An unbendingly held tie bar in a warming chamber has a width of 60 mm and is tensioned to a heap of 150 kN at a temperature of 15°C. What is the underlying pressure in the bar and what will be the resultant pressure when the temperature in the chamber has ascended to 50°C?

An unbendingly held tie bar in a warming chamber has a width of 60 mm and is tensioned to a heap of 150 kN at a temperature of 15°C. What is the underlying pressure in the bar and what will be the resultant pressure when the temperature in the chamber has ascended to 50°C?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Q1: For the retaining wall shown below, and for the following values: • Plot the pressure diagram…

Q: 8. An automobile tire is inflated to 32psig pressure at 50°F. After being driven, the temperature…

A: Given DataP1=32psiT1=50°F=283.15KT2=75°F=297.039KP2=? As Question Data is not enough to draw FBD

Q: -35%- The pressure in the automobile tire depends on the air in the tire. When the air temperature…

A: Given:T1=25°C =298 KPg1=210 kPaV=0.025 m3T2=50°C =323 KPatm=95 kPa

Q: Q3: An isolated rigid tank shown in Figure, contains helium. A paddle wheel with a power rating of…

A: let take content in the tank as a system, consider it as a closed system since no mass crosses the…

Q: A cylindrical vessel with a diameter of 8 inches and 5 feet long contained acetylene at 300 psi…

Q: If the initial volume of the gas is compressed to one-half its original volume and the new…

Q: Problem No.4 kg piston in a cylinder with diameter 100 mm is loaded with ng exerts no force on the…

Q: Consider an evacuated, insulated, rigid tank connected through a closed valve to a high-pressure…

Q: A steel cylinder bursts when the pressure inside the tank reaches 10,000 psi. It is filled with gas…

Q: A large room contains a volume of air of Va = 11 m3 at a temperature of Ta = 55° F. It also contains…

A: *As per our guidelines we are supposed to answer first three sub-parts of the question. Kindly…

Q: A piece of rubber block is placed in an open rectangular box made out of metal as shown in the…

Q: Helium is contained in a 2m^3 rigid tank at 50C and 200kPa. Calculate the heat transfer needed to…

Q: A frictionless piston-cylinder device contains 10 kg of water at 20°C at atmospheric pressure. An…

A: Given Data: The mass of water in the cylinder is: m =10 kg The initial temperature is: T = 20 0 The…

Q: The test tube opens at 293 K with 13 cm Hg at the bottom, and 5.6 cm water above Hg. Calculate the…

Q: the initial volume and temperature was 75 liters and 27 degrees respectively. if the final volume is…

Q: A constant volume container holds 10 kg of air at a temperature of 20°C and a pressure of 150 kPa.…

Q: Determine the internal forces acting in members, HC, JD, and KE. State if the members are in tension…

A: Drawing the free body diagram of the system as shown below,…

Q: An ideal gas expands at a constant total pressure of 3.0 atm from 460 mL to 660 mL. Heat then flows…

A: Given data: The initial pressure, P1=3 atm. The initial volume, V1=460 mL. The final volume, V2=660…

Q: Pre-lab 8: Cold Engine The experimental setup for this week's lab consists of a syringe connected to…

A: Given : To find :

Q: The fabrication shop at the university has a request to make a large outdoor barbeque cooker for…

Q: An aerostat balloon is filled with hydrogen. It has a volume of 1000m^3 at constant air temperature…

A: Aerostat balloons, often filled with lighter-than-air gases like hydrogen, are used to lift payloads…

Q: A thin spherical pressure vessel is required to contain 18 m3 of water at a gauge pressure of 700…

Q: What is the Temperature of 02 gas if it starts at 45oC and a volume of 7L and ends at a volume of…

Q: A mass of gas has a temperature of 150°C and volume of 0.2 m3. The temperature is changed to 50°C…

A: Given data: Initial condition: T1=150°C=150+273=423KV1=0.2m3 Final condition:…

Q: A closed vessel contains air at a pressure of 160kPag and temperature of 30°C. The air is heated at…

