An Ideal gas is being heated in a circular duct as while flowing over an electric heater of 130 kW. The diameter of duct is 500 mm. The gas enters the heating section of the duct at 100 kPa and 27 deg C with a volume flow rate of 15 m3/s. If heat is lost from the gas in the duct to the surroundings at a rate of 80 kW, Calculate the exit temperature of the gas in deg C. (Assume constant pressure, ideal gas, negligible change in kinetic and potential energies and constant specific heat; Cp =1000 J/kg K; R = 500 J/kg K)

Q: rate of 15 m3³/s. If heat is lost from the gas in the duct to the surroundings at a rate of 51 kW,…

A: Given data; A gas is heated in a duct as it flows over a resistance heater,    consider electric…

Q: (Q3) Refrigerant-134a enters a compressor at 320 kPa and 90°C at a rate of 2.15 m'is and leaves at a…

A:

Q: HOwrate of 0.75 Ibm/s of water at 80 F and 70 pisa is mixed with 1 Ibm/s of saturated vapor water at…

A: To determine the quality of steam leaving the chamber, first, we need to calculate the enthalpy of…

Q: (0.1 kg/s) of water enters a boiler at (323°K & 5 Mpa), and leaves as steam at (673°K & 5 Mpa). For…

A:

Q: 1. (Pp156p-ex4.16-jrfra) Air at 280 K and 80 kPaa enters the diffuser oa a jet engine steadily with…

A:

Q: Saturated ammonia at a temperature of 50oF and a flow rate of 3 lbm/s enters a steady-state…

A:

Q: Air enters a 28-cm diameter pipe steadily at 200 kPa and 20C with a velocity of 5 m/s. Air is heated…

A:

Q: Consider the turbocharger of an internal combustion engine. The exhaust gases enter the turbine at…

A:

Q: team enters the condenser of a steam power plant at 20 kPa as a saturated vapor with a mass flow…

A: The pressure of condenser is .The mass flow rate of steam is .The steam enters at saturated vapor…

Q: In a gas turbine unit, the gases flow through the turbine at 13 kg/s and the power developed by the…

A: Given data: Mass flow rate of gas (m.)=13 kg/s The power developed by the turbine (P)=14000 kW The…

Q: A vapor enters a group of convergent-divergent nozzles at 3 MPa and 300 oC and expands to 0.5 MPa.…

A:

Q: termine the rate of heat released (in kW) by the steam with 88.0% quality that enters the evaporator…

A: Given:x=0.88m=1800 kg/hT1=132°CT2=100°CC=4.187 KJ/kg.°C

Q: a) Draw the process on the PV diagram and explain the changes of pressure and volume durin the…

A: Pneumatic: The pneumatic is the system in which the pressurized air used for the applications. The…

Q: Q1: Air enters a diffuser at 200 m/s with a pressure of 85 kPa and a temperature of -20°C. It leaves…

A: INTRODUCTION: The diffuser is a steady flow mechanism in which incoming mass leaves by expanding and…

Q: R-134a flows in a pipe at a 30°C with a specific volume of 0.04434 m3/kg. The internal energy and…

A: Given data :To find:

Q: (Q3) Refrigerant-134a enters a compressor at 400 kPa and 100°C at a rate of 2.2 m'is and leaves at a…

A:

Q: An underground cavern will be used to store energy of compressed air. the cavern has a volume of…

A: Given:Volume of the cavern, V=150000 ft3Initial pressure of the air, Pi=15 psiaFinal pressure of the…

Q: Steam enters the condenser of a steam power plant at 20 kPa and a quality of 90 percent with a mass…

A:

Q: Liquid water at 20 oC is heated in a mixing chamber by obtaining a mixture with a saturated steam as…

A: Given: For water:     m1 = 7.2 kg/s     T1 = 20 °C For saturated vapor    m2 = 0.35 kg/s For mixed…

Q: A piston cylinder device is fitted with stops at the top. Initially.5lbs of R-134a is in the tank at…

A: Given: The mass of refrigerant, m = 5 lbs The initial temperature of the tank, T1 = 80 F = 26.66°C…

Q: Air enters an electric furnace at 100 KPa and 28°C with a volume flow rate of 22 m3/min. At the exit…

A: Given data: P1=100 kPaT1=28°C=301 KQ˙=22 m3/min=0.3667 m3/sV1=3.7 m/sd1=d2=16 cmd3=0.3 m Need to…

Q: Air at 15°C and 100 kPa occupies 0.03 m³. The air is heated at constant volume until the pressure is…

A:

Q: The water vapor that is 3.00 MPa and 540°C goes through a pipe with a 0.40 m^2 cross sectional area…

A:

Q: Argon enters a turbine ayt 900 kPa and 450 0C at a rate of 2.90 kg/s and leaves at 150 kPa and 270…

A: Given that, From the property table of argon, the enthalpy at given pressure and temperature can be…

Q: (a) A garden hose attached with a nozzle is used to fill a 20-gallon bucket. The inner diameter of…

A:

Q: n a place where the outdoor air temperature is 30°C, the air is compressed from its current…

A: Given , Inlet air temperature , T1 = 30 C = 303 K Outlet pressure , P2 = 800 KPa Flow rate of air ,…

Q: The specific heat ratio of a gas is 1.4. Gas is entering through nozzle at 800 °C and 900 kPa. Exit…

A:

Q: Problem 2 Refrigerant R-134a enters an adiabatic compressor at 60 kPa and -10 °C with a volume flow…

A:

Q: Air at 70 kPa, 27°C, and 220 m/s enters a diffuser at a rate of 2.5 kg/s and leaves at 42°C. The…

A: Given       Mass flow rate, m =2.5 kg/s       Entry velocity, v1 = 220 m/s        Area, A = 400 cm2…

Q: A steam plant. the pressure levels are 10 kPa and 6000 kPa, and the steam leaves the turbine as…

A:

Q: Refrigerant-134a enters an adiabatic compressor at -26°C as a saturated vapor at a rate of 0.45…

A:

Q: An adiabatic expansion of air occurs through a nozzle from 120 psia and 96o F to 20 psia. The final…

A: Given data Inlet pressure ( P1)=120psia= 827.371kPa Outlet Pressure (P2)=20psia= 137.895kPa Inlet…

Q: The gas turbine unit is rejecting heat at certain rate but your client is unsure about it. To…

A:

Q: Consider 2 kg of air has a decrease of internal energy of 25 kJ during a reversible non flow…

A: Given that: m = mass of air = 2 kg decrease in internal energy is -25 kJ. The process follows…

Q: Water vapor enters a nozzle at 400 °C and 800 kPa, with a speed of 10 m/s, and leaves at 375 °C and…

A: Given data and to be determined variables. T1=400 °CP1=800 kPaC1=10 m/sT2=375 °CP2=400 kPaQl=25…

Q: velocity and exits at 1 MPa and 347°C with a velocity of 90 m/s. The compressor is cooled at a rate…

A:

Q: Define the system to be a container full of steam. If the steam condenses, did the system hae a…

A: Steam is a substance that is a gaseous phase of water. The steam can be generated by evaporation or…

Q: The refrigerant R-134a enters the compressor of a refrigeration machine at a pressure of 140kPa and…

A:

Q: he refrigerant R-134a enters the compressor of a refrigeration machine at a pressure of 140kPa and a…

A:

Q: (Q3) Refrigerant-134a enters a compressor at 240 kPa and 70°C at a rate of 2.05 m³/s and leaves at a…

A: