Question 7:An ISP has the following block of addresses 132.204.192/20. The manager of this ISP hired youto help him assign IP block of addresses to the following subnets.• Subnet A should have enough addresses to support at least 850 interfaces;• Subnet B should have enough addresses to support at least 55 interfaces;• Subnet C should have enough addresses to support at least 46 interfaces;• Subnet D should have enough addresses to support at least 40 interfaces;• Subnet E should have enough addresses to support at least 20 interfaces.• Subnet F should have enough addresses to support at least 28 interfaces.Give the range of addresses (in binary) assigned to each subnet. Showyourwork.

Answered: An ISP has the following block of…

An ISP has the following block of addresses 132.204.192/20. The manager of this ISP hired you to help him assign IP block of addresses to the following subnets.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Q' Figure below shows the IPV4 datagram format. Fill the fields from 1 to 5 by choosing the right answers 2 16-bit identifier ID flags 3 4 32 bit source IP address 5 options Data (variable length, typically a TCP or UDP segment) 1- Field (1) is for: a- Time to live b- IP protocol version number c- Type of service d- Header checksum e- Upper layer protocol f- None of them 2- Field (2) is for: a- Time to live b- IP protocol version number c- Type of service d- Header checksum e- Upper layer protocol f- None of above 3- Field (3) is for: a- Time to live b- IP protocol version number c- Type of service d- Header checksum e- 32 bit destination IP address f- None of them
In order to redistribute a route into EIGRP, what is the mandatory parameter that must be used? The administrative distance might be affected by a variety of factors, including the exit interface and the IP address of the hop that comes after it.
b. Suppose that you are hired by a local company to set up a router that both serves as the network's bidirectional firewall and also NATS hosts in the corporate network. The corporate network consists of about 100,000 machines that simultaneously access the Internet using port-based NAT. What problem could arise if the corporate network only has a single public IP address?
Given the following IPv6 address 2ABCD:0000:0000:0000:00B7:0000:0000:00C6 rewrite it in its shortest possible format?
You could provide a static IP address to a host on your network when the service that host provides must always originate from the same server. In this case, the address would not change. I need to manually assign an IP address; which approach is the most effective way to do this? How did it get to be this way, and what factors contributed to it?
What are the source and destination IP addresses of the frame's network-layer header? Is this an incoming or a departing frame? *Use the filter box to remove all frames except those with http as the source or sink protocol.
a. Suppose we send into the Internet two IP datagrams, each carrying a different UDP segment. The first datagram has source IP address A1, destination IP address B, source port P1, and destination port T. The second datagram has source IP address A2, destination IP address B, source port P2, and destination port T. Suppose that A1 is different from A2 and that P1 is different from P2. Assuming that both datagrams reach their final destination, will the two UDP datagrams be received by the same socket? Why or why not? b. Suppose Alice, Bob, and Claire want to have an audio conference call using SIP and RTP. For Alice to send and receive RTP packets to and from Bob and Claire, is only one UDP socket sufficient (in addition to the socket needed for the SIP messages)? If yes, then how does Alice's SIP client distinguish between the RTP packets received from Bob and Claire?
write the following iptables on the server to block the following traffic types originated from the attacker to the server: HTTP connection request from the attacker to the server. SSH connection request from the attacker to the server. FTP and Telnet requests ( Use single rule to block these multiple ports).
True or False 1. After fast retransmit is invoked, fast recovery cuts the slow start period in half 2. A host sends a segment with a sequence number 35 and a payload of 5 Bytes. The ACK number in that segment is 40 3. TCP segments can only be lost when router queues overflow. Please explain if possible， Thank you!
A IPV6 global unicast address is composed of a Global Routing prefix = 2001:0540:FACE, Subnet ID = 0020, and an interface id = 0000:0000:0000:0040. Assuming the IPV6 global unicast address follows the "3+1+4" Rule, which of the following is the correct IPV6 global unicast address representation? %3D %3D 2001:540:FACE:20:40/32 2001:540:FACE:20:40/64 2001:540:FACE::40:20/32 2001:540:FACE::40:20/64
To illustrate the mechanics of the attack, you will conduct the attack one packet at a time using nping. Use the options -tcp -flags syn to set the SYNLflag, source-ip rand to pick a random source IP, -c 1 to send one packet at a time to that IP address, and -p 23 to select the telent protocol.
What happens if one of the TCP peers fails to publish its Maximum segment size MSS value during the handshake?