An operational amplifier is to be used with positive feedback to produce a Schmitt trigger circuit. If resistor, Rl = 10k2 and resistor, R2 = 90kO, what will be the values of the upper and lower switching points of the reference voltage and the width of the hysteresis if the op- amp is connected to a dual +10v power supply. Given: R1- 10KO, R2 - 90k2. Power supply +Vcc - 10v and -Vcc=-10v.

An operational amplifier is to be used with positive feedback to produce a Schmitt trigger circuit. If resistor, Rl = 10k2 and resistor, R2 = 90kO, what will be the values of the upper and lower switching points of the reference voltage and the width of the hysteresis if the op- amp is connected to a dual +10v power supply. Given: R1- 10KO, R2 - 90k2. Power supply +Vcc - 10v and -Vcc=-10v.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Calculate and plot on a drawing the force experienced by each of the electrical charges in the following configuration: with Q = 160000.10^-19 C and d = 5 cm. Please answer in typing format please ASAP for the like please clear the solution of above
i. The saturation voltage an op-amp is primarily controlled by(i) power supply (+Vcc and -Vcc)(ii) open-loop gain of the op-amp(iii) common mode gain (iv) slew rate
A certain op-amp has two internal amplifier stages with the following gains and critical frequencies; Av1 = 50 dB, Av2 = 25 dB, fc1 = 1500 Hz, and fc2 = 3000 Hz. Determine the open loop midrange gain in decibels and total phase lag when f = fc1....
What will be the CMRR of an opamp if the value of the common mode gain is 100 and the value of the difference gain is 106?
6) i need fast please now
QUESTION: Input 1 C. Input 2 E Output Differential Amplifier Figure 2-3: Differential amplifier 2 1. As shown in figure 2-3, what will be the output signal given the following input signals: a. Input 1 = 5Vp-p and input 2 = 2Vp-p -3Vp-p 7Vp-p b. Input 1 = 5Vp-p and Input 2 = -2Vp-p -3Vp-p 7Vp-p Input 1 = -5Vp-p and Input 2 = 2Vp-p -3Vp-p 7Vp-p d. Input 1 = -5Vp-p and Input 2 = -2Vp-p -3Vp-p 7Vp-p 3Vp-p 3Vp-p 3Vp-p 3Vp-p -7Vp-p -7Vp-p -7Vp-p -7Vp-p
1-C) Which op-amp IC is more suited for digital applications, and why?1-D) Which op-amp IC is more suited for instrumentation applications, and why?
An op-amp has an open-loop gain of 105 and an open-loop upper cutoff frequency of 10 Hz. If this op- amp is connected as an amplifier with a closed-loop gain of 100, then the new upper cutoff frequency is