An RTD forms one arm of a Wheatstone bridge as shown in the figure. The RTD is used to measure a temperature with the bridge is operated in a balanced mode. The RTD has a resistance of 250 at a temperature of 0°C and a thermal coefficient of resistance a=0.003925C-1. The value of the variable resistance R, must be set to 41.485 Q to balance the bridge circuit. Determine the temperature measured by the RTD where R2=R3=100N

Q: Employing the characteristic curve in Figure 1 and obtain the design for a voltage divider…

A:

Q: ?How many nodes in this circuit R₁ R₁ W

A: Circuit diagram is given as,

Q: VOLTAGE DIVIDER-6 SIMULATE THE CIRCUIT USING MULTISIM. FIND THE VOLTAGE IN EACH RESISTOR. GIVEN:…

A:

Q: +15 Vcc RC 1.5 k2 22 k2 ß = 150, R2 4.7 k. SRE 680 kN

A:

Q: How would you find total Resistance. I found Ra of R7,Rload, and R8 to be 12kOhms. Rb of R6 and Ra…

A: R7, Rload and R8 are series, Ra = 2 + 4 + 6 = 12 kΩRa and R6 parallel, Rb = 12 * 6 / (12 + 6) = 4…

Q: For the potential divider shown in the figure, VIN = 10 V, R1= 10k and R2=4.7 k Calculate the output…

A: Ans

Q: RL series has two resistors and two inductors. The Z of the circuit is 1000 ohms. The XL of the…

A: In this question , RL series circuit has resistors and inductors... Inductors values are given and…

Q: RI = 1200 V1 = ? V2 = ? V 3 ? Vth = ? Pmax = ?

A: In the given circuit the value of the voltage across the resistors, thevenin voltage and the maximum…

Q: /2 mvi2=Fkd m=0.5 vi = 0.2 d=0.7   solve for fk

A: Given -1/2 mvi2=Fkd  m=0.5  vi = 0.2  d=0.7

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.