Answered: An impedance draws a current I =…

An impedance draws a current I = 10sin(ωt-30°) ampere from a voltage V = 220cos(ωt-65°) volts. Determine the following: a. Apparent Power b. True Power c. Reactive Power

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: A voltage and current applied to a single phase load is v= 195 sin (300t+35°) and i= 175 sin (250t-…

A: Since frequency are different so Net real power will be zero in single and 3 phase system.

Q: nts ce The voltage and current of an ac circuit are as follows: e = 141. sin (377t + 10) V and i =…

Q: The 60-Hz ac source of a series circuit has a voltage amplitude of 120 V. The resistance, capacitive…

A: Given data: R=490ΩXL=230ΩXC=960 Ω V=120V

Q: Solve the following. 1. Find the voltage for given value of e, if sinusoidal wave has got amplitude…

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again.

Q: A 480-V rms, 60 Hz source supplies a load having a total impedance of 50 angle 60° ohms. Find the…

A: .

Q: A supply voltage has a mean value of 150V. Determine its maximum value and its rms value.

A: Given, Mean voltage of a supply, Vavg=150 V.

Q: A 400 resistor is connected in parallel to a coil having a resistance of 10 and an inductance of 3H.…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: A coil of resistance 20000 and self- inductance 1.0 Henry has been connected to an a.c. source of…

A: The coil can be thought of as the resistance connected in series with the inductor. The inductive…

Q: Determine the output waveform for the network of figure below and calculate the output dc level. Si…

A: Rectifiers are used to convert the Alternating supply into pulsating DC. It can be an uncontrolled…

Q: A 480-V rms, 60 Hz source supplies a load having a total impedance of 50 angle 60° Q. Find the…

Q: A non-inductive resistor is connected in series with a coil across a 230V, 50Hz supply. The current…

A: Let 'R' be the non inductive resistor and a coil with resistance 'r' and inductance 'L' may be all…

Q: I. CIRCUIT DIAGRAM. R1 L1 150 26.5mH C1 100 Vrms 60 Hz =132.63µF 0°

A: In series RLC Circuit,XL=XC Resonance ConditionXL>XC Inductive Circuit (R+j XL-j…

Q: supplies

Q: For the circuit of the following figure, if R=26 Q, Zc=-J18 Q, and ZL=J18 Q, and if the value of the…

A: To find The value of reactive power supplied by 3L-41° v

Q: 1. 0.95 0.299 599 x16372.56 1 O o85 0.5.3 0.106 57.86

A: As per given table mention various kind of data of RC circuit.

Q: Assume you are working on sinusoidal ac supply voltage which is in the form of 150 sin 220 t. So…

A: In the theory of alternating current, a sinusoidal waveform can be generated by using a single-coil…

Q: a. Determine the total real power, Pr, and total reactive power, QT- b. Draw the simplified circuit.…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: A 60 Hz sinusoidal voltage v = 141sinwt is applied to a series RL circuit. The values of the…

Q: A single phase AC chopper supplies a pure inductive load of 0.02H from 220V, 50HZ AC supply. The…

Q: Quistion.4. a) A sinusoidal voltage is applied to the resistive circuit in figure.Q.4. a. Determine…

Q: Draw the power triangle associated with the source, 300230° Vrms. illustrate the apparent, active,…

A: We need to draw the power triangle and calculate the power factor for the given circuit.

Q: A three-phase, variable-frequency drive (VFD) draws lagging non-sinusoidal line current, resulting…

A: The given question deals with spectral analysis of the non-sinusoidal line current of a three-phase…

Q: A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm…

A: Please refer the attached images for the complete answer..

Q: When a load is connected to a power line with a frequency of 230V (rms) 50 Hz, it draws 4250 W of…

A: Given Vs=230V f=50Hz PL=4250 watt power factor,cosφ=0.85 → φ=31.78° So reactive power of load,…

Q: An AC supply voltage is represented by v = 325 Sin wt. Three loads are connected in parallel across…

Q: Please solve...

Q: 2. Three series loads are drawing 20A ms current through a 60Hz source. Load 1 is an 400W, 0.8…

Q: Resistor R and a resistanceless coil L1 = 83.8 mH are connected in series to an AC source with…

A: The given circuit is the RL circuit: The current I can be calculated as: Irms=VrmsR2+XL2

Q: A load is supplied by a 230 V, 50 Hz source. The active power P and the reactive power Q consumed by…

Q: 4. In ac circuit takes a load of 160 kVA at a lagging power factor of 0.75 when connected to a 460-V…

Q: Problem 1 • A sinusoidal source with frequency of 60 Hz and rms-voltage of 100 V is connected to an…

A: Given data, Resistance R= 10 Ω Inductance L= 10 μH=10×10-6 H

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: 5. Discussion: 1. What is the condition under which the superposition theorem can be applied? 2. Is…

A: Q) what is the condition under which the superposition theorem can be applied? Answer: The…

Question

100%

An impedance draws a current I = 10sin(ωt-30°) ampere from a voltage V = 220cos(ωt-65°) volts. Determine the following:
a. Apparent Power
b. True Power
c. Reactive Power

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
Please help with parts d and e.
d. 565.685 V If a Load absorbs 20 kVA at a leading power factor of 0.6. Then the complex power is: Select one: O a. 12000 - j16000 VA O b.-12000 + j16000 VA O c. 12000 + j16000 VA O d. None of these Given the circuit below and the associated set of voltages and currents, the reactive Power developed by im voltage source is FENG300 MINTERM
Please help with the solution.
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of158 volts, 50 Hz supplies the combination. Determine the following: e. Reactive power supplied by the sourcef. Apparent power of the circuitg. Power factor of the entire circuit
Find the rms value of the current waveform shown below. (Show complete solution)
The total reactive power of an AC circuit having power factor of 0.85 leading is 40kVAR. The true power drawn by the circuit is: PS: please write in detailed solution.
Vm = 10 V T = 2 ms V0 = 7.07 V 1) Find the frequency of the voltage in Hz. 2) What is the frequency in kiloradians per second? 3) What is the rms value of the voltage?
1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the expression of waveforms A and B clearly. HUS Voltage (V) 8 0 K/N B 7: ST ot
Google ls alual Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below. V-120v (rms) 2.1k.n + Q
15 O 715 O A-20/10° Ayh/rms VB w100 rad/s
Given the circuit shown, answer the following questions 1 40 I U8 VS-24/60° V (+ one of the following statements is correct: Choose... Choose... 12 in Ampere equals to: 2.65-j0.54 the equivalent impedance in Ohm of the circuit is 7+j1.88 12 leads Vs by 60° 12 lags Vs by 71.58° -0.47+j1.75 12 leads Vs by 71.58° 12 leads Vs by 11.58° 3.26+j15.93 12 lags Vs by 11.58° 2.18+j1.21 8.24+j4.94 V2 in Volts equals to: m13-4-2021 Jump to...