An area of 10 km x 20 km is to be surveyed using aerial photogrammetry. Average scale of photograph is 110.000 at ground elevation of 400 m above the datum. Focal length of camera used is 20 cm and size of photographs are 23 cm x 23 cm. The speed of aircraft is 270 kmph. The forward lap in photographs is 70% and side lap is 30%. Determine the flying height, exposure interval and number of photographs required to complete the survey

An area of 10 km x 20 km is to be surveyed using aerial photogrammetry. Average scale of photograph is 110.000 at ground elevation of 400 m above the datum. Focal length of camera used is 20 cm and size of photographs are 23 cm x 23 cm. The speed of aircraft is 270 kmph. The forward lap in photographs is 70% and side lap is 30%. Determine the flying height, exposure interval and number of photographs required to complete the survey

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A flagpole appears in two successive photographs taken at an altitude of 2,000 m above datum. The focal length of the camera is 120 mm and the Length of the air base is 200 m. The parallax for the top of the pole is 52.52 mm and for the bottom is 48,27 mm. Find the difference in elevation between the top and the bottom of the pole,
Question In a closed loop traverse of 1 km total length, the closing errors in departure and latitude are 0.3 m and 0.4 m respectively. The relative precision of this traverse will be A 1:2000 B 1:3000 1:4000 D 1:5000
A student used the breaking tape method in determining the horizontal distance of a sloping terrain AB. Using a clinometer, he found out that the HD = 5.882VD. He also measured the sloping distance of the terrain and obtained a value of 34.165 m. Find the following: a) percent slope of the sloping terrain AB b) horizontal distance between points A and B c) difference in elevation between point A and B
Determine the y-coordinate of the centroid of the shaded area. y 0.25h 69° 69° Answer:y = i h Save for Later Attempts: 2 of 3 used Submit Answer
An elevation must be established on a benchmark on an island that is 2536.98 ft from the nearest benchmark on the island’s shore. The surveyor decides to use a total station that has a stated distance measuring accuracy of (3 mm +3 ppm) and a vertical compensator accurate to within 0.4”. The height of instrument was 5.37 ft with an estimated error of 0.05 ft. The prism height was 6.00 ft with an estimated error of 0.02 ft. The single zenith angle is read as The estimated errors in instrument and target centering are 0.003 ft. If the elevation of the occupied benchmark is 632.27 ft, what is the corrected benchmark elevation on the island? (Assume that the instrument does not correct for Earth curvature and refraction.) After completing the job, the surveyor discovered that the instrument had a vertical indexing error that caused the sight line to be inclined by 15. (a) How much error would be created in the elevation of the island benchmark if the indexing error were ignored? (b) What…
Which statements about the Global Positioning System (GPS) are true(multiple choice questions)A.The plane error is smaller than the elevation errorb.Static measurement is more accurate than dynamic measurementc.using geostationary satellitesD.distance intersection method
1. Compare and contrast: a Active vs. Passive Remote Sensing b. Linear swath vs. Optical mechanical scan c. Internal vs. External parameters d. Perspective vs. Orthographic projections e. Single Image Photogrammetry vs. Stereopairs
2/A- The following data were obtained by stadia observation: zenith angle = 81° 50', s = 2.50 ft. The stadia interval factor is known to be 0.75 and K = 1 ft. Calculate H and V. 02/B- The following table gives the Departure Latitud
1) 2 points B & C were observed from point A where the instrument was set up at a height of 1.25m. Points B & C are ahead of point A. The surveyor used an internally focusing telescope with a stadia interval factor of 100. The table below shows the data recorded as observed for points B & C. Answer the following. (Show complete figures and solutions) a) What is the stadia constant of the instrument? b) What is the slope distance between the telescope at point A and the rod reading at point B? c) What is the difference in elevation between point B & C? d) What is the slope distance between the ground surface at point B and the ground surface at C? e) What is the elevation of point C if point A is at an elevation of +0316.15m above mean sea level? - 1 attachment Vertical Stadia Hair Readings ROD/Point Angle Upper Middle Lower В -25°15' 2.316 1.877 1.438 -45°57' 3.333 2.011 0.689
An elevation must be established on a benchmark on an island that is 2536.98 ft from the nearest benchmark on the island’s shore. The surveyor decides to use a total station that has a stated distance measuring accuracy of (3 mm +3 ppm) and a vertical compensator accurate to within 0.4”. The height of instrument was 5.37 ft with an estimated error of 0.05 ft. The prism height was 6.00 ft with an estimated error of 0.02 ft. The single zenith angle is read as The estimated errors in instrument and target centering are 0.003 ft. If the elevation of the occupied benchmark is 632.27 ft, what is the corrected benchmark elevation on the island? (Assume that the instrument does not correct for Earth curvature and refraction.) What is the estimated error in the computed benchmark elevation if the instrument has a DIN 18723 stated accuracy of +-3"?
The interior angles X, Y, and Z of a triangular traverse were measured with the same precision. The results were as follows: Station Interior Angle No. of measurement X 410 3 Y 650 4 Z 750 2 Determine the most probable value of the interior angles.
A backsight reading of 2.73 m is taken on point A and subsequently a foresight reading of 1.35 m is taken on point B from a level station established midway between the points. The difference in elevation between points A and B is