An ideal gas (the system) is contained in a flexible balloon at a pressure of 1 atm and is initially at a temperature of 20.°C. The surrounding air is at the same pressure, but its temperature is 25°C. When the system has equilibrated with its surroundings, both systems and surroundings are at 25°C and 1 atm. In changing from the initial to the final state, which one of the following relationships regarding the system is correct? Select one: a. DH = 0 b. q > 0 C. W > 0 d. DE < 0 e. DE = 0

An ideal gas (the system) is contained in a flexible balloon at a pressure of 1 atm and is initially at a temperature of 20.°C. The surrounding air is at the same pressure, but its temperature is 25°C. When the system has equilibrated with its surroundings, both systems and surroundings are at 25°C and 1 atm. In changing from the initial to the final state, which one of the following relationships regarding the system is correct? Select one: a. DH = 0 b. q > 0 C. W > 0 d. DE < 0 e. DE = 0

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A 9.00L tank at 22.2°C is filled with 5.42g of carbon monoxide gas and 17.1g of sulfur tetrafluoride gas. You can assume both gases behave as ideal gases under these conditions. Calculate the partial pressure of each gas, and the total pressure in the tank. Be sure your answers have the correct number of significant digits. carbon monoxide partial pressure: atm sulfur tetrafluoride partial pressure: atm Total pressure in tank: atm
True or false. Why?
Hot gaes Expanding A mixture hot gases expands, changing volume from 2.45 L to 6.82 L, against a constant pressure of 3.22 atm. The P-Vwork involved is Latm .
A syringe containing 1.47 mLmL of oxygen gas is cooled from 94.5 ∘C∘C to 0.8 ∘C∘C. What is the final volume Vf of oxygen gas?
Please answer the question Below.
A balloon has a volume of 4.7 L when sitting inside a warm building at 22.°C. When the balloon is taken outside to a temperature of 3.3°C, and the air inside the balloon is allowed to come to equilibrium with the outside air, what will be the volume of the balloon? Answer in L, assuming that the pressure in the balloon is 1 atm, both inside the building and outside in the cold air.
A student experimentally determines the gas law constant, R, by reacting a small piece of magnesium with excess hydrochloric acid and then collecting the hydrogen gas over water in a eudiometer. Based L-atm on experimentally collected data, the student calculates R to equal 0.0832 mol·K L-atm Ideal gas law constant from literature: 0.08206 mol·K (a) Determine the percent error for the student's R-value. Percent error = % (b) For the statements below, identify the possible source(s) of error for this student's trial. The student notices a large air bubble in the eudiometer after collecting the hydrogen gas, but does not dislodge it. The student does not clean the zinc metal with sand paper. The student does not equilibrate the water levels within the eudiometer and the beaker at the end of the reaction. The water level in the eudiometer is 1-inch above the water level in the beaker. The student uses the barometric pressure for the lab to calculate R.
7. When detern ing the mass of a liquid, ras in a hurry and did not allow enough time for the temperature of the flask to reach the temperature of the boiling water bath. The student recorded the temperature of the gas as 100.0°C when it was only 80.0°C, Is the molar mass calculated by the student higher or lower than the accepted molar mass, or does this error have no effect on the calculated result? Briefly explain your answer # 2/HB Office DEPOTS b) If the student assumed the volume of the flask was 125 mL (as marked by the side of the flask) rather than measuring the volume experimentally, would the unknown's calculated molar mass be too high, too low, or unaffected? Explain. # 2/HB 4
A canister of pressurized gas has a mass of 10.0000 g. A small amount of gas is released and collected. The collected gas has a volume of 50.00 mL. The pressure and the temperature of the collected gas are the same as the air pressure and air temperature that day: 100. kPa and 25oC. It is noticed that when the gas is released the mass of the pressurized canister decreases to a mass of 9.9110 g. It is not known what gas is in the canister, but you know it is one of the following gases: methane (CH4), ethane (C2H6), propane (C3H8) or butane (C4H10). Using the information provided determine which gas is actually present in the canister.