AMoving toestion 42An open cylindrical tank 45 cm in diameter and 135 cm tall is full of water and revolved about its own vertical axis at constant angular speed. What will be the depth of water (in meters) in thetank when it is brought to rest from an angular speed of 200 rpm?Round off to three decimal places.«< Question 42 of 48> >A Moving to another question will save this response.F10F11F12DELETEPAUSEFBESF6w ERTBREAF2F4%&NUM LK@%2386{PQRYENTERALGHJKSHIFTVBMV

Answered: Image /qna-images/answer/d4af18ba-03b8-411f-ba22-e7437921996d.jpg

Answered: An open cylindrical tank 45 cm in tank…

An open cylindrical tank 45 cm in tank when it is brought to rest from an angular speed of 200 rpm? Round off to three decimal places. A Moving to another question will save this response.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 3. Determine the slope and vertical displacement of point A on the beam shown in the accompanying…

Q: Barry is observing a bird on the ground 50m away from him. The bird flies away at an angle of 60°…

Q: The pump in the figure discharges water at 45 lit/s, Neglecting losses and elevation changes, 1.…

Q: 100 mm 120 mm 50 mm 180 mm

A: Given Data: The width of the rectangle is b1=180 mm. The height of the rectangle is h1=50 mm. The…

Q: Calculate the harmonic mean speed in kil ometers per hour.

A: Given, Distance and time observation data for various vehicles To find : Harmonic mean speed

Q: 01/Water poured into a conical tank through a faucet, this tank has a base radius of 5 ft and 10 ft…

Q: A ball is thrown so that it just clears a 3m fence 18m away. If it left the hand 1.5m above the…

Q: The speed of the tip of the minute hand on a town clock is 1.75 103 m/s. (a) What is the speed…

A: Speed of tip of minute hand=1.75mm/sec

Q: Assume an intercontinental ballistic missile goes from rest to a suborbital speed of 7.75 km/s in 1…

A: Average speed=7.75 km/sec, Average time=1 min=60 sec, Acceleration due to gravity(g)=9.80 m/s2.

Q: A pulley with an initial angular velocity w, of 40 is accelerated 10 rad for 6 sec. What is its…

Q: The mass of the cart is 500g. A mass of 300g is added to it. The measured time for the cart to…

A: Distance traveled,s=45cm Taken time,t=0.5sec Initial speed,u=0

Q: 20 ft/s 10 ft

Q: A frisbee completes 100 revolutions every 5 seconds. What is the angular velocity of the frisbee in…

A: No. Of revolution: 100 Time taken: 5 sec To determine: angular velocity ( rad/s)

Q: Water enters a 11 horizontal nozzle with a square cross section of 18 by 18 at a speed of 11. The…

Q: 250 m 45° 162 kph 144 kph 300 m 30°

Q: Required information A garden hose attached with a nozzle is used to fill a 20-gal bucket. The inner…

A: Given data,Bucket volume=20 galinner dia of hose=1 inat nozzle exit hose dia is 0.4 inaverage…

Q: . An object is moving with an initial velocity of 20 m/s. If it is decelerating at 5 m/s, how far…

A: Given data- Initial velocity (u) = 20 m/s Deceleration = 5 m/s2 , acceleration (a) = (-5) m/s2 Final…

Q: From a videotape of a football player kicking a long field goal, it was observed that the ball…

A: Given: The distance traveled by the ball is 185 ft. The time of flight is 2.8 sec.

Q: A liquid full is to be rotated in the vertical plane. What minimum angular velocity in radians/sec…

A: Solution is attached below

Q: A ball is thrown upward from the ground with a speed of 40??/???; at the same instant another ball…

A: Draw FBD for ball thrown upward condition:

Q: 2" 3" 3"

A: To find moment of inertia bot base a-a

Q: A train brakes from 80 m/s to a stop over a distance of 150 m. How much time does it take to put the…

A: Given Initial velocity = u = 80m/s Final velocity = v = 0m/sec Distance travelled = s= 150m

Q: 250 m 162 kph 45° ablue, n 300 m 144 kph ared, n 30°

Q: The blade shown in the figure below is 1 ft wide and is intended to skim oil (SG = 0.9) floating on…

A: Given data: width = 1ft SG = 0.9 skim of 8in speed = 8ft/sec

Q: What is the range of reaction distances for a car traveling at 70 miles per hour? (Use the lower end…

Q: Part A The ball at A is kcked with a speed vA- 15 ft/s and at an angle 30". Assumo the ground has…

A: Given Data : Speed of the ball at point A, v = 15 ft/s Hit angle, 0 = 30° Equation of parabola…

Q: 1. In which of the following does deceleration take place? * a. A bullet fired from a pistol. b. A…

A: Acceleration is the increase in velocity per unit time. It's S.I unit is m2/sec. Whereas,…

Q: Quèstion 42 A 10.0-kg box is pulled along a horizontal surface by a force of 40.0 N applied at a…

Q: A technician at a construction site accidentally drops a concrete block with a mass of 8 kg from a…

