An impedance z₁ = 8j5ohms is in parallel with an impedance z₂ = 3 + j7ohms. If 100V areimposed on the parallel combination. Find the branch current 11, 12 and the resultant current.Draw the corresponding phasor diagram showing each current and voltage drop across eachparameter. Calculate also the equivalent resistance, reactance and impedance of the wholecircuit.

In this question we will find impedance , current etc....

An impedance z₁ = 8 - j5ohms is in parallel with an impedance z₂ = 3 + j7ohms. If 10 imposed on the parallel combination. Find the branch current 11, 12 and the resultant cu Draw the corresponding phasor diagram showing each current and voltage drop across parameter. Calculate also the equivalent resistance, reactance and impedance of the wh circuit.

An impedance z₁ = 8 - j5ohms is in parallel with an impedance z₂ = 3 + j7ohms. If 10 imposed on the parallel combination. Find the branch current 11, 12 and the resultant cu Draw the corresponding phasor diagram showing each current and voltage drop across parameter. Calculate also the equivalent resistance, reactance and impedance of the wh circuit.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A voltage source with a value of 25 e^j45 V flows a current of 5 e^j15 A through a series impedance. Find the equivalent impedance and admittance in this circuit. Find the resistance, inductive and capacitive elements at equivalent impedance
draw the thevenin equilvalent circuit and determine the load impedance for maximum power transfer. show the final circuit with appropriate resistors, capacitors, and/or inductors.
Consider a drcuk where an ideal inductor L=D.144H is connected in parallel to a resistor R=1.00k. This combination is connected in series with a capacitor C=3.67e-07. This combination in connected to a power supply source of frequency f-3.4kHz. To study this circuit you need to drawa phasor diagram. Note the sum cf the current phasors through the resistor and the inductor must be equal to the phasor representing the current through the capacitor fie. the total current). You should draw the phasor for the current through the capadtor on the horizontal axis, since this is also the total ourrent delivered by the supply. The angie between this phasor and that of the power supply represents the phase angle o. Note that the voltage across the inductor equals the voltage aoross the resistor since they conmected parallel to esch other. Furthermore the sum of the phasors representing the currents through the inductor and the resistor equals the phasor representing the current through the…
1. a) Sketch the phasor diagram, using current as the reference phasor, for a load consisting of a resistor and capacitor in series. b) Sketch the phasor diagram, using current as the reference phasor, for a load consisting of a resistor and inductor in series.
A sinusoidal current of 5 Arms is flowing through a series combination of a resistor and Inductor. The value of R is 45 ohms and that of the inductance is 15 mH and a frequency of 60 Hz. Find the magnitude and the phase angle of the voltage across the combination. (Hint: you can use phasor diagram). Select one: a. [V]=28.89, angle=9.39 b. IV]=25.60, angle367.00 c. [V]=128.01, angle3D10.18 d. IVl=226.77, angle=D7.16
An inductive impedance made up of a resistor and an inductor has the characteristic that its currentadvances in phase to the voltage at the impedance A) lags in phase with the voltage across the impedance B) is in phase with the voltage across the impedance. C) None of the above
The picture shows three LC circuits, two of them with capacitors of capacitance C and the three with coils of inductance L, the three circuits are coupled by means of two capacitors Cc capacitors.L inductance coils, the three circuits are coupled by means of two capacitors of capacitance Cc. The currentscirculating through each mesh are those indicated in the figure: I1, I2 and I3. Using Kirchhoff's law for voltagesand taking into account the definition of current I = -dQ/dt, find the system of coupled equations for the systemand then find the angular normal frequencies of the system.
NOTE: Polar form for Voltage & Current. Rectangular form for Impedance Find the total impedance of the circuit, total power (apparent) delivered by the current source, Draw the phasor diagram of the voltage and current at the source, the current passing through the R2 and L1 branch, Draw the phasor diagram of the voltage and current at the R2 and L1 branch. Also, is the circuit inductive, capacitive, or neither (resistive)?
A circuit is designed with an AC source of max voltage 12 and frequency 60 Hz. The circuit has a resistance of 1050 Ohms, an inductance of 0.06 Henrys, and a capacitance of 0.009 coulombs per volt. - omega for source in rad/s? - omegaR for circuit? -XL? -XC? -phi in radians? -Z? -imax?
A 300 – ohm inductive reactance is connected across a series combination of a resistor R anda capacitive reactance of 30 – ohm. Solve for R if the equivalent impedance of the combinationis pure resistance of 100 – ohm.
]What happens when we encounter a circuit that has all 3 components in series? Parallel? How do we figure out what our phase relationship in a series reactance and resistive circuit? Parallel?
4) Given: R = 700-N, Xc = - j 500-N, e(t) = 150 sin(wt) V Find: a) Total impedance of the ckt. b) Total current in phasor and sinusoidal form c) Voltage drop across the resistor and capacitor in phasor and sinusoidal form d) Total Power and Power factor