An electric shower is capable of heating water from 10 C to 55 "C when the flow rate is 0.0400 kgs. calculation Calculate the minimum power of the heater. Give your answer in kW.
Q: Let us use a heat pump to cook dinner! You set up a heat pump that has 40 % of its theoretical…
A:
Q: 2. A 150W solar PV panel produces 15V and 7A when it is connected to a load under solar insolation…
A:
Q: How much work (in J) is required to expand the volume of a pump from 0.0 L to 1.5 L against an…
A:
Q: Calculate the net work output of a heat engine following path ABCDA in the figure below.
A:
Q: What volume of water at 0°C can a freezer make into ice cubes in 1.0h, if the coefficient of…
A:
Q: A heat engine performs 613 J of work in each cycle and has an efficiency of 0.2. For each cycle, how…
A: Answer : We know the efficiency of a heat engine is : η = Work done…
Q: A heat engine takes in 1500 joules of heat at 2000K and rejects 950 joules of heat at 1000K. Find…
A: Given : W1 = 1500 J T1 = 2000 K W2 = 950 J T2 = 1000 K
Q: Determine the NPSH availalbe when a pump draws gasoline at 30°C (sg-0.65) from an underground tank…
A: To determine the NPSH (Net Positive Suction Head) available, we need to use the following formula:…
Q: A single-stage single acting air compressor takes air in at 1 bar & delivers at 5.5 bar. Work done…
A: Let W denotes the work done in each cycle, n denotes the r.p.s. of the compressor, and P denotes the…
Q: An engine with 12% efficiency does 125J of work in each cycle. How much heat is absorbed in each…
A: Efficiency of the engine = 12 % ∴ e =0.12 =WQhwhere W= work done in each cycle =125 J Qh…
Q: A Carnot heat engine receives heat from a thermal energy reservoir at 1150°C and has a thermal…
A:
Q: The efficiency of a Carnot heat engine is 25%. It takes 4000 J of heat input. What is the heat…
A:
Q: In order not to damage the resistance in the kettles, the difference between the temperature of the…
A:
Q: When ____ is added to a system, some of the energy stays in the system and some of the energy leaves…
A: Answer:- Heat energy When heat energy is added to a system, some of the energy stays in the…
Q: (b) How much heat in kilocalories would it pump into the warm environment if 3.60 x 107 J of work…
A:
Q: A heat engine, receives IMW of heat from a heat source at 600°C and rejects 700 kW of heat to a low…
A: Here, Temperature of source is 600°C and that is for the sink is 30°C.Q1=1MW=1000kWQ2=700 kWAnd it…
Q: A 220-volt 2 ampere electric kettle contains 5 kg. of water at 21° C. It is required to bring it to…
A: Step 1 The efficiency of the kettle can be calculated using the standard formula as below, Here…
Q: Explain about Non-conservative Forces and Internal Energy in a Tire.
A:
Q: 50 g of water is split into hydrogen and oxygen using electrolysis at 27oC. Calculate the work done.
A: Given: mass of water = 50 g temperature T = 27o C = 27+273 =300 K Knowns: atmospheric pressure P…
Q: My Vitamix blender can make hot water mechanically. The blender takes 32 oz of water at 25DegC and…
A:
Q: Consider the following 3-reservoir problem. All pipes are ductile iron (k₁-2.60 x 10). The water is…
A: It is given thatHere h= head loss due to frictionf=friction coefficient
Q: A household installed heat in solar panels with 2.5 kw h has an efficiency of 85.5% what is the…
A:
Q: g of water is split into hydrogen and oxygen using electrolysis at 27oC. Calculate the w
A: Given values:- Mass of water,(m)=50 g=0.05 kg -----(1) Latent heat of water,(c)=540 J/kg-0C ----(2)…
Q: If there were no process, then there would be no need for ____ in a system.
A: To determine: What happens if there were no process in a system
Q: Write a note on “ENTROPY”.
A: Entropy can be defined as the measure of randomness or molecular disorderness of a system. It is an…
Q: A certain heat engine does 9.2 kJ of work and 8.5 kJ of heat is transfered to the environment in a…
A: Thus the net work done by the system equals the net heat transfer into the system, or W=Q1−Q2…
Q: A heat engine extracts 45.0 kJ from the hot reservoir and exhausts 40.0 kJ into the cold reservoir.…
A: The work done by heat engine: W=QH-QC Efficiency η=1-QCQH Given QC=40kJ QH=45kJ
Q: Assume that the turbines at a coal-powered power plant were upgraded resulting in an improvement in…
A: Heat and work are two forms of energy. Heat transfers from high temperature region to low…
Q: If 40 million Joules of energy is put into the hot reservoir and the engine transfers 22 million…
A: Given Data:- Energy put into the hot reservoir is QH=40 million Joules Energy transfered to the cold…
Q: If 370 J of work is performed with 45% efficiency, what is the amount of energy that goes into…
A:
Q: A heat pump removes 2060 J of heat from the outdoors and delivers 3060 J of heat to the inside of a…
A: Given data The heat removed by the pump is QL=2060 J The heat delivered by the house is QH=3060 J…
Q: A 3 ohm heater takes 6 amperes while submerged in 1200 grams of water contained in a vessel with a…
A: Given:- m= 1200 g = mass of water mo= 200 g = water equivalent of vessel S= 4.184 J/g-°C = specific…
Q: Energy may be stored for use during peak demand
A: (b) (i) Energy required each night E = mgh = 1.35 X 105 X 9.8 X 135 = 178605000 J = 1.78605 X 108…
Q: An electric kettle was marked 500 Watt, 230 volt and was found to bring one kg of water at 15 degree…
A:
Q: 1. An engine with an efficiency of 0.2 absorbs 485J of heat per cycle. (a) How much work does it…
A:
Q: An engine absorbs 500 J of heat and reject 100 J of heat to cold reservoir in each cycle. What is…
A: Given data: The amount of heat absorb is QH=500 J. The amount of heat reject is QL=100 J.
Q: Q3/ a/ IIRNACE On= 80MW net,out НЕ OL = 50 MW RIVER Determine thermal efficiency
A:
Q: b) Energy may be stored for use during peak demand by pumping water to a high reserveir when needed.…
A: Given: The height is h=135 m. The time is t=10 h. The rate is r=1.35X105 kg/s. Part (i) The…
Q: Consider a heat engine transferring energy from a warm region (Tw) to a cool region (Tc) . Which…
A: The efficiency of Carnot is given by η=1-TcTw where Tc and…
Step by step
Solved in 2 steps