An experimental UAV is to be equipped with two engines with ideal cycle efficiency of 95% and 90%. The engine follows the fundamental principles of cyclic processes. Each engine is to be rated with 1800 watts-hour of work developed. Determine the following: a. The heat supplied b. The ratio of heat supplied to heat rejected c. the ratio of work developed to heat rejected on each engine

Q: The maximum temperature that can be reached in a dual-combustion cycle is 2000°C, and the pressure…

A:

Q: A steam power plant operates on a Rankine cycle as shown. II all kinetic and potential energy…

A: Given that, Pressure at 2-3 process, P2=P3=3 MPa,Pressure at 4-1 pressure, P4=P1=50 kPaTurbine at…

Q: Evaluate the performance of gas power cycles for which the working fluid remains a gas throughout…

A: The gas power cycle deals with a system whose working fluid remain in the gaseous stare throughout…

Q: Draw the T-P and T-s diagrams of the Carnot engine cycle

A: Temperature Pressure (T-P) and Temperature Entropy diagrams for Carnot engine cycle are drawn below.…

Q: Consider an ICE operating at constant rpm because it powers an electricity generator. Does this…

A:

Q: Stirling engine to perform 20 kJ of work per cycle.  How large would the engine need to be with a…

A: Given:W=20 KJ∆T=300°Cr=2.3

Q: heat rate

A: From steam table At 5MPa and 450oCh3=3317.2 kJ/kgs3=6.8210 kJ/kgK Process 3-4 is isentropic…

Q: In the Rankine cycle for a steam power plant the turbine entry and exit enthalpies are 2803 kJ/kg…

A: Given, Enthalpy at turbine inlet = ht1 = 2803 kJ/kg Enthalpy at turbine exit = ht2 = 1800 kJ/kg…

Q: A- 500 MW diesel engine power plant has an overall efficiency of 80%, calculate the fuel consumption…

A: To calculate the fuel consumption in liters per hour (L/hr) for a 500 MW diesel engine power plant…

Q: 15. Determine the maximum temperature of a Carnot cycle if it operates at a minimum temperature of…

A:

Automation in manufacturing processes

The term automation refers to the technique through which the creation of an apparatus takes place using an automatic process or a system. Let us try to understand this with an example.