An enclosed rectangular concrete vault with outside dimensions 2 m x 1 m x 1.5 m and wall thickness 10 cm is buried with the top surface even with the ground surface. Will the vault tend to rise out of the ground if the ground becomes completely saturated with water? Use Sconcrete = 2.4.

Q: 7. A shallow square foundation with the dimension of 2.5m by 2.5m is constructed at a depth of 1.5m…

A:

Q: Referring to the retaining shown in the drawing, what is the total height on which the active force…

A: Given- A retaining wall with inclined backfill at a angle of 12°. Required- To calculate the height…

Q: A shear force of V = 410 kN is applied to the box. The wall thickness is 13 mm. Using thin wall…

A: The Shear Force will induce a shear flow in the box. For a thin walled box structure, the shear flow…

Q: If the tubular shaft has an allowable shear stress of 65MPa, determine the required wall thickness…

A: It is given that : allowable shear stress of 65MPa outer diameter of the shaft is150mm. To Find -…

Q: What would be the change ineffective stress at point A if the water table rises to 2m above ground…

A: Effective stress:- The ratio of soil particle force to surface area is known as effective stress.…

Q: 1. Volume of excavation for the foundation with depth 0.2 m 2. The amount of construction materials…

A: All the details of the plan and footing are given in question.We will use long-wall short-wall…

Q: At a temperature of 0 ̊C, a precast wall made of low-strength concrete just fits between two rigid…

A: Since the temperature rises to 35oC, hence the change in temperature is, ∆T=35-0=35°C We know,…

Q: A 4m high vertical wall supports a saturated cohesive soil p =0 with horizontal surface. The top…

A: Answer To find the Total active pressure on the wall based on the given data we have Pa =…

Q: A torque of 1250 N-m is applied to the rectangular section shown in the Figure above. Determine the…

A: To determine the wall thickness t (mm) for the given allowable shear stress.   Given, Torque…

Q: 12.13 Refer to Problem 12.3. behind the wall. a. Draw the Rankine passive pressure distribution…

A:

Q: A concrete wall is 1.2 meters high and 0.203 meters thick. Concrete has a specific gravity of 23,7…

A:

Q: find the hydrostatic force acting on the 1 m wide cover ABC R=1.1 H=4.2 h2=2.5

A: Width = 1m R = 1.1 m h2 = 2.5 m H = 4.2 m Find the hydrostatic force acting on the 1 m wide cover…

Q: * Draw the active earth pressure diagram, calculate the magnitude and location of the active earth…

A:

Q: 1) Calculate the vertical induced stress (Ao) at point A in the two cases below. In both cases, the…

A:

Q: Determine the coefficient of active pressure Ka. Answer:

A: The active earth pressure is the pressure cause by the soil which tends to move retaining wall or…

Q: A 300 mm thick footing slab supports a 300 mm thick concrete wall carrying uniform service dead load…

A: Given: The thickness of the footing slab is 300 mm. The thickness of the wall is 300 mm. The dead…

Q: What is flooded tension crack? Why it occurs in Clay soils and not in sandy soils?

A: (Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: Situation 12- Wooden planks 300 mm wide by 100 mm thick are used to retain soil soil exerts a…

A:

Q: H = 8m x₁ = 0.40m x₂ = 0.60m Soil properties: Y₁ = 16.80kN/m³ Y2 = 17.60kN/m³ x₂ = 1.50m x₁ = 3.50m…

A: To find-  The magnitude of pressure at the base of the heel.

Q: 3m R=1.2m R=1.2m Find the length of given figure above All dimensions Are c/c Wall thickness=0.4m…

A:

Q: The standard acceptable 28-day compressive strength of 150mm clay masonry hollow units in MPa (on…

A: This is a standard result so the answer will be according to the standard codes.

Q: The ratio of the Boussinesq's influence factor to Westergaard's influence factor at point 0 (2 m…

A: The ratio of the Boussinesq's influence factor to Westergaard's influence factor at point 0 ( 2m…

Q: A 60-meter building is subjected to horizontal wind loads exerting uniform pressures on the vertical…

A: Wind load is the weight put on the outside of a structure by wind in pounds per square foot. This is…

Q: Calculate the total stress, pore water pressure, and effective stress at the center of the strata.…

A: To find effective stress at center of strata

Q: The soil next to a basement wall has a unit weight of 115 lb/ft³. If Ko is 0.6, what is the…

A: A soil profile outside a basement is given Unit weight of soil, γ =115 lbft3 Coefficient of earth…

Q: A retaining wall is to be constructed shown below. It has the following information: Soil Parameters…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: please help me step by step solve thank you

A: Given- A=6B=2Q=6×100Q=600 Kn-mM=2×300 Kn-mM=600  Kn-mFOS=3e=Hqe=3100e=0.03m

Q: Define the vertical Stress Caused by a Rectangularly Loaded Area ?

A: Vertical stresses:- Vertical stresses are the stresses which develops in the soil are due to weight…

Q: Q2: For the following soil profile and retaining wall condition shown, find the active earth force…

A:

Q: a building will have a sitting wall on the north side of the building to allow for seating during…

A: wall height = 1.5 meter Gamma dry= 18.3 kN/m^3gamma buoyant =11.5 Kn/m^3gamma water= 9.81 kN/m^3…

Q: - Determine the Rankine active force, Pa, per unit length of the wall and the location of the…

A: Thank you for the question. As per Bartleby guidelines, we are allowed to answer one question at a…

Q: 1. Determine the normal stress caused by the load in the drawing below. The cylinder is hollow with…

A: Given:- The outside radius of the hollow cylinder = 6 in The inside radius of the hollow cylinder =…

Q: N/m and service live load of 145.94 n the ground surface. Design paran m³, qa = 215.46 kPa, f’c = 27…

A: data we have thickness of wall = 300mmthickness of footing slab =300mmservice load DL =…

Q: The figure below shows a triangular retaining door holding acetone. Sketch the pressure distribution…

A:

Q: A is 6 storey building will be constructed on a clay deposit. Its foundation will be 3 m depth which…

A: Given  depth of the foundation = 3m No. of stories = 6 plan dimensions = 25×25 Pressure P = 90kpa…

Q: Exercise 2: Draw the shear and bending - moment diagrams for beam AD. Also determine the maximum…

A: Given Data: The diameter of all pulleys is 600 mm.   To Determine: Draw the shear and bending moment…

Q: The lintel of prestressed reinforced concrete in the figure below is 1.50 m long. The concrete…

A: Given data Length of concrete, LC=1.50m young modulus of concrete, γc=3×1010 N/m2 cross-sectional…

Q: 1. An open top standpipe as shown has a radius r = 1.5 m and 30 mm wall thickness. Determine the…

A:

Q: 1. The cross section of a continuous one way slab in a building is shown in the figure. The slabs…

A:

Q: A 150 mm clay reinforced masonry wall of vertical cell units has an effective high tensile steel…

A: Given:- The width of the clay reinforced masonry wall = 150 mm  An effective high tensile steel area…

Q: Assignment 5: A rectangular brick pool was constructed using MU10 brick and M10 cement mortar with a…

A: approx height of wall

Q: Calculate the total stress, pore water pressure, and effective stress at the center of the strata.…

A: To find effective stress at center

Q: Compute the hydrostatic force acting on surface ABC exerted by water. Given wall width as 2 m.

A: Question is based on the surface ABC covered with water . Width of wall and depth from surface are…

Q: A building with a basement is to be constructed in saturated loose silt.. The foundation consists of…

A: It is required to determine the maximum applied pressure. Qmax=γ×D Here γ is the saturated unit…