An oil-water SS displacement experiment was carried out on a 5.0 cm long and 3.0 cm diameter sandstone core plug taken from Duyung-1 well in Terengganu. The porosity of the plug is 25% and the grain density is 2.65 g/cm3. Oil and water densities are 0.85 g/cm3 and 1.05 g/cm3, while viscosities are 2.0 cP and 1.0 cP, respectively. The differential pressure for the test is 12.94 psi. Other data are provided in the following table. Calculate and plot the oil-water relative permeability data and expla

Q: If porosity is 0.3 find void ratio.

A:

Q: During the 1-dimensional consolidation test, the following measurements were m Before commencement…

A: Disclaimer- According to my calculation right answer is differing from the above given choices ,so i…

Q: A fully saturated clay specimen is placed in a consolidometer and subjected to a loading c 200…

A:

Q: Question 6.4 a) A core sample with a diameter of 1.2 in and a length of 1.8 in is saturated with…

A:

Q: During an oedometer test on a specimen of saturated clay, the thickness of the specimen decreased…

A: Solution; Given that; Oedometer test; Change in thickness of specimen  ∆H=19.931-19.720∆H=0.211…

Q: The dry bulk density (pb) of a sample is found to be 1.65 g/cm3. What is the porosity?

A:

Q: Problem 3: For a sandstone reservoir, calculate the water saturation if the porosity (Ø) is (20 %),…

A:

Q: Experimental data for clay specimen obtained initial values of e1 = 1.12 and P1 = 90 kPa, and final…

A: Given- e1 = 1.12 e2 = 0.90 P1 = 90 kPa P2 = 460 kPa To Find -  Coefficient of volume…

Q: Does a positive presumptive test indicate that water is potable?

A: A screening test called the presumptive test is used to check a water sample for the existence of…

Q: A student conducted 2 UU triaxial tests on Kaolin clay samples in the laboratory. Table 1 provides…

A:

Q: Q.4(a)(i) A laboratory consolidation test on a normally consolidated clay showed the following…

A:

Q: A consolidated undrained triaxial test was conducted on a normally consolidated clay. Following are…

A: Given; Cell or chamber pressure=200+x kN/m2 Deviator stress at failure=300+x kN/m2

Q: The height of the capillary rise of water increases as particle diameter increases True O

A: Ans: False Explanation:  In the soil, usually, as the grain size decreases the size of the voids…

Q: In a triaxial test, total increament in cell pressure and total increament in deviator stress are…

A:

Q: The time required for a 50% consolidation of a 25mm thick layer drained both sides is  2 min 20…

A: Given: For 50% consolidation of a 25 mm thick layer having drainage both side , time required is…

Q: Experimental data for clay specimen obtained initial values of e1 = 1.12 and P1 = 90 kPa, and final…

A:

Q: Following are the results of a laboratory consolidation test on a sample of undis- turbed clay…

A: Compression index is normally the variation of void ratio from the replace of effective stress…

Q: A consolidated-undrained triaxial compression test was performed on a normal consolidated clay…

A:

Q: In an oedometer test, a clay specimen initially 25 mm thick attains 90% consolidation in 10 minutes.…

A:

Q: Cc = 0.2 and An oedometer test on a saturated clay soil gave the following results: Cs = 0.04. The…

A: Vertical effective stress, Increase in vertical stress, Water content, Thickness, To find:…

Q: 1.) DERIVED THE FORMULA OF THE VOID RATIO, 2) DERIVED THE FORMULA OF POROSITY, n = V/v = W - W

A:

Q: a sand sample is subjected to direct shearing testing at its normal in (situ) water content. two…

A: Since we answer one question at a time so we will answer the first one. Please resubmit another…

Q: A consolidated undrained test was conducted on a clay speci- men. The consolidation and chamber…

A: From first specimen-σ1=σ3+σd

Q: A laboratory consolidation test on a 25 mm thick normally consolidated clay specimen showed the…

A:

Q: A dry sandstone sample of diameter 22 mm and length 35 mm weighs 32 g. the sample is crushed and a…

A: Pycnometer method is used for the determination of specific gravity of dry soil sample. It is a very…

Q: 3- The time for 65% consolidation of a 1.12-inch clay specimen (drained at top and bottom) in the…

A:

Q: a）For clays, the failure line (one that connects the peak failure stresses) in the normally…

A: A)Cohesion is the stress of binding together, in soil mechanics the cohesion means shear strength…

Q: Determine void ratio Porosity=0.142

A: Given data : The value of porosity=n n=0.142   Required : Void ratio

Q: The coefficient of permeability of the sand at a void ratio of 0.62 is 0.03 cm/s. The permeability…

A:

Q: On close investigation of a sample it was found to be in three layers 20mm, 60mm, and 40mm. The…

A:

Q: A CU triaxial compression test was performed on saturated sand at a cell pressure of 100 kPa. The

A:

Q: An onshore well is drilled on dry land with no water above the ground surface. An offshore well is…

A: This question is related to Soil Mechanics from Civil Engineering. In this question ask about the…

Q: consolidated-undrained test was conducted

A:

Q: Determine the value of void ratio if porosity is 0.402 a:0.65 b:0.69 c:1 d:0.67 e:None of the above

A:

Q: A consolidated-undrained triaxial test was conducted on a saturated, normally consolidated clay. The…

A: σ3=13 lbin2σ1=32lbin2u=pore  pressure at failur=5.5 lbin2now effective stresses can be…

Q: The water content of a sample of saturated soil at a mean effective stress of 10 kPa is 85%. The…

A: