An operating test of a steam turbine produces the following results. With steam supplied to the turbine at 1350 kPa and 375°C, the exhaust from the turbine at 10 kPa is saturated vapor. Assuming adiabatic operation and negligible changes in kinetic and potential energies, determine the turbine efficiency, i.e., the ratio of actual work of the turbine to the work of a turbine operating isentropically from the same initial conditions to the same exhaust pressure.

Q: In a gas-turbine plant working on a Brayton Cycle, the air at the inlet of the compressor is at 25C…

A: Ideal gas Brayton cycle for gas-turbine plant contains 4 processes: A-B adiabatic reversible…

Q: Consider a gas power cycle has a pressure ratio of 8. Air enters the compressor at pressure of…

A: Given:  Pressure ratio=8  P1=100 KpaT1=27°C=300 KV1=1.5 m3/sT3=1500 Kηc=0.8ηT=0.83

Q: exit velocity and what is the cross-sectional area at the nozzle exit f

A:

Q: A reversible engine converts %th of the heat input into work. When the temperature of the heat sink…

A: GivenA reversible (Carnot) engine with efficiency (η) of 16, or 0.1666New efficiency when…

Q: Q2: A closed cycle gas turbine unit operating with maximum and minimum temperatures of 760°C and 20…

A: The closed cycle gas turbine works on the Brayton cycle. This has reversible adiabatic compression…

Q: There are three thermal energy reservoirs that are being used by a reversible engine, namely X,Y,…

A: Given that, An equal amount of heat is being absorbed by the engine from reservoirs X and Y Qx = Qy…

Q: 81-100. The power output of an adiabatic steam turbine is 5 MW, and the inlet conditions are given…

A: Note- We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: A power plant involves thermodynamic cycles to generate electrical power. In the first stage, water…

A:

Q: 100 kg/s of superheated steam at 653.15 K and 8800 kPa enters a turbine and leaves as saturated…

A: Note: Since we are entitled to answer only 3 sub-parts, we will the first three. Please re-submit…

Q: Air compressor Steam turbine

A: Answer. Data given below:-

Q: Air enters a compressor operating at steady state at 1.05 bar, 300 K, with a volumetric flow rate of…

A:

Q: ca gas Wi 2. Steam at 2500 kPa and 350° C enters a turbine and leaves at 10 kPa. The turbine…

A:

Q: Q2) A 100 MW power plant uses the lake water at 20°C to condense the steam in a boiler operating at…

A: 100 MW Temperature = 20 °C Boiler operating temperature = 800 °C Heat Capacity of water = 4.184 J/gK…

Q: In a Rankine cycle, steam enters the turbine at 8400 kPa and 350°C. The total condenser (i.e. exit…

A:

Q: Compressed air at room temperature (295 K) is contained in a 20-L tank at 2 bar. The valve is opened…

A:

Q: An adiabatic steady-state turbine is operated reversibly to generate energy. The inlet to the…

A: Energy is generated by expansion of steam through a reversible, adiabatic turbine.

Q: 18. The thermal efficiency of a rev reservoirs is 0.4. The device is used either as a refrigerator…

A: This question is based on chemical engineering thermodynamics. Let the two thermal reservoirs be at…

Q: Air enters a compressor operating at steady state at 1.05 bar, 300 K, with a volumetric flow rate of…

A:

Q: For the given question and solution, for part (b), finding the work input  of the saturated vapour…

A: A compressor is used to compress steam at two different phase of steam.

Q: 4. Steam enters a throttling valve (i.e. Joule-Thomson expansion) at 350 °C and 2 MPa, and leaves…

A: Steam inlet temperature = 350oCSteam inlet pressure = 2 MPaSteam outlet temperature = 300oCSteam…

Q: You are an engineer in an electric-generation station. You know that the flames in the boiler reach…

A: In an electric generation system, electricity can be produced by various different methods. One of…

Q: A heat engine operates between a heat-source reservoir at a T = 535 K and a heat-sink reservoir at a…

A: Given TH=535 K TC=315K ηth=0.38 ηC

Q: Q1: Steam flows through a device with a stagnation pressure of 900kpa, a stagnation temperature of…

A: Given: Stagnation pressure P0= 900 kpa Stagnation temperature T0= 371 °C Velocity= 275 m/s, Cp=…

Q: 1.Steam enters an adiabatic turbine at 4MPA and 600C and exits at 40 kPa. If the efficiency of the…

A:

Q: An imaginary Carnot Engine has an intake temperature of 1°C while its intake temperature is…

A: we know that,  Engine Efficicieny = 1 - Exhaust TemperatureIntake Temperature If Intake Temperature…

Q: 3. Assume 5 kg of steam initially at 8 MPa and 100% quality are heated at constant temperature. If…

A:

Q: A & B are rigid tanks. Tank A has volume of 1 m, contains steam with 4 MPa and 500 °C heated by…

A:

Q: Q3: Assume ideal gas behavior, and compute the reversible work required to compress a natural gas…

A:

Q: A nuclear power plant generates 750 MW of power.The heat engine uses a nuclear reactor operatingat…

A: Given that :W  = 750 MWT1  = 315 C = 588.15 KT2  = 20 C = 293.15 KVolumetric flow rate ,Vo   =  165…

Q: Consider the PV diagram as shown above when a thermodynamic system changes its state from state a to…

A: given that for the path acb heat flows into the system (Q1)=120 J work done by the system (W1)=-50 J…

Q: Consider a reheat-regenerative vapor power cycle with two feedwater heaters, a closed feedwater…

A: Entry Pressure = 8000 kPa Temperature = 480 oC Expands to 700 kPA Reheated steam temperature = 440oC…

Q: Case Study: Two AES exchangers in series have difficulty heating a process stream from 50°C to 90°C…

A: To increase or decrease the temperature of the fluid, we will make this fluid run through the heat…

Q: In a Brayton power cycle with a compressor isentropic efficiency of 83% and a turbine isentropic…

A: