An infinitely Long slope is made up ofa c-p soil having the properties:cohesion, C = 20 kPa, and dry unit16 kN/m³. The angle ofweight, Ydinclination and critical height of theslope are 40° and 5 m, respectively.To maintain the limiting equilibrium, theangle of internal friction of the soil(in degrees) is=

Answered: Image /qna-images/answer/76710981-c3d9-4cd0-a1ce-ff82ba7bb055.jpg

An infinitely long slope is made up o a c-p soil having the properties: cohesion, C 20 kPa, and dry unit weight, Yd = 16 kN/m³. The angle of inclination and critical height of the slope are 40° and 5 m, respectively. To maintain the limiting equilibrium, t angle of internal friction of the soil (in degrees) is = -

An infinitely long slope is made up o a c-p soil having the properties: cohesion, C 20 kPa, and dry unit weight, Yd = 16 kN/m³. The angle of inclination and critical height of the slope are 40° and 5 m, respectively. To maintain the limiting equilibrium, t angle of internal friction of the soil (in degrees) is = -

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

R
A infinite soil slope with an inclination of 35° is subjected to seepage parallel to its sur-face. The soil has C'= 100 kN/m² and ¤'= 30°. Using the concept of mobilized cohesion and friction, at a factor of safety of 1.5 with respect to shear strength, the mobilized friction angle is
A granular soil has Yeat = 18 kN/m³ and o' = 32°. An infinite slope is required to be made from %3D this material. If seepage occurs parallel to the surface of the slope and factor of safety of 1.5 is needed against slope failure then the value of safe angle of slope is degree.
When the sediment or soils on a slope is saturated with water, the between grains is greatly reduced and the material is more likely to move/slide downslope. A. Overlap B. cohesion C. distance D. volume
The soil shown in the figure having the properties C = 0, ø = 450, Ydry 16kN/m³ and Ysat 20kN/m. What should be the depth of ground water table (GWT) from the surface of the soil to achieve a factor of safety (FOS)= 2 of an infinite soil slope shown in the figure. Take Yw= 10 kN/m³ W 10 m m h 25° ¥ GWT TTT
Please calculate the critical factor of safety for the following slope configuration using the following m ethods: Using slope stability charts Layer 1 Clay c=35 kN/sq.m Friction Angle=0 Unit Weight-18 kN/cu.m Layer 2 Silty Sand c=5 kN/sq.m Friction Angle=35 deg Unit Weight=18 kN/cu.m Slope Height=10 m Slope Angle=30 Degrees Layer 1
2. Consider a rectangular footing 3.2 m x 4.5 m to be constructed in a uniform clayey sand to support allowable loads as shown in Figure Q2. Assuming general shear failure would take place, determine the safety factor against bearing capacity failure when the ground water table is at 1.0 m above the ground surface. Comment on the obtained result.
3 of earth pressure at rest, active earth pressure and passive earth pressure. Write a note on Rankine's Earth Pressure Theory for Cohesive Soil Explain the Coulomb Wedge theory to estimate the earth pressure. 4 5 A soil mass is retained by a smooth backed vertical wall of 6m height. The unit weight of 20 KN/m3 and -16° The top of soil is level with the top of horizontal. If the soil surface carries a uniformly distributed load of 4.5 KN the total active thrust on the wall and its point of location. 6 Compute the intensity of passive earth pressure at a depth of 8m in a cohes with an angle of internal friction of 30° when water rises to the ground leve weight of sand is 21 KN/m³, Yw=9.81 KN/m³ 7 Compute the intensities of active and passive earth pressure at depth of 8m cohesionless sand with an angle of internal friction of 30° and unit weight What will be the intensities of active and passive earth pressure if the water the ground level? Take saturated unit weight of sand as 22…
A soil is used in the construction of an infinitely long slope of angle 45° and critical height 6 m. The cohesion and dry unit weight of soil is 21 kPa and 18 kN/m3, respectively. Calculate the required internal friction angle of the soil.
The intensity of passive earth pressure at a depth of 6 m in a cohesionless soil with an angle of internal friction of 30° kN/m². when water rises to ground level is Take saturated unit weight of sand as 21 kN/m³ and y = 9.81 kN/m³. Y