Q: A spherical steel tank of 22 m diameter contains gas under a pressure of 300 kPa. The tank consists…

A: Given: d = 22 m P = 300 Kpa t = 25 mm

Q: What is the resulting pressure when one pound of air at 15 psia and 20°F is heated at a constant…

A: Given data, P1= 15 psia =103.421 KPa T1=20°F =366.483 K T2= 800°F = 699.817 K

Q: Solve for the pressure differential in Pa if the temperature inside a 5.14m vertical wall is…

A: Calculate the pressure difference on the bottom of wall at the left and right wall

Q: Derive that AHAU+W for the constant pressure process. b

A: we need to prove the given relation.

Q: Initially, a gas is subjected to standard atmospheric pressure with a temperature reading of 289K…

A: Given: The temperature reading initially, T1 = 289 K The volume of gas initially, V1 = 2830…

Q: A bottle with a lid contains 0.0083kg of air at 64°C. If the volume of the air inside

Q: Two spheres each 3.0ft in diameter are connected by a pipe in which there is a valve. Each sphere…

Q: A thin-walled cylindrical pressure vessel has a diameter of 1.7 metres and contains gas at a…

Q: Q.2 A rod is made of cast iron and is secured to the piston by a tapered rod and nut and to the…

A: Given Cylinder diameter, D = 1.3 m Pressure, P = 0.25 N/mm2…

Q: In celebration of the end of term, see the symmetric wine glass of 300 g mass, as shown below. Note…

A: Consider first case: Draw the free body diagram of the glass: Consider the equilibrium of…

Q: You are in the compressed gas business as a science specialist and your company offers a wide range…

A: Given dataMass of Sulfur Dioxide = 1100 gramsVolume of cylinder = 8 L = 8 x 10-3 m3Temperature =…

Q: ample 3 (a) A sphere, 1 m internal diameter and 6 mm wall thickness, is to be pressure-tested for…

A: Step 1:Step 2:

Q: Figure Q3 shows the Nitrogen in the chamber at a pressure of 400 kPa. Determine the total force the…

Q: A spherical balloon filled with H2 gas to a volume of 3.35x10-2 m3 at 17 °C is carefully lowered…

Q: A closed vessel contains air at a pressure of 160 kPa gauge and temperature of 30°C. The air is…

A: Given, Initial gauge pressure of air, P1,g=160 kPa The initial temperature of the air, T1=30…

Concept explainers

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.

Question

An unbendingly held tie bar in a
warming chamber has a width of 60
mm and is tensioned to a heap of 150
kN at a temperature of 15°C. What is
the underlying pressure in the bar and
what will be the resultant pressure
when the temperature in the chamber
has ascended to 50°C?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Can you please help me answer this?
Please provide the correct solution including the free body diagram. Thanks
A rigid vessel of volume 0.5m 3 (Vessel X) containing hydrogen at 200K and a pressure of 60kPa is connected to a second rigid vessel of volume 0.8m 3 (Vessel Y) containing Argon at 300K at a pressure of 40kPa. A valve separating the two vessels is opened and both are cooled to a temperature of 150K. What is the final pressure (kPa) in the vessels?
Can you please help me answer this?
How can we analyze a spherical pressure vessel?
ii. At temperature T = 250C and pressure 2.25 bar, the volume of gas = 2.5 m3. Subsequently temperature increases to 750C while the pressure remains constant. The volume of gas under the change condition.
only correct answer
What is press vessels?Application of plane stresses in pressure vessels. Please explain briefly
' A rylindrical boiler with hemispherical ends has an outside diameter of 6 ft. lf the hoop and axialstresses in the boiler must be limited to 15 ksi and 8 ksi respectively, determine the thickness of steel plate required if the internal pressure in the boiler will be 200 psi.
Determine if the following is true/false. Provide the necessary solution The critical point for the specific volume is 0.00315 x103 m3/kg, 22.09 MPa and 374.140 Celsius
Topic: Fluid Statics and its Applications
I need the answer as soon as possible