An ideal Brayton cycle has a net work output of 150 kJ/kg and a backwork ratio of 0.4. Now, considering that both the turbine and the compressor have an isentropic efficiency of 85%, calculate: a. The work of each of the turbine and compressor for the ideal case b. The work of each of the turbine and compressor for the non-ideal case. c. the net work output of the actual cycle

An ideal Brayton cycle has a net work output of 150 kJ/kg and a backwork ratio of 0.4. Now, considering that both the turbine and the compressor have an isentropic efficiency of 85%, calculate: a. The work of each of the turbine and compressor for the ideal case b. The work of each of the turbine and compressor for the non-ideal case. c. the net work output of the actual cycle

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Required information. The net work output and the thermal efficiency for the Carnot and the simple ideal Rankine cycles with steam as the working fluid are to be calculated and compared. Steam enters the turbine in both cases at 10 MPa as a saturated vapor, and the condenser pressure is 50 kPa. In the Rankine cycle, the condenser exit state is saturated liquid and, in the Carnot cycle, the boiler inlet state is saturated liquid. Draw the T-s diagrams for both cycles. (Please upload your response/solution using the controls below.) upload a response file (15MB max) Choose File no file selected save
An ideal Brayton cycle has a net work output of 150 kJ/kg, and a recoil work ratio of 0.4. Determine the net work production of the cycle, if both the turbine had an isentropic efficiency of 85% and the compressor 78%.
Two ideal Brayton cycles (see Figure below) have the same inlet temperature and the same maximum temperature of the turbine inlet. Brayton Cycle A has a higher compression ratio than Cycle B. Which of the following statements is true about the cycles? Cycle A has a higher thermal efficiency and Cycle B has a higher work net for a given mass flow rate. Cycle B has a higher thermal efficiency and a higher work net for a given mass flow rate. Since the temperatures are the same the efficiencies and work net are also the same. Cycle A has a higher work net for a given mass flow rate and Cycle B has a higher thermal efficiency. Cycle A has a higher thermal efficiency and a higher work net for a given mass flow rate.
Q3: The 500-1b cylinder is supported by three chains as shown. Determine the force in each chain for equilibrium. Z 135⁰ 90° 1 ft 41359 B 18 ft 500 lb y
Consider an ideal Rankine cycle with reheating as shown. Steam enters a high-pressure turbine at 6 MPa and 440°C and expands to 0.5 MPa then reheated to 400°C. The condenser pressure is 8 kPa. • Calculate the quality at the exit of the low-pressure turbine, x6 = • Calculate the work produced by the low-pressure turbine in kJ/kg • Calculate the heat transfer in reheating (greheat) in kJ/kg = Boiler Turbine 3 QH 5 Condenser 87.3% || 89.0%||| 91.1% | 94.3% || 95.9% || 99.0% 763 |805 || 832 || 851878 || 901 513 556| 581 665 | 697|| 758
H.W2: An air-standard Carnot cycle is executed in a closed system between the temperature limits of 350 and 1200 K. The pressures before and after the isothermal compression are 150 and 300 kPa, respectively. If the net work output per cycle is 0.5 kJ, determine (a) the maximum pressure in the cycle, (b) the heat transfer to air, and (c) the mass of air. Assume variable specific heats for air. Answers: (a) 30,013 kPa, (b) 0.706 kJ, (c) 0.00296 kg
A simple Bravton cycle operates between the pressure limits of 100 and 2000 kPa. The working fluid is air which enters the compressor at 40 "C at a rate of 4 kg/s and enters the turbine at 1400 °C. The compressor is ideal (i.e., n= 100%) and the turbine has an isentropic efficiency of n= 90%. For this problem, assume that air is an ideal gas with constant specific heats (R= 0.287 kJ/kg-K, C, = 1.005 kJ/kg-K, C, = 0.718 kJ/kg-K, k= 1.4). %3D (a) Determine the net work output, in kW. (b) Determine the thermal efficiency of the cycle. Heat exchanger Compressor Turbine Heat exchanger Jout
An ideal Otto cycle has a compression ratio of 8. At the beginning of the Compression process, air is at 100 kPa and 17°C, and 800 kJ/kg of heat is Transferred to air during the constant-volume heat-addition process. (a) the maximum temperature and pressure that occur during the cycle, (b) The net work output, (c) the thermal efficiency, and (d) the mean effective pressure for the cycle. P. kPa Isentropic 4 in Isentropic 100 Jour V₁ = V₁