AN IDEAL REHEAT-GENERATIVE CYCLE, STEAM ENTERS THE ENGINE NUDAGO AT 8 MPa AND 400°C. AFTER EXPANSION TO 300°C THE STEAM IS WIDTHDRAWN AND REHEATED TO 350°C. EXTRACT FOR FEEDWATER REHEATING OCCUR AT 1.5 MPa AND 0.70 MPa AND THE CONDENSER PRESSURE IS 0.005 MPa. FOR THE IDEAI CYCLE FIND (A) Wnet AND Ec. FOR THE IDEAL ENGINE FIND (B) W WORK. EcTHERMAL EFFICIENCYENTERING www THE ENGINE W WORK - Wnet TOTAL WOTK DONE 1

AN IDEAL REHEAT-GENERATIVE CYCLE, STEAM ENTERS THE ENGINE NUDAGO AT 8 MPa AND 400°C. AFTER EXPANSION TO 300°C THE STEAM IS WIDTHDRAWN AND REHEATED TO 350°C. EXTRACT FOR FEEDWATER REHEATING OCCUR AT 1.5 MPa AND 0.70 MPa AND THE CONDENSER PRESSURE IS 0.005 MPa. FOR THE IDEAI CYCLE FIND (A) Wnet AND Ec. FOR THE IDEAL ENGINE FIND (B) W WORK. EcTHERMAL EFFICIENCYENTERING www THE ENGINE W WORK - Wnet TOTAL WOTK DONE 1

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In a carnot cycle. The pressure at the end of heat rejection is 14 psia while the pressure at the end of expansion is 329 kPaa. Find the cycle efficiency in % if the working fluid is hot air
An industrial plant generates its own power thru heat transfer and mechanical work, from heat energy generator and turbo generator set. A bagasse fired 60 tonner water tube boiler generating 335 psi. And 330°C superheated steam. Condensates at 90°C feedwater absorbing heat at the deaerator and preheater by as much as 3 592 446 KJ/hr that supplies the steam drum at a rate of 10% higher than the steam generated. Tons steam per ton cane is 2. Superheated steam at a velocity of 25 m/sec is supplied to an impulse turbine that drives a generator producing electrical energy. Exhausted heat energy at a velocity of 20 m/sec, before undergoing heat condensations is at 800 KJ/kg. Determine the following: The Boiler Thermal Efficiency
A reheater cycle is executed of 1kg steam expanding initially from 12.356 Mpa and 540.356oC. The reheater pressures are 2.5356 MPa and the steam leaves the reheater at 420.356oC. Condensation occurs at 0.02356 Mpa. Calculate W, ec and ee.
A two-stage R-22 system uses flash-gas remoal and intercooling as in the previous problem. The evaporating temperature is -40 C and the condensing temperature is 30 C. The pumping capacity of the high and low stage compressors is shown below: (from picture solve a and b)
A refrigerating system operates on reversed carnot cycle. The minimum and maximumtemperatures are minus 28°C and plus 70°C, respectively. If the heat rejected at the condenseris 5200 kJ/min, draw the TS diagram and find,a) Power input required
A power plant operating in a Reheat Rankine Cycle produces steam at 3 MPa, 600oC in the boiler. It keeps the condenser at 45oC by transfer of 10 MW out as heat transfer. The first turbine section (high-pressure) expands to 500 kPa and then flow is reheated followed by the expansion in the low-pressure turbine. Draw the Ts Diagram
The subject is thermodynamics 2
The low pressure turbine in a regenerative cycle receives 10 kg/s steam at 600kPa, 500 C. The turbine exhausts to a condenser operating at 10 kPa. The condenser co0ling water temperature is restricted to a maximum of 10 C increase, so what is the needed flow of cooling water? draw schematic and t-s diagram
Find C.O.P from a simple vapor compression refrigeration cycle R-134 evaporation temperature is -15 degrees Celsius and condenser temperature is 30 degrees Celsius
290°C using 1700kJ/kg, the condenser cools the steam to 40°C, the uh to produces 530kJ/kg, and the pump uses 23KJ/kg? What is the efficiency of an equivalent Carmot cycle
The boiler and enters the turbine at 4MPA ,40oc. After expansin in the turbine to 400kpa, khe steam is reheuted to 400c, and then expanded in Hhe Low-presne turbinre to 10 kpa. Dekermina the Cycle efficemy :- Censide
Thermodynamics