An NH, vapor compression refrigeration system has a condensing temperature of 25°C and an evaporating temperature of -10°C. The refrigerating capacity is 7 tons. By Creating a schematic diagram and ph diagram determine the ff: a) refrigerant flow rate; b) volumetric flow rate at compressor suction; c) theoretical power required; d) heat

Q: . Explain how the expansion valve in the refrigeration system works?

A: Dear student,                    According to the guidelines I am allowed to answer only one problem…

Q: How to do a heat/energy balance on a anode fuel cell and a condenser given that the fuel cell is…

A:

Q: A cascade refrigeration system uses R22 in the low temp unit and R12 in the high temp unit. The…

A: Given:Refrigerant in the low temperature unit=R22Refrigerant in the high temperature…

Q: QUESTION 53  An ideal vapor-compression refrigeration cycle that uses refrigerant-134a as its…

A:

Q: A direct contact condenser of the spry type receives 60 kg/s of 925 quality steam at 0.06 bar. A dry…

A: Given Data The mass flow rate of the steam is: m˙=60 kg/sec The quality of the steam is: x=92% The…

Q: I have step by step but I don’t know how to read table and values ! Help with final calculations

A: Solution

Q: Explain the condenser coils of a refrigerator must be cleaned periodically, and the airflow passages…

A: Dirty condenser  coils not only increase energy use and force the appliance to work harder, but they…

Q: Compare briefly the relative merits of a shell-and-tube condenser with a cooling tower, and an…

A: introduction; In shell and tube condenser heat should be removed from fluid when both are at…

Q: The food storage room requires a cooling system with a capacity of 15 tons of refrigeration that…

A: