An open tank consists of 3 immiscible liquids, in which the water is at the height of 200 cm, above which a crude oil of specific gravity of 0.9 is filled up to a height of 3400 mm, above which a coconut oil of specific gravity of 0.88 is filled for about 4 m. Find (i) the intensity of pressure in kPa at the interface between coconut oil & crude oil (ii) the intensity of pressure in MPa at the interface between crude oil & water (iii) the intensity of pressure in N/cm² at the bottom of the tank. Solution: The intensity of pressure at the interface between coconut oil & crude oil (unit in kPa) = The intensity of pressure at the interface between crude oil & water (unit in MPa) = The intensity of pressure at the bottom of the tank (Unit in N/cm²) =

An open tank consists of 3 immiscible liquids, in which the water is at the height of 200 cm, above which a crude oil of specific gravity of 0.9 is filled up to a height of 3400 mm, above which a coconut oil of specific gravity of 0.88 is filled for about 4 m. Find (i) the intensity of pressure in kPa at the interface between coconut oil & crude oil (ii) the intensity of pressure in MPa at the interface between crude oil & water (iii) the intensity of pressure in N/cm² at the bottom of the tank. Solution: The intensity of pressure at the interface between coconut oil & crude oil (unit in kPa) = The intensity of pressure at the interface between crude oil & water (unit in MPa) = The intensity of pressure at the bottom of the tank (Unit in N/cm²) =

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 12.5 kg block of metal measuring 12.0 cm by 10.0 cm by 10.0 cm is suspended from a scale and immersed in 5.60 cm below the surface of the water. Scale a b (a) What are the magnitudes of the forces (in N) acting on the top and on the bottom of the block due to the s significant figures.) Frop N N Fbottom (b) What is the reading of the spring scale (in N)? N (c) Show that the buoyant force equals the difference between the forces at the top and bottom of the block. ( II
A manometer showed in Fig. 1 (right) connects pipe A and pipe B. It reaches a balance at the showing state. Determine a) When the pressure in pipe A is increased from the current state by 32 kPa while the pressure in pipe B remains constant, the interface between water and mercury in the left leg of the manometer will go up or down? b) Calculate the change in the elevation of this interface.
Given an atmospheric pressure of 16.5 psia and an absolute pressure of 30.5 in. Hg, make these convertions: (e) 45 psi vacuum to psia and to Pa (f) 38 psia to atmospheres, and to in. Hg abs (g) 13 psi vacuum to Pa and to atmospheres (h) 8 in. Hg gage to psia, and to Pa
The pressure intensity at a point in a fluid is given 3.925 N/cm². Find the corresponding height of the fluid when the fluid has specific gravity 1.
Two ends of an U-tube manometer which contains mercury, is connected between two pipes (A & B) that carries oil of specific gravities 1.5 & 1.4 respectively. The center of the pipe B (right limb) is 14 cm above the pipe A (left limb). The mercury level difference in the Left limb is 2 cm, and the height of fluid in the left limb is 5.8cm, find the pressure difference between these two pipes in Pascal. Draw the diagram. The difference of pressure between the pipes A & B in (Pascal) =
2. There is a liquid having density of Np below a liquid of density p (N is an unknown constant). A piston of a rectangular cross section (width H into the page) is attached to a completely submerged sphere of density e/3 and volume 4/2H3, with a pulley attachment as shown in the figure. The piston surface has a 45° angle with respect to the horizontal direction and a 90° angle with the pulley cable. It is measured that the within the piston is atmospheric. pressure (a) Identify all the forces applied to the piston surface, and mark them on a free body diagram. Accurately indicate their points of action. (b) Evaluate N if all the forces applied to the piston surface balance. Air P/3 2H g Piston surface Np H
Find the pressure at the bottom of a tank containing a 3 m thick layer of mercury, a 2 m thick layer of water, and a 4 m thick layer of oil (D = 700 kg/m3). The tank is open to the air.
Find the resultant hydrostatic force on plate AB and its location from B. Gama water = 10 kN/m^3. The width of the plate is 1.5 m 2 m A 145° 2m B
Must answer both A and B
Chemistry The contact angle for water in a clean glass is zero. Calculate the surface tension of waterin a 0.3 mm diameter vertical tube if the water rises to a height 4.96 cm above the liquidoutside the tube, knowing that specific gravity of water equals 998.2 kg/m 3 and theacceleration due to gravity equals 9.806 m/sec2
Example:A micrometer, having a ratio of reservoir to limb areas as 40, was used to determine the pressure in a pipe containing water. Determine the pressure in the pipe for manometer reading shown in Figure. Limb Reservoir: 79 - unu 08