An inclined tube manometer measures the gauge pressure ps of a system S . The reservoir and tube diameters of the manometer are 50 mm and 5 mm respectively. The inclination angle of the tube is 30°. What will be the percentage error in measuring pS if the reservoir deflection is neglected.

Q: A piezometer connected to a pipe containing oil (Density = 860 kg/m³) reads 20 cm height. Determine…

A: Given: Density=860kg/m3 Height (h)=20cm or 0.20m Atmospheric pressure (Patm)=101.320kPa

Q: The reading of the pressure gauge fitted on a vessel is 32 bar. The atmospheric pressure is 1.03 bar…

A: Given Data⇒ Reading of pressure gauge is : Pgauge=32 bar Atmospheric pressure is Patm=1.03 bar…

Q: Show complete solution. Determine the gauge pressure at P in the figure below which shows a…

A: Pressure formula P = Po + ρgh

Q: 9. If the surface tension of water-air interface is 0.073 N/m, the gauge pressure inside a rain drop…

A:

Q: if a pressure gauge on a compressed air tank reads 125 psi, assuming standard atmospheric pressure…

A: given data- gauge pressure, Pgauge= 125 psi atmospheric pressure  Patm = 14.696 psi to determine-…

Q: A horizontal pipe carries oil with a specific gravity of 0.86.  Two pressure gauges placed along the…

A: Given The specific gravity of oil is x=0.86. The pressure at two ends of the pipe is P1=135 psig…

Q: During a natural storm, a student in a laboratory observes a 22.0 mm drop in height from the normal…

A:

Q: There are two manometers (liquid inside has an Specific Gravity of 13.6) attached to an air duct.…

A: Given:-  Reading on open end manometer = 25 mm of Hg Reading on sealed end manometer = 800 mm of Hg…

Q: y. A manometer is attached to a conduit, as show the figure. Calculate the gauge pressure inside the…

A:

Q: QUESTION 1 1.1 The inverted U-tube manometer is used to measure the difference in pressure between…

A: The densities of the respective fluids are,Draw the schematic diagram for the given system.

Q: A strain gauge measured the hoop stress on the surface of the tank as 291,989 Pa. The tank diameter…

A: Given The value of the hoop stress for the cylindrical tank is σh=291,989 Pa. The diameter of the…

Q: The  viscosity of liquids is appreciably affected by a change in temperature.     Select one:…

A:

Q: Suppose by curiosity, a student poured three different media inside a transparent tank with gauge…

A: Principle : Pascal law - states that, pressure on the horizontal plane of same fluid remains same.

Q: A horizontal Orifice meter is used to measure the flow rate of water through the piping system of 20…

A:

Q: Determine the pressure difference between pipe A and B for arrangement shown in Fig. P. 1.13.20.

A: It is needed to determine the pressure difference between the two pipes.

Q: Bourdon-type pressure gauges are used in thousands of applications. A deadweight tester is a device…

A: Dead weight pressure tester:A simple form of a dead weight pressure tester consists of a plunger of…

Q: gauges G, and G, install r and Pe = 1.00 bar. Th ATMOSPHERIC PRESS %3D G2

A:

Q: cylindrical tank is filled with fluid. A pressure gauge 3 meters above the bottom reads 100 kpa.…

A: Given Data At 3 m above bottom, P= 100 kPa At 8 m above bottom,P=60 kPa

Q: The vacuum in the condenser is 716 mm of Hg when the barometer reads 748 mm of Hg. In another case,…

A: we will raise the barometric pressure to 760 mm without any change in absolute pressure in condenser

Q: A tube contains an oil of specific gravity 0.87 to a depth of l1200 mm. Find the gauge pressure at…

A:

Q: A rocket is accelerating horizontally to the right at 10 g. The pressure gauge is connected by a 0.6…

A: Given data: ● The horizontal acceleration of the rocket to the right: ax = 10 g ...(g = 9.81 m/s2) ●…

Q: Why the experiment was repeated? One for increasing and one for decreas eights? To get the accurate…

A: The more times an experiment is conducted with various experimenters using different equipment,…

Q: 1. Determine the pressure difference between the water pipe and the oil pipe. Water S = 0.68 15 cm…

A: To find: The value of pressure difference between water pipe and the oil pipe. Given:   Pw =…

Q: Pressure measuring devices like differential manometers are used to measure the pressure difference…

A: A differential manometer is a pressure measuring device which is use to measures the difference in…

Q: 3.8 If the reading of the pressure gauge in will the value of Fig 3.42 is 6.5 bar what pressure be…

A: Given : The gauge  pressure is  The density of oil is The density of water is The diagram is,

Q: Shown in the figure, Fluid 1 is flowing in a horizontal tube and a U-tube manometer containing Fluid…

A: According to hydrostatic law, the pressure at any location fluid inside a static fluid is the…

Q: Water flows at 0.07 cubic meter per second through a pipe. A horizontal venturi meter with throat…

A:

Q: 7. Does the error rate in the gauge increase or decrease when the pressure is increased? And why?

A: Given Gauge To find Error rate of gauge

Q: A pressure gauge measures the reading as 29 psi. If the atmospheric pressure is 13 psi. Compute the…

A:

Q: “C-Type Bourdon Tube is a device in which the pressure responsive element is made of a thin metal…

A: Bourdon Tube :- The burden tube works on a principle that a metallic tube tend to regain its…

Q: Problem 2 (30 points): The manometer shown is closed to the atmosphere. The pressure at point A is…

A: Given: The pressure at point A is PA=9000 Pa. The pressure at point B is PB=8000 Pa. The dimension…

Q: Convert the reading of pressure to kpa.

A: Given data; Borometer reads =760 mm of Hg Convert 80 cm of Hg into kpa ?

Q: Ex. 10. A mercury manometer is con- nected to open tank of fuel. Calculate a change of manometer…

A: Dear student, we are suppose to solve only one question. Please post other question as a separate…

Q: Explain the concept of calibration. pressure calibrator, digital tachometer, defibrillator analyzer,…

A: Calibration is the process of verifying and adjusting the accuracy and precision of a measuring…