An oscilloscope is set to 0.5 [V/ cm] vertically and 1 [s / cm) horizontally. Sketch the following traces using oscilloscope grid and upload as one pdf file. (a) Sketch the trace that would be seen if a 1.5 [V] cell was connected to the y-input. (b) Sketch the trace that would be seen if a square wave signal of with a frequency of 1 [Hz] and amplitude of 0.5 [V] (positive and negative) is connected to the input. Power Slope +/- ms/cm X-Pos. Hor ext. Ext. Level s/cm us/cm -Pos. V/cm V/crm Y-Pos.II CHI AC CHII AC CAL Illum. |/cm Intens. Focus 0,2 V Inv.I CHI/II Dual alt/chop

Q: A quantum cascade laser can be used to generate wave at 3.86 THz. What is the required energy gap…

A: We need to find out energy band gap for given laser .

Q: 4) The pulsed cosine signal shown in the following figure is "on" for two cycles and then "off" for…

A: Frequency Spectrum: No of cycle 18, frequency=200pi rad/sec limit -10 to 10 To find:  Sketch…

Q: 2) What is the area under the signal x(t) = 4sinc²(3t)?

A:

Q: Figure (1) shows the block diagram of a wideband frequeney modulator using the indirect method, This…

A:

Q: An oscilloscope is set to 0.5 [V/ cm] vertically and 1 [Ss / cm] horizontally. Sketch the following…

A:

Q: 3. Find no and Po, and locate the Fermi level. Draw the energy band diagram. a. b. Silicon is doped…

A: Refer explanationExplanation:

Q: When comparing the 1st waveform and the 2nd waveform, what control on the oscilloscope has changed?…

A: Digital oscilloscope is very important to while designing and analyzing the electrical circuits at…

Q: When the time basis signal is set to div/1usec, find the time required to scan the screen.

A: Note : Number of division is not given taking the number of division as 10. Time set basis signal is…

Q: An oscilloscope is an extremely effective instrument to study the characteristics of waveforms. The…

A: Oscilloscope or generally known as CRO are an graphical dispaly which can display 2D graphs of an…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.