A: Mass = 8 kg H = 10 m Acceleration due to gravity = 9.81

Q: An open cylindrical tank 1.1 meter in diameter and 2.4 m high is 3/5 full of water. If the tank is…

A: A fluid which flow revolves around an axis is called vertex flow. Forced vertex and free vertex flow…

Q: A tank of water in the shape of a cone is being filled with water at a rate of 12 m3/ sec. The base…

Q: A golf ball is struck with a velocity of 80 ft/s as shown. Determine the speed at which it strikes…

Q: 4. An iPhone is thrown vertically upward and returns to earth in 10 sec. How high dio go (in m) and…

Q: 2. Sketch the velocity-versus-time graph from the following position-versus-time graph. Position vs.…

A: The expression for velocity is given by, Velocity=DistanceTime

Q: You are working at a radar station for the Coast Guard. While everyone else is out to lunch, you…

A: Use Cosine Rule To Find out the Distance of Sinking Ship from Various Ships And then time taken by…

Q: 5. The tank shown in the accompanying fig filled by Pipes 1 and 2. If the water level constant, what…

A: The diameter of the pipe (1) is d1 = 1in The diameter of the pipe (2) is d2 = 1.75in The diameter…

Q: Why does the concept of Theftia pressure become invalid in the case of "instantaneous" closure of a…

A: Solution: Inertia pressure or inertial pressure concept is actually defined as an empirical…

Q: Water flows in a pipe, a 30mm x 25mm reducer is connected to change the speed of the water, if the…

Concept explainers

Thermal Processes

Some of the key areas where thermal processes find their application are:

Question

AMoving to
estion 42
An open cylindrical tank 45 cm in diameter and 135 cm tall is full of water and revolved about its own vertical axis at constant angular speed. What will be the depth of water (in meters) in the
tank when it is brought to rest from an angular speed of 200 rpm?
Round off to three decimal places.
«< Question 42 of 48> >
A Moving to another question will save this response.
F10
F11
F12
DELETE
PAUSE
FB
ES
F6
w ERT
BREA
F2
F4
%
&
NUM LK
@
%23
8
6
{
P
Q
R
Y
ENTER
AL
G
H
J
K
SHIFT
V
B
M
V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A particle travels along a straight line with an acceleration of a = (10 - 0.2s) m/s", where s is measured in meters. Determine the velocity in m/s if the particle when s - 10 m, if v = 5 m/s at s = 0. • Previous Next Quiz saved at 11:34am Submit Quiz
(fluid mechanics question) Diesel fuel with a specific gravity of 0.8, flows through the Venturi meter shown in figurebelow. If viscous effects are negligible, determine;a) the elevation, hb) the volume flow ratec) the mass flow rateParameters given for the velocity, the distance and the angle as (m/s), (cm) and (degree)respectively, V=49, h1=12x9, h2=4x4, D1=24, D2=14, angle=0
A container for an emergency beacon is a rectangular shape 31.75 in wide, 40.55 in long, and 20.20 in high. Its center of gravity is 9.55 in above its base. The container weighs 253 lb. Required Calculate ymc to the nearest 100th of an inch. Also state if the box will with the 31.75-in by 40.55-in side parallel to the surface in plain water is STABLE or UNSTABLE in the units box.
Qlu Jui fwis20e1085@uoanbar.edu.iq i i مطلوب Note : Attempt All Questions 25 Q1) A train accelerates from rest to 30 Km/h in the first 0.5 minute. (a) what is the average acceleration? (b) suppose the train slows to stop from a velocity of 22 Km/h in 10 seconds, what is the average acceleration? Note that the acceleration calculated in m/s2 University of Anb. acer
:If speed is equal to 35 mph, then perception reaction distance would be 200 ft O 129 ft 125 ft
please put some illustrationAn open cylindrical vessel 1.2m in diameter and 2.1m high is 2/3 full of water. Compute the amount of water in liters that will be spilled out if the vessel is rotated about its vertical axis at a constant speed of 90rpm.
5. The engine of lunar lander is shut off when the lander is 5.0 m above the surface of the moon and descending at 2.0 m/s. If the acceleration due to gravity on the moon is 1.6 m/s2, what is the speed of the lander just before it touches the surface? (Hint: Make a diagram. Consider vector directions)
! Required information The boom of a fire truck raises a fireman (and his equipment-total weight 290 lbf) 38 ft into the air to fight a building fire. Calculate the work done by the boom on the fireman in units of Btu. (You must provide an answer before moving on to the next part.) The work done by the boom on the fireman is 14.17 Btu.
Which car car showed the greatest acceleration going to the right (horizontally)?
The blade shown in the figure below is 1 ft wide and is intended to skim oil (SG = 0.9) floating on water with the resulting stream to be caught in a holding tank to clean-up an oil spill. If the skimmer is set to skim off a 9-in. layer of fluid, and all of the fluid skimmed is oil, how much power (hp) must be provided to drive the skimmer at a speed of 9 ft/s? 60% i ! hp Power =