An analog voltage (0 to 5) volt is to be converted to 8 bit digital form. a. What is the resolution in volt. b. What is the digital representation of 2.2 volt. c. What is the largest quantization error as a percentage to full scale. d. What is the error made in quantization of 2.2 volt as a percentage of the input.

An analog voltage (0 to 5) volt is to be converted to 8 bit digital form. a. What is the resolution in volt. b. What is the digital representation of 2.2 volt. c. What is the largest quantization error as a percentage to full scale. d. What is the error made in quantization of 2.2 volt as a percentage of the input.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

List out the five quality measures for silicon wafer requirements
Q4) If fr is the frequency of the fundamental component of the output ripple, then for full bridge rectifier, the output frequency fo in respect to input frequency fi is Ofr=fo=2fi Ob.fr=fo%3D3fi Ofr=fo=D4fi Ofr=fo=fi
The resolution of a 12 bit analog to digital converter in percent is ?
6.q1
14 Which of the following is true? O Most often, the PFC circuit is a combination of diode rectifier circuit and single-phase inverter. O Most often, the PFC circuit is a combination of diode rectifier circuit and boost converter. O Most often, the PFC circuit is a combination of diode rectifier circuit and full-bridge DC-DC converter. Most often, the PFC circuit is a combination of thyristor rectifier circuit and DC-DC converter.
Please answer the questions 1 c, and d with details on why it is true or false. Please make handwriting legible. Thank you.
State whether the following statement is true or false. “When an LDO is used as a sub-regulator in cascade with a switching regulator for stepping down the input voltage, it is more efficient to design the LDO to have a large step-down ratio of the two.” Reference Book :
1- Connect the half-wave rectifier with resistive load (RL=1KΩ ) and setthe parameters value of peak amplitude equal (220) volt, frequency equal(50) HZ.2- Draw the output waveform for the DC output and the r.m.s value of theoutput voltages.3- What is the value of the peak inverse voltage on the diode in half -waverectifier?
4- What is the effect of adding capacitor in parallel to the load at the rectifier output? Note: Please do not handwritten.
If forward bias flyback diode voltage drop is0.6 Vand Q1 switches off, what will be the maximum voltage that the transistor Q1 will be subject to? [express your answer in V] Answer:
chose the correct answer for the following:1-An SCR is semiconductor device which consists of:a.Four PN junctionsb. Three PN junctions c. Two PN junctions d. One PN junction-------------------2-Relay control is one of the ....................... applications.a.Triac b. Darlington c. SCR d. Diac
Briefly explain the basic concepts of transistors and diodes can function as logic gates! Please Answer with explanation and full Step thank u.... I'm needed in 30-60 minutes...