An open tank has a 3 m square horizontal section and weighs 3.5 kN. It contains water to a depth of 1.0 m. An unbalanced force of 15 kN is applied to the tank parallel to one of the pair of sides. Determine the minmimum height in meters of the tank in order to prevent any spillage.

Q: 1 m A rectangular gate 1.6 m wide is used as a partition as shown. One side has linseed oil filled…

A: Given data in question  Depth Specific gravity  Width of gate To find out  Pressure on right side of…

Q: A half parabolic gate 3m in tall and 1m wide is submerged and there are two different liquid on each…

A: Given- hg=3mb=1mGL=0.85GR=1.00

Q: A rectangular tank 10m long by 2m deep by 5m wide contains Im of water. If the linear acceleration…

A:

Q: Q- An orifice is located in the side of a tank with its centre 10 cm above the base of the tank. The…

A: Given- Height of orifice h=10 cm=0.10 m, Water level height H=1 m, Coefficient of velocity C=0.98,…

Q: Q3/ Three opening of head regulator with 2 m each. The head between US and DS equals to 1.75 m. and…

A: 3 head regulator with 2m each head h= 1.75 mvertical opening = 2.5 mCd = 0.62need to find1- the…

Q: Gas having an internal pressure of 4 MPa is housed in the 3-meter-high pressure tank below. It…

A: A tensile Stress acting in the direction tangential to circumference is called circumferential or…

Q: Q2:B) Calculate the power required to pull (1.5m x 1.5m) flat plate at speed (1 m/s) to the left…

A:

Q: reynolds number b.) total head lossv(m) c.) gage pressure at 1

A: Gauge pressure: - It is defined as the extra pressure to a system with respect to local atmospheric…

Q: Determine roller support reaction

A: Given data : The value of uniformly distributed load q=36 KN/m The value of uniformly varying load…

Q: Determine the Furall hydrostatic force acting on the gate shown below. The tank is Gm wide- i Sea…

A: Width of gate = 6 mRadius of gate = 6 mOil of depth 2 m above water of depth 5m a ove gate.

Q: horizontally along its length just before any liquid

A: Data given Height of tank, H=10.61m length of tank, L=8.66m width of tank, W=3.66m Depth, D=7.56m…

Q: Compute the reaction of the roller support of Beam CD. 10 KN 20 KN / m 5 KN / m А В 5 KN / m 50 KN-m…

A:

Q: 12 KN/m 10KN/m A 8 m 7 m

A:

Q: A- ال 13 الحل Determine the pressure head, elevation head, and total head at A, B, and C for the…

A: Total head = Pressure head + elevation head  Take ponit B  Elevation head = 1.4  - . 5 = 0.9 m…

Q: R1 50 kN 2m m 20 kN/m 10 kN/m 7m R₂ 40 kN 3 m

A:

Q: • Given the beam as shown: 50 kN Determine: 20 kNm a.) Reaction at A. A B D b.) Reaction at B. 3 m…

A:

Q: Find roller support reaction

A: Given data : The value of Point load P=18 KN The value of uniformly varying load w=0 to 3 KN/m…

Q: I- A rectangular tank om long, 2.5m wide and 2m deep contains wader filled to Im deep. If the linear…

A:

Q: A pump draws water from a 20 cm diam suction pipe and discharges through a 15 cm diam pipe in which…

A: Given,

Q: rectangular tank 4 m long. ater pressure on the base of the tank. Find also the depth of centre of…

A:

Q: Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level…

A:

Q: Water flows downward in a pipe at 30°. The pressure drop P₁ - P2 is partly due to gravity and partly…

A: Given- Height difference=50 cm, Water flow in the pipe with parameter shown in the figure. It is…

Q: 45. A 1-meter-diameter cylinder is connected to a 2-meter-wide rectangular gate as shown. The gate…

A: y = 4 m d = 1 m h = 2.5m

Q: H-W1 Q1/ Neglecting losses, determine the discharge in Fig. below Oi so 075 Q2/When the pump in Fig.…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: . A rectangular tank 2m long, 1.5m wide and 1.5m deep is filled with oil of specific gravity 0.8.…

A:

Q: A 1.2m diameter open vessel, 2m high is filled with oil s.g = 0.85 at a depth of 1.6m and rotated at…

A:

Q: The hydraulic cylinder extends at 0.5 m/s and determine the angular velocity and the angular…

A: The given figure is shown below:

Q: ա 9

A:

Q: Determine roller support reaction

A: Given data : The value of Point load P=5 KN The value of Point load Q=8 KN The value of Point load…

Q: The weight and diameter of the block are 56,12 kN and 1 m, respectively. Determine the height of H…

A:

Q: The impeller of the centrifugal pump is 350 mm diameter, and the width of the blade passages at…

A:

Q: .) For the tank shown below (width = 1.25 m), determine (6.a) the maximum horizontal acceleration…

A:

Q: 不 1 m 1.5 m 3 m E Air, p = 32 kPa Oil, s = 0.80 Water Glycerin, s = 1.26 LL F cg 60° D

A: