An ideal reheat turbine with one stage of reheat receives steam at 8.0 MPa, 480 ̊C. Reheat pressure is 0.83 MPa and exhaust pressure is 0.007 MPa. The work is 1559 kJ/kg and the thermal efficiency is 41.05%. Find the temperature of steam leaving the reheater.

Q: diesel engine has a compression ratio of 20:2 with an inlet of 90 kPa, 17C, state 1, with volume 0.5…

A: Given Data rc=20.2  State 1: 90 kPa, 17°C Tmax=1900 K

Q: A complex flow system expands helium from 1500 K, 1000 kPa to 500 K, 100 kPa. In the process this…

A: The inlet condition of helium is The exit condition of helium is The work produces is For helium The…

Q: 40˚C. Expansion now occurs to the condenser pressure of 0.0035 MPa. The steam flow is 147,000 kg/hr,…

A: In a reheat cycle steam at 15 MPa, 540˚C enters the engine and expands to 1.95 MPa. Reenters the…

Q: A milk sterilizer flow system accepts milk at 20°C, 100 kPa and uses steam at 1 MPa, 200°C to heat…

A: The mass flow rate of milk is The properties of steam is The inlet pressure of milk is The inlet…

Q: An adiabatic air turbine has an inlet of 1600 K, 2000 kPa, and it exhausts at 100 kPa. If o=0.5…

A: The inlet temperature of adiabatic air turbine is .The inlet pressure of the adiabatic air turbine…

Q: A 7.162M British Thermal Unit per hour is required for a gas turbine power plant in Batangas wherein…

A: Write the given data. Wnet=7.162 MBTU/hrP1=3.4 psig=18.1 psiaT1=300 KPR=9T3=1742 °F=1223 K Write the…

Q: In a carnot cycle. The pressure at the end of heat rejection is 15 psia while the pressure at the…

A:

Q: A steam turbine has an inlet of 2 kg/s water at 1000 kPa, 350°C and velocity of 15 m/s. The exit is…

A:

Q: In a spray condenser, find the ratio of circulating water to steam flow if the condenser pressure is…

A:

Q: In a reheat cycle steam at 550°C expands in theh.p. turbine till it issaturated vapour. It is…

A: Given data as per question The temperature of steam =5500 c Considering TS diagram of the system…

Q: In the open-circuit steam plant, boiler feed water at atmospheric pressure 1 bar and 35oC is pumped…

A:

Q: capacity

A:

Q: 4. A two-stage compressor receives 0.35kg/s of air at 100kPa and 269K and delivers it at 5MPa. Find…

A: givenm=0.35kg/sP1=100kPaT1=269KP2=5Mpa

Q: A Brayton cycle has an initial temperature 300C. If compression ratio of compressor is 8, find the…

A:

Q: Q3/ Onc kg of air is the taken through on Otto cycle, the initial pressure and tempe rature being 10…

A: Given: Mass of air=1kg P1=10kPa T1=100°C or 373K Heat added Qin=3350kJ/kg Compression ratioγk =6…

Q: 6. Superheated steam at 10MPa, 400°C is flow through an adiabatic nozzle of back pressure IMpa, and…

A: Given DataP1=10MPaT1=400°CP2=1MPaA=10cm2=0.0.1m2

Q: H.w: nitrogen gas flows into a convergent nozzle at 200 kpa,400K and very low velocity .it flows out…

A:

Q: Ideal air enters a compressor at 100 kPa and is compressed to 150 kPa. The isentropic efficiency is…

A:

Q: In a carnot cycle. The pressure at the end of heat rejection is 14 psia while the pressure at the…

A:

Q: 2. 1 kg/s steam enters the turbine at 2.5MPA and 500C while leaving at 10kPa with 89% quality. The…

A:

Q: Air in an ideal diesel is compresses from 8 liters to 0.15 and then expands during the constant…

A:

Q: Efficiency of Carnot cycle is given as 75%. If the cycle direction is reversed, what will be the…

A: Let us take, Lower temperature of carnot cycle = TL Higher temperature of carnot cycle = TH   Given,…

Q: An ideal turbine with one stage of reheat receives steam at 8 MPa, 500 degree C. Reheat pressure is…

A:

Q: e water to (18"C). Assume turb

A: Given-Information:- Condenser Pressure, Pc = 0.07 barTemperature,T = 18°CTurbine Exhaust quality, x…

Q: A steam engine isentropically expand 5kg/sec of the steam from the 0.70 mpa 250°c, the exhaust is…

A: Given data: - The mass flow rate is ms = 5 kg/s. The initial pressure of the steam is P1 = 0.70…

Q: Problem 2: A turbine accepts steam at 3000kPa and 800 °C and leaves at 100 kPa with a quality of…

A:

Q: In a geothermal power plant a underground hot water is available as saturated liquid at 600 kPa. The…

A: Given:P1=529 kPax1=98%P2=15 kPa

Q: An isentropic turbine process 5kg/s of steam at 4MPa, which is exhausted at 50kPa and 100 C. Five…

A: given data : mass flow rate at which the turbine processes steam (m*1) = 5kg/s pressure at which…

Q: A 7.162M British Thermal Unit per hour is required for a gas turbine power plant in Palawan wherein…

A: Calculated air flow in lb/min.

Q: An adiabatic turbine receives 2.0 kg/s of superheated steam at 2.5 MPa, and 700°C. The discharge at…

A:

Q: Steam turbine with 80% stage efficiency receives steam at 7MPA and 550 deg C and exhausts as 20kPa.…

A:

Q: Steam enters the high-pressure turbine at 150bar and 550c and low pressure turbine at 40bar and 550c…

A:

Q: In a spray condenser, find the ratio of circulating water to steam flow if the condenser pressure is…

A:

Q: If the mass flow rate for air is 5 Kg/s .and air compressor takes in air at 200 kPa, 290 K and…

A: Assumptions are taken in the compressor device -Air is assumed as an ideal gas -Flow is steady -No…

Q: 1 kg/s steam enters the turbine at 2.5MPa and 500C while leaving at 10kPa with 89% quality. The pump…

A: Answer: (a) The turbine work output is 1142.03 kW. (b) The heat added in the boiler is 3268.4751 kW.…

Q: An ideal turbine with one stage of reheat receives steam at 8 MPa, 500°C. Reheat ressure is 0.8 MPa…

A:

Q: Given . ● 86 and 91% isentoopie efficiency of the turbine = 86%. isentrople", Pump = 91% • If…

A: From given schematic diagram, it is clear that reheating is applied to the working fluid. Draw T-s…

Q: Butane enters an adiabatic compressor at 20psia and 250F with a volume Clow rate of 12ft3/s and…

A:

Q: 2. Consider an ideal steam reheat cycle where steam enters the high-pressure turbine at 3.0 MPa,…

A:

Q: A steam turbine has an inlet of 4 kg/s water at 1000 kPa, 400 oC and velocity of 77 m/s. The exit…

A: Given        Pressure, P1 = 1000 kPa Temperature, T1 = 400 oC           Velocity, v = 77 m/s

Q: A 5-stage compressor has intake conditions of 100 kPa and 20C. The air must be discharged at 900…

A: