An AM-DSB-LC modulator has a carrier frequency of (fc) Hz, with amplitude of (Ac) volt, and the modulating single tone signal has a frequency of (fm) Hz, with amplitude of (Am) volt. For this system determine: The modulation index?* The upper sideband frequency* The lower sideband frequency?* The upper sideband power?* The transmission efficiency?* Note Fc 64492 Ac 31 Fm 9850 Am 15.94

An AM-DSB-LC modulator has a carrier frequency of (fc) Hz, with amplitude of (Ac) volt, and the modulating single tone signal has a frequency of (fm) Hz, with amplitude of (Am) volt. For this system determine: The modulation index?* The upper sideband frequency* The lower sideband frequency?* The upper sideband power?* The transmission efficiency?* Note Fc 64492 Ac 31 Fm 9850 Am 15.94

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

[Q2] Answer the following: (a) Explain the effect of the value of u on the modulation quality of AM-DSB-LC. (b) Explain the frequency conversion of the carrier.
Does a PCM signal have a smaller bandwidth? Why or Why not?
a. Sketch the transfer curve for the device in the figure below. b. Determine IDg and VGSQ using the transfer curve c. Calculate Ipo and VGSQ for the circuit below 12 V 1.2 ka loss = 12 mA Vaso V =-4V 1 MA 1.5 V.
3. The role of mixer in the Armstrong modulator is to. a) raise the carrier frequency b) lower the carrier frequency c) to change the carrier frequency to any required value For AMDSB-SC, The carrier is suppressed using a) A mixer b) A frequency multiplier c) A balance modulator 5. In FM modulation, frequency deviation is equal to .........., if the amplitude of the modulating signal is 4 V, and the frequency sensitivity of the modulator is 30 Hz/V. a) 120 Hz b) 34 Hz c) 100 Hz 6. A voltage controlled oscillator (VCO) is an oscillator that its frequency output is varied according to any change in the ............... at its input. 4. a) Frequency b) Current c) Voltage Q1: (B) Draw A block diagram to generate the SSB using Hilbert Transform method, Write an equation for an input, and output signals?
Q2. For the scheme shown in Figure Q2, i. Draw the spectrum of the baseband signal (multiplexer output) for the multiplexer. ii. Determine the bandwidth of the baseband signal (multiplexer output) for the multiplexer. iii. Determine the minimum transmission bandwidth of the multiplexer. Explain, briefly, the modification needed for the multiplexer in the figure to achieve this bandwidth. 3 kHz cos 10,000nt Bascband signal cos? 1000nt Σ cos 22,000rt 4 kHz cos 36,000nt Figure Q2
modulating signal amplitude wideband FM dependent %m carrier swing Prompts Submitted Answers It determines the rate of frequency shift Choose a match frequency deviation The peak to peak frequency deviation Choose a match narrowband FM FM with modulation index between 1 and 10 Choose a match modulation index The ratio of actual frequency deviation to the maximum Choose a match modulating frequency allowable frequency deviation expressed in percentage. midband FM Frequency deviation of the carrier is to the Choose a match amplitude of the modulating signal. proportional inverse proportional
The figure shows the AM modulated signal. What is modulation index?
ANSWER THE PROBLEM MAKE SURE THAT IT IS IN 4 DECIMAL PLACES: Solve for the side frequency volt, modulation depth is lessened by 25% of an AM transistor with 32V output voltage when modulated to a depth of 96%.