An oil pump operating at steady state delivers oil at a rate of 10 lb/s through a 1-in.-diameter exit pipe. The oil, which can be modeled as incompressible, has a density of 70 lb/ft3 and experiences a pressure rise from inlet to exit of 40 lbf/in2. There is no significant elevation difference between inlet and exit, and the inlet kinetic energy is negligible. Heat transfer between the pump and its surroundings is negligible, and there is no significant change in temperature as the oil passes through the pump. Determine the velocity of the oil at the exit of the pump, in ft/s, and the power required for the pump, in hp. Step 1 Determine the velocity of the oil at the exit of the pump, in ft/s.

An oil pump operating at steady state delivers oil at a rate of 10 lb/s through a 1-in.-diameter exit pipe. The oil, which can be modeled as incompressible, has a density of 70 lb/ft3 and experiences a pressure rise from inlet to exit of 40 lbf/in2. There is no significant elevation difference between inlet and exit, and the inlet kinetic energy is negligible. Heat transfer between the pump and its surroundings is negligible, and there is no significant change in temperature as the oil passes through the pump. Determine the velocity of the oil at the exit of the pump, in ft/s, and the power required for the pump, in hp. Step 1 Determine the velocity of the oil at the exit of the pump, in ft/s.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In the figure for this question an ideal Brayton cycle is described in the pv diagram data - The gas operating in the cycle is air. - The circulating air flow is 1 kg/s - The pressure ratio of the circulation is 10 T3 = 1,400 K, T2 = 580 K - - The specific heat coefficient of the gas at constant pressure is: Cp= 1004 j/ kg -K - The ratio between the specific heat coefficient at constant pressure and the specific heat coefficient at constant volume is y = 1.4 A. State which processes occur between the points marked in the figure: 4-3, 3-2, 2-1 and - 1-4 Indicate for each of the processes whether during it heat was absorbed or heat was emitted. B. Calculate the thermal efficiency of the cycle. C. Calculate the power of the heat absorbed in the cycle. d. Calculate the cycle power
What point is I13 ?
Do number 13.12
P1.60 A block of weight W is being pulled over a table by another weight Wo, as shown in Fig. P1.60. Find an algebraic formula for the steady velocity U of the block if it slides on an oil film of thickness h and viscosity u. The block bottom area A is in contact with the oil. Neglect the cord weight and the pulley friction. Assume a linear velocity profile in the oil film.
The figure shows a train traveling at a constant uniform velocity of 75 kph and a car travelling at a speed of 36 kph towards point O. Which of the following gives the nearest value of the velocity of the car at the collission point? 1 km- car 36 kph I km train 75 kph
6 ft B D
Q/ The force in the member (CA) is 12 m 50 ку 5m BX
Maximum Stresses in Thick Walled Cylinders
Determine the weight of the heaviest cylinder which can be placed in the position shown without exceeding a stress of 50 MN/m? in the cable BC. Neglect the weight of the bar AB. The cross - sectional area of cable BC is 100mm?.
(-6).(-4) – 3(-5) 11-기-12 + (-5)|
Q/ The force in the member (CA) is 50 kg 12m 5m BX
what is the actual area in part a ?