

Q: student obtained 2.111 g of a mixture containing four components. After performing separation by…

A:

Q: An unknown food-dye is analyzed by the method used in this experiment. The absorbance of 5 standard…

A: Given:Abs = 4.300x + 0Absorbance = 0.65

Q: The absorbance of a cationic iron(II) sample solution was measured in a spectrophotometer, but the…

A: Given that: the initial volume of sample = 100.0 μL diluted volume = 2 mL +100.0 μL  concentration…

Q: An unknown food-dye is analyzed by the method used in this experiment. The bsorbance of 5 standard…

A: Given : Abs = 4.150x + 0.08

Q: Data: (make sure to include appropriate units) Unknown number 1.509g Trial 1 Trial 2 0.51ml 1.15ml…

A: • In a balanced chemical reaction the reactants react and products form in the molar ratio of their…

Q: Following the directions in the laboratory manual, you create Standard 2 by transferring the…

A: Calculate the total volume of mixture of solution in the test tube. i.e.…

Q: You begin preparation of the calibration curve to measure absorbance vs concentration of FeSCN²+. To…

A: The objective of this question is to calculate the resulting concentration of FeSCN2+ after the…

Q: In a similar experiment, the mass of 3 PB tablets was measured to be 3.1177 g. The tablets were…

A:

Q: In the first step of this process sodium bromide is dissolved in water. It is mentioned that not all…

A: Given data:  The solubility of NaBr = 0.9432 g/mL Mass of NaBr = 78 g Volume = 75 mL

Q: professor Scimemi has accepted you as a Master’s student and you are involved in a project that…

A: You need to make 2.5 mM KCl. The formula for weighing is as follows: Amount of KCl (g) = [Molarity…

Q: Volumetric flasks show no intermediate gradations, but they show a single mark to indicate, with…

A: The objective of the question is to determine the concentration of the solution prepared in the lab,…

Q: A solution of HNO3HNO3 is standardized by reaction with pure sodium carbonate.…

A: To determine the molarity of the HNO3 solution and the absolute uncertainty associated with it. The…

Q: A pool cleaning solution is mixed from three different bottles of solution. The first bottle…

A:

Q: A stock solution of 7.99 microM dye is provided. While making one of the standard solutions, a…

A: Given data :

Q: The molar volumes of pure acetone and pure chloroform at room temperature are 72.0 cm^3 and 81.0…

A: The volume of one mole of acetone is = 72.0 cm^3 The volume of one mole of chloroform is = 81.0 cm^3…

Q: You begin preparation of the calibration curve to measure absorbance vs concentration of FeSCN2+. To…

A:

Q: To measure the blood Ca2+ concentration of a patient’s sample, 5.00 mL of blood was diluted to a…

A: To solve this question we have to careful about units and how many times successive dilution was…

Q: An environmental study was performed to measure the transport of a DDT (a banned pesticide)…

A: The relative response factor can be calculated as: Area of Analyte signalConcentration of…

Q: 1. a. Calculate the mass of BaSO4 required to make 50.00 mL of a 0.1500 M solution. b. Calculate the…

A: Molarity is the amount of substance that is added in particular volume of solution. Molarity =…

Q: A volume of 25.00 mL of the original solution was diluted to a total volume of 100.0 mL and then…

A: If we take a definite amount of solution and then dilute it with by adding of water the mole of…

Q: Convert the amount of spiperone in each sample to the concentration in the 1 ml total volume of…

A: Explanation The molar concentration is expressed as  Molar concentration (M) = mole / Volume of…

Q: V. Results and Observation VI. Questions 1. How many colors separated from the black ink? 2. What…

A: It was observed that the black ink separated into different colors as the water gets absorbed in the…

Q: A stock standard of uric acid contains 100 mg/100 ml. A working standard is made by diluting the…

A: Stock standard of uric acid contains 100 mg/100 ml.  Which means 100 ml stock solution contains 100…

Q: 2. A stock standard solution of copper (1000.0 ppm) is available. How would you prepare 50.00 mL…

A: Concentration of stock solution(C1) = 1000.0 ppmVolume of stock solution(V1) =?Concentration of…

Q: The absorbance of a cationic iron(II) sample solution was measured in a spectrophotometer, but the…

A: Given  :----Initial volume = 100.0 μLDilution volume = 2.00 mL + 100.0 μLConcentration of diluted…

Q: By pipet, 15.00ml of the stock solution of potassium permanganate (KMn04) that was prepared by…

A: Mass of KMnO4 = 13.0 gm, Molar mass of KMnO4 = 158.034 gm/mol Number of moles of KMnO4 =

Q: You measure 1.5232 g of oxalic acid on an analytical balance, add it to a 250-mL volumetric flask…

A: moles of oxalic acid= concentration of oxalic acid x volume of oxalic acid used Given…

Q: A student weighed approximately 1.5 g of an unknown solid acid and carefully placed the sample in a…

A: Let the dibasic acid be H2Y It will be neutralized by NaOH in the following way:- H2Y + 2NaOH  =…

Q: If you prepared a solution of KOH by weighing out 4.750 g of solid KOH that had a purity of 84.6 %…

A: given, mass of KOH = 4.750 g purity = 84.6%

Q: When answering this problem, report the answer with the appropriate number of significant figures.…

A: In the given question we have to calculate the molar concentration of food dye.  we know that, the…

Q: Six clean, dry, 18 x 150mm test tubes 1-6 was labeled.  5.00 L of 2.00 x 10-3 M Fe(NO3)3 solution…

A: Please note the typo in your question.  Actually, we have to add, 5.00 mL, NOT 5.00 L of 2.00 x 10-3…

Q: In this experiment, the mass of pure copper provided is 0.491 gram, and then it was dissolved in…

A: Given Mass of pure Copper is 0.491 g. Volume of original solution as 100 mL. Volume of diluted…

Q: A student was given a stock ascorbic acid solution of 2.323 mg/L. Following the directions in the…

A: Concentration of stock ascorbic acid solution = 2.323 mg/L

Q: Suppose you wish to separate a mixture of fine particles of gold and sand, neither of which is…

A: The aim is to separate silicon dioxide (sand) and gold from their mixture and a scheme for this…

Q: A sample containing an unknown quantity of cadmium in a water sample gave a reading of 1.4 in an…

A: Given data: Reading for unknown water sample = 1.4, Concentration of known sample = 2 ppm, Reading…

Q: Starting from the primary standard solution in Question 4 and using the dilution scheme in Figure 1,…

A: The amount of solute that is dissolved in a specified volume of a solvent yields a solution. The…

Q: A solution is prepared by pipetting 25.00 mL of 3.0 x 10-4 M CaCl2 into a 750.00 mL volumetric flask…

A:

Q: When you walked in to Mrs. Bateast's lab today, you noticed that your partner group had a 0.05432 ml…

A: Given: Initial volume of mixture = 0.05432 mL. And volume of water added = 5.2 mL.

Q: In order to form Ba(IO3)2, 500 mL of 0.5000 M Ba(NO3)2 was mixed with 500 mL of 0.0500 M NaIO3.…

A:

Q: 1. Develop a detailed separation scheme for the separation and determination of the percent…

A: A mixture is a combination of two or more individual substances that may have uniform composition or…