An automobile lift in the Nizwa service station raises 6.6 kN car of 3.6 m above the ground floor level,As shown in the below given figure , If a hydraulic actuator has a piston of diameter 329 cm . Find the following: (a) Work necessary to lift the car vehicle (b) Required Pressure to lift the car. (c) Power needed to the raise the car in 0.6 minutes (d) Speed of the the lift for 545 m3 per minute ( (e) Required flow rate for the vehicle to descend in 8.2 seconds.

Q: An automobile lift in the Karsha car wash and service station raises 5.6 kN  car of 2.4 m above the…

A:

Q: Nizwa service station raises 6.6 kN  car of 3.4 m above the ground floor level,As shown in the below…

A:

Q: You were asked to design and manufacture a manual hydraulie device (as shown in the figure) to lift…

A: Given data:

Q: In an open vessel, a certain volume V of water is perfectly agitated by means of an impeller 20 cm…

A: Diameter of the impeller, D=20 cm,Speed of the impeller, N=150 rpm,Density of water, ρ=1000 kg/m3…

Q: This is unit analysis. Explain and Plot the whole process why the head(h) arrive in meter(m) unit…

A:

Q: Suppose the master cylinder in a hydraulic system is at a greater height than the slave cylinder.…

A: Understand that the pressure is defined as the ratio of the force applied to the cross-sectional…

Q: A 5000 N weight is pulled up on an inclined surface at a constant speed by a cylinder as shown in…

A:

Q: Q3: The cylinder shown in Fig. (2), Ayn7.012cm, has two pistons mounted, the upper one, ma =100kg,…

A: The area of cylinder Acylinder=7.102 cm2. The  mass of upper pistion  mp=100 kg. The  mass of upper…

Q: Q3: The Figure shows a horizontal pipe used to provide a fluid from a container. The pipe inlet…

A: Given: Pipe pressure P1=150kPaInlet diameter D1=1cmOutlet diameter=2.5cm

Q: Explain the concept of the effect of i. Shifting a mass within a body ii. Adding a mass to a body…

A: As per policy i have solved first 3 for you.   Explain the concept of the effect of-  Shifting a…

Q: Figure 4 shows the hydraulic circuit to perform work with the piston. The pump extracts oil (sg…

A: Given: Specific gravity of the oil is 0.92. The internal diameter of the cylinder is 12 cm. Length…

Q: . The hydraulic system of a backhoe is used to lift a load asshown in Figure 11.45. (a) Calculate…

A: To determine (a) The force that the slave cylinder must exert to support the load and the weight of…

Q: The ram and plunger of a hydraulic press are 150 mm and 25 mm in diameter respectively. With a…

A:

Q: An investment cost for the wind power system is RM 5000 with the annual maintenance costs are RM…

A: Given : D = 30 m P = 400 kWh v = 7.5 m/s ρ=0.602 kg/m3 To find : Efficiency

Q: Task 11 Determine a force P which is required to raise a cone of a weight G which closes the outflow…

A:

Q: lift (elevator) in a tall building is operated by an electric motor as shown in Figure QB3. The lift…

A:

Q: Size the supply circular duct system shown in figure below using equal friction method with pressure…

A: Given that  Size the supply circular duct system shown in figure below using equal friction method…

Q: A pump continuously transports water to an open tank for 12 hrs everyday. If the theo. horsepower…

A: Given that: A pump runs 12 hours everyday Theoretical horsepower for the process = 4 hp Pump…

Q: An effort of 2 kN is required just to move a certain body up an inclined plane of angle 15°, the…

A:

Q: Q) A shaft has a number of collars, external diameter of each is 35 cm and the shaft diameter is 20…

A:

Q: A vertical rectangular sluice gate at the bottom of the dam is 0.60m wide and 1.8m high and…

A: Width of the gate, b= 0.60 m Height of the plate, h= 1.8 m Height of water above the center of the…

Q: If the piston mass is 20 kg and the car mass with its base is 400 kg, what will the minimum pressure…

A: we need to calculate minimum pressure required to lift the car

Q: A jet of freshwater strikes a series of vanes of a turbine at 25° with the direction of motion and…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: ) Required Piston area and its diameter (b) The necessary pump discharge (c) The hydraulic power…

A:

Q: The client is procuring a new hydraulic lifting jack. The jack is rated to lift 2000kg. Given that…

A: Solution: Given Data: m=2000 kgdp=25 mmdl=40 mm   To Find: a) The force needed on the pumping piston…

Q: A train has a weight of 100 tons (2,000lbf) is stopped from 4 mph in 1 ft by a hydraulic cushion.If…

A:

Q: Problems. 1. In the figure shown, a horizontal rectangular tank is to be filled by a liquid whose…

A: Dear student,                     According to the guidelines, I am allowed to answer only one…

Q: Q4. A worker manually lifts trays of clean dishes of a 20-lbs from a conveyor at the end of a…

A: We can analyze that , At the origin of the lift, the horizontal distance (H) 20 inches, the vertical…

Q: 4.27 A reaction turbine produces 5600 hp while operating at 260 rpm and a head of 60 ft. It is…

A: CAVITATION: Cavitation is the arrangement and imploding of pits or air pockets in a fluid generally…

Q: A69 A typical escalator in the London Under- ground rises at an angle of 30 to the horizontal. It…

A: Given: Vertical height (h)=15mTime taken by the escalator to reach h=1min or 60secNumber of people…

Q: Q) The diameters of a frustum of cone of a pivot bearing of a shaft are 30 cm and 60 cm and its…

A: The answer is givem below

Q: A very tall 10-cm-diameter vase contains water at a depth of 6 cm. When spun steadily to achieve…

A: Given data as per the question Diameter = 10 cm Depth =6 cm

Q: As shown in the picture blew, a pump can deliver volume flow rate of Q=3.6 × 10-³ m³/s of water…

A: Given data Flow rate = 3.6 ×10^(-3) m^3/sec h= 8.0 m hL= 1.0 m Find the power delivered by the pump.

Q: The system given in the figure is compressed in accordance with the P-sb process under mass m (300…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A hydraulic cylinder is to compress a vehicle body in 17.45 seconds,The operation requires a stroke…

A:

Q: Necessary Work to lift the car vehicle  (in J) (b) Required Pressure to lift the car.in pascal…

